Allylic carbon reactions

In contrast to oxidation in water, it has been found that 1-alkenes are directly oxidized with molecular oxygen in anhydrous, aprotic solvents, when a catalyst system of PdCl2(MeCN)2 and CuCl is used together with HMPA. In the absence of HMPA, no reaction takes place(100]. In the oxidation of 1-decene, the Oj uptake correlates with the amount of 2-decanone formed, and up to 0.5 mol of O2 is consumed for the production of 1 mol of the ketone. This result shows that both O atoms of molecular oxygen are incorporated into the product, and a bimetallic Pd(II) hydroperoxide coupled with a Cu salt is involved in oxidation of this type, and that the well known redox catalysis of PdXi and CuX is not always operalive[10 ]. The oxidation under anhydrous conditions is unique in terms of the regioselective formation of aldehyde 59 from X-allyl-A -methylbenzamide (58), whereas the use of aqueous DME results in the predominant formation of the methyl ketone 60. Similar results are obtained with allylic acetates and allylic carbonates[102]. The complete reversal of the regioselectivity in PdCli-catalyzed oxidation of alkenes is remarkable. 

Allylic acetates are widely used. The oxidative addition of allylic acetates to Pd(0) is reversible, and their reaction must be carried out in the presence of bases. An important improvement in 7r-allylpalladium chemistry has been achieved by the introduction of allylic carbonates. Carbonates are highly reactive. More importantly, their reactions can be carried out under neutral con-ditions[13,14]. Also reactions of allylic carbamates[14], allyl aryl ethers[6,15], and vinyl epoxides[16,17] proceed under neutral conditions without addition of bases. 

Wylation under neutral conditions. Reactions which proceed under neutral conditions are highly desirable, Allylation with allylic acetates and phosphates is carried out under basic conditions. Almost no reaction of these allylic Compounds takes place in the absence of bases. The useful allylation under neutral conditions is possible with some allylic compounds. Among them, allylic carbonates 218 are the most reactive and their reactions proceed under neutral conditions[13,14,134], In the mechanism shown, the oxidative addition of the allyl carbonates 218 is followed by decarboxylation as an irreversible process to afford the 7r-allylpalladium alkoxide 219. and the generated alkoxide is sufficiently basic to pick up a proton from active methylene compounds, yielding 220. This in situ formation of the alkoxide. which is a... 

Since allylation with allylic carbonates proceeds under mild neutral conditions, neutral allylation has a wide application to alkylation of labile compounds which are sensitive to acids or bases. As a typical example, successful C-allylation of the rather sensitive molecule of ascorbic acid (225) to give 226 is possible only with allyl carbonate[l 37]. Similarly, Meldrum s acid is allylated smoothly[138]. Pd-catalyzed reaction of carbon nucleophiles with isopropyl 2-methylene-3,5-dioxahexylcarbomite (227)[I39] followed by hydrolysis is a good method for acetonylation of carbon nucleophiles. 

Allylalion of the alkoxymalonitrile 231 followed by hydrolysis affords acyl cyanide, which is converted into the amide 232. Hence the reagent 231 can be used as an acyl anion equivalent[144]. Methoxy(phenylthio)acetonitrile is allylated with allylic carbonates or vinyloxiranes. After allylation. they are converted into esters or lactones. The intramolecular version using 233 has been applied to the synthesis of the macrolide 234[37]. The /i,7-unsaturated nitrile 235 is prepared by the reaction of allylic carbonate with trimethylsilyl cyanide[145]. 

Diphenylketene (253) reacts with allyl carbonate or acetate to give the a-allylated ester 255 at 0 °C in DMF, The reaction proceeds via the intermediate 254 formed by the insertion of the C = C bond of the ketene into 7r-allylpalla-dium, followed by reductive elimination. Depending on the reaction conditions, the decarbonylation and elimination of h-hydrogen take place in benzene at 25 °C to afford the conjugated diene 256(155]. 

Various S-nucleophiles are allylated. Allylic acetates or carbonates react with thiols or trimethylsilyl sulfide (353) to give the allylic sulfide 354[222], Allyl sulfides are prepared by Pd-catalyzed allylic rearrangement of the dithio-carbonate 355 with elimination of COS under mild conditions. The benzyl alkyl sulfide 357 can be prepared from the dithiocarbonate 356 at 65 C[223,224], The allyl aryl sufide 359 is prepared by the reaction of an allylic carbonate with the aromatic thiol 358 by use of dppb under neutral condi-tions[225]. The O-allyl phosphoro- or phosphonothionate 360 undergoes the thiono thiolo allylic rearrangement (from 0-allyl to S -allyl rearrangement) to afford 361 and 362 at 130 C[226],... 

Some organosilicon compounds undergo transmetallation. The allylic cyanide 461 was prepared by the reaction of an allylic carbonate with trimethylsi-lyl cyanide[298]. The oriho esters and acetals of the o. d-unsaturated carbonyl compounds 462 undergo cyanation with trimefhylsilyl cyanide[95]. 

Silyl enol ethers are other ketone or aldehyde enolate equivalents and react with allyl carbonate to give allyl ketones or aldehydes 13,300. The transme-tallation of the 7r-allylpalladium methoxide, formed from allyl alkyl carbonate, with the silyl enol ether 464 forms the palladium enolate 465, which undergoes reductive elimination to afford the allyl ketone or aldehyde 466. For this reaction, neither fluoride anion nor a Lewis acid is necessary for the activation of silyl enol ethers. The reaction also proceed.s with metallic Pd supported on silica by a special method[301j. The ketene silyl acetal 467 derived from esters or lactones also reacts with allyl carbonates, affording allylated esters or lactones by using dppe as a ligand[302]... 

The reaction can be applied to the synthesis of q, /3-unsaturated esters and lactones by treatment of the ketene silyl acetal 551 with an allyl carbonate in boiling MeCN[356]. The preparation of the q,, 3-unsaturated lactone 552 by this method has been used in the total synthesis of lauthisan[357]. 

On the other hand, the expected alkene 598 was regioselectively formed from the allylic carbonate 597[388]. In these reactions, the hydride from formate preferentially attacks the tertiary carbon rather than the secondary carbon. 

Isopentenyl pyrophosphate and dimethylallyl pyrophosphate are structurally sim liar—both contain a double bond and a pyrophosphate ester unit—but the chemical reactivity expressed by each is different The principal site of reaction m dimethylallyl pyrophosphate is the carbon that bears the pyrophosphate group Pyrophosphate is a reasonably good leaving group m nucleophilic substitution reactions especially when as in dimethylallyl pyrophosphate it is located at an allylic carbon Isopentenyl pyrophosphate on the other hand does not have its leaving group attached to an allylic carbon and is far less reactive than dimethylallyl pyrophosphate toward nucleophilic reagents The principal site of reaction m isopentenyl pyrophosphate is the carbon-carbon double bond which like the double bonds of simple alkenes is reactive toward electrophiles... 

Diethylene glycol bis (chloroformate) [106-75-2] is the starting material for diethylene glycol bis(allyl carbonate) [142-22-3] CR-39, or Nouryset 200, monomer, used in the manufacture of break-resistant optical lenses, which is obtained by the reaction with aHyl alcohol [107-18-6] (59). Alternatively, it can be obtained from aHyl chloroformate [2937-50-0] and diethylene glycol (60) (see Allylmonomers and polymers). 

This reaction showed a remarkable selectivity with respect to the solvent and base used. In THF and EtOAc using TEA as the base, a 1 1 mixture of the allylic carbonate and bisacylated products is obtained, but when CH2CI2 is used as solvent, the reaction favors the allylic alcohol by a factor of 97 3 (mono/bis). In THF or MTBE, the use of TMEDA as the base also results in a 97 3 mono/bis ratio. ... 

Pd(OAc)2, TPPTS, CH3CN, H2O, Et2NH, 30 min, 89-99% yield. Deprotection can be achieved in the presence of a prenyl or cinnamyl ester, but as the reaction times increase, these esters are also cleaved.Prenyl carbamates and allyl carbonates are cleaved similarly. 

To explain tlie stereodieniistiy of tlie allylic substitution reaction, a simple stereoelectronic model based on frontier molecular orbital considerations bas been proposed fl55. Fig. G.2). Organocopper reagents, unlike C-nudeopbiles, possess filled d-orbitals fd - configuration), wbidi can interact botli witli tlie 7t -fC=C) orbital at tlie y-carbon and to a minor extent witli tlie cr -fC X) orbital, as depicted... 

Allylic carbonates are better electrophdes than allylic acetates for the pallathirm-catalyzed allylic alkylation. Reaction of Eq. 5.54 shows the selective allylic alkylation of ct-nitro ester v/ith allylic carbonates v/ithont affecting allylic acetates. ... 

Pd(0)-catalyzed hydrogenolysis of vinylepoxides offers an attractive regio- and dia-stereoselective route to homoallylic alcohols (Scheme 9.36) [104, 155, 156]. Thus, hydrogenolysis of ( ) olefin 88 affords syn isomer 89 with inversion of configuration at the allylic carbon, while subjection of (Z) isomer 90 to identical reaction conditions results in the anti isomer 91. The outcomes of these reactions are ex-... 

Allylsilanes are available by treatment of allyl acetates and allyl carbonates with silyl cuprates17-18, with antarafacial stereochemistry being observed for displacement of tertiary allyl acetates19. This reaction provides a useful asymmetric synthesis of allylsilanes using esters and carbamates derived from optically active secondary alcohols antarafacial stereochemistry is observed for the esters, and suprafacial stereochemistry for the carbamates20,21. 

ADMET reaction. The 13C NMR spectrum also allows the scientist to distinguish between cis and trans internal sp2 carbons as well as the allylic carbons, which are adjacent to the internal vinyl position. Using quantitative 13C NMR analysis, the integration of the peak intensities between die allylic carbon resonances and diose of the internal vinyl carbons gives die percentage of trans/cis stereochemistry diat is present for the polymer.22 Empirically, the ratio of trans to cis linkages in ADMET polymers has typically been found to be 80 20. Elemental analysis results of polymers produced via ADMET demonstrate excellent agreement between experimental and theoretical values. 

An efficient chemoenzymatic route for the synthesis of optically active substituted indolines has been recently developed (Scheme 7.27), and also the alkoxycarbonyla-tion process is more efficient than the acylation reaction. Different lipases have been tested in the alkoxycarbonylation of these secondary amines, GALA being found to be the best biocatalyst for 2-substituted-indolines, and CALB for 3-methylindoline. The combination of lipases with a variety of allyl carbonates and TBME as solvent has allowed the isolation of the carbamate and amine derivatives in a high level of enantiopurity [51]. 

The protocol of the allylic alkylation, which proceeds most likely via a c-allyl-Fe-intermediate, could be further improved by replacing the phosphine ligand with an M-heterocyclic carbene (NHC) (Scheme 21) [66]. The addition of a ferf-butyl-substituted NHC ligand 86 allowed for full conversion in the exact stoichiometric reaction between allyl carbonate and pronucleophile. Various C-nucleophiles were allylated in good to excellent regioselectivities conserving the 71 bond geometry of enantiomerically enriched ( )- and (Z)-carbonates 87. Even chirality and prochirality transfer was observed (Scheme 21) [67]. 

---