Allyl alcohols addition reactions

Wohf-Kishner reductions of a,jS-epoxy ketones give allylic alcohols, thus providing a means of reversing the arrangement in a,jS-unsaturated ketones or allylic alcohols. The reaction as first described by Wharton proceeds very readily (at room temperature in some instances) and the addition of strong base is unnecessary for example, the reduction of the epoxy ketone 143. 

Organozinc reagents have been used in conjunction with a-bromovinylboranes in a tandem route to Z-trisubstituted allylic alcohols. After preparation of the vinylborane, reaction with diethylzinc effects migration of a boron substituent with inversion of configuration and exchange of zinc for boron.176 Addition of an aldehyde then gives the allylic alcohol. The reaction is applicable to formaldehyde alkyl and aryl aldehydes and to methyl, primary, and secondary boranes. 

Polyether Polyols. Polyether polyols are addition products derived from cyclic ethers (Table 4). The alkylene oxide polymerization is usually initiated by alkali hydroxides, especially potassium hydroxide. In the base-catalyzed polymerization of propylene oxide, some rearrangement occurs to give allyl alcohol. Further reaction of allyl alcohol with propylene oxide produces a monofunctional alcohol. Therefore, polyether polyols derived from propylene oxide are not truly difunctional. By using zinc hexacyano cobaltate as catalyst, a more difunctional polyol is obtained (20). Olin has introduced the difunctional polyether polyols under the trade name POLY-L. Trichlorobutylene oxide-derived polyether polyols are useful as reactive fire retardants. Poly(tetramethylene glycol) (PTMG) is produced in the acid-catalyzed homopolymerization of tetrahydrofuran. Copolymers derived from tetrahydrofiiran and ethylene oxide are also produced. 

Besides oxidation reactions, MTO supported on AI2O3/ Si02, niobia, or zeolites also catalyzes the metathesis of functionalized alkenes, 1,2 transposition of allylic alcohols, addition of epoxides to ketones, alkoxylation of epoxides, dehydration and amination of alcohols, and... 

Derivation Addition of hypochlorite to allyl alcohol and reaction with soda lime. 

Allyl alcohol undergoes reactions typical of saturated, aliphatic alcohols. Allyl compounds derived from allyl alcohol and used industrially, are widely manufactured by these reactions. For example, reactions of aUji alcohol with acid anhydrides, esters, and acid chlorides yield aUyl esters, such as diaUji phthalates and allyl methacrylate reaction with chloroformate yields carbonates, such as diethylene glycol bis(allyl carbonate) addition of allyl alcohol to epoxy groups yields products used to produce allyl glycidyl ether (33,34). 

The vinylmagnesium derivatives (40), obtained by Cu -mediated anft-addition of Grignard reagents to primary a-acetylenic alcohols, can by hydrolysed to ( )-allylic alcohols (41) (Scheme 18) or, if = H, halogenated and then alkylated to yield (Z)-allylic alcohols (42)." Reaction of (40) with carbonyl compounds gives substituted but-2-ene-l,4-diols. ... 

Torgov introduced an important variation of the Michael addition allylic alcohols are used as vinylogous a -synthons and 1,3-dioxo compounds as d -reagents (S.N. Ananchenko, 1962, 1963 H. Smith, 1964 C. Rufer) 1967). Mild reaction conditions have been successful in the addition of ],3-dioxo compounds to vinyl ketones. Potassium fluoride can act as weakly basic, non-nudeophilic catalyst in such Michael additions under essentially non-acidic and non-basic conditions (Y. Kitabara, 1964). 

Organoboranes are reactive compounds for cross-coupling[277]. The synthesis of humulene (83) by the intramolecular cross-coupling of allylic bromide with alkenylborane is an example[278]. The reaction of vinyiborane with vinyl-oxirane (425) affords the homoallylic alcohol 426 by 1,2-addition as main products and the allylic alcohol 427 by 1,4-addition as a minor product[279]. Two phenyl groups in sodium tetraphenylborate (428) are used for the coupling with allylic acetate[280] or allyl chloride[33,28l]. 

Tlie addition reactions of allylic and acetylenic alcohols produce compounds resulting from rearrangements [16, 17] (equation 7). 

A number of reaction variables or parameters have been examined. Catalyst solutions should not be prepared and stored since the resting catalyst is not stable to long term storage. However, the catalyst solution must be aged prior to the addition of allylic alcohol or TBHP. Diethyl tartrate and diisopropyl tartrate are the ligands of choice for most allylic alcohols. TBHP and cumene hydroperoxide are the most commonly used terminal oxidant and are both extremely effective. Methylene chloride is the solvent of choice and Ti(i-OPr)4 is the titanium precatalyst of choice. Titanium (IV) t-butoxide is recommended for those reactions in which the product epoxide is particularly sensitive to ring opening from alkoxide nucleophiles. ... 

This class of substrate is the only real problematic substrate for the AE reaction. The enantioseleetivity of the AE reaction with this class of substrate is often variable. In addition, rates of the catalytic reactions are often sluggish, thus requiring stoichiometric loadings of Ti/tartrate. Some representative product epoxides from AE reaction of 3Z-substituted allyl alcohols are shown below. 

The first, and so far only, metal-catalyzed asymmetric 1,3-dipolar cycloaddition reaction of nitrile oxides with alkenes was reported by Ukaji et al. [76, 77]. Upon treatment of allyl alcohol 45 with diethylzinc and (l ,J )-diisopropyltartrate, followed by the addition of diethylzinc and substituted hydroximoyl chlorides 46, the isoxazolidines 47 are formed with impressive enantioselectivities of up to 96% ee (Scheme 6.33) [76]. 

The above described approach was extended to include the 1,3-dipolar cycloaddition reaction of nitrones with allyl alcohol (Scheme 6.35) [78]. The zinc catalyst which is used in a stoichiometric amount is generated from allyl alcohol 45, Et2Zn, (R,J )-diisopropyltartrate (DIPT) and EtZnCl. Addition of the nitrone 52a leads to primarily tmns-53a which is obtained in a moderate yield, however, with high ee of up to 95%. Application of 52b as the nitrone in the reaction leads to higher yields of 53b (47-68%), high trans selectivities and up to 93% ee. Compared to other metal-catalyzed asymmetric 1,3-dipolar cycloaddition reactions of... 

The acid-catalyzed addition of an aldehyde—often formaldehyde 1—to a carbon-carbon double bond can lead to formation of a variety of products. Depending on substrate structure and reaction conditions, a 1,3-diol 3, allylic alcohol 4 or a 1,3-dioxane 5 may be formed. This so-called Prins reaction often leads to a mixture of products. 

The excess of N-chlorosuccinimide is destroyed by the addition of about 15 drops of allyl alcohol and 180 ml of water is then added with stirring. This mixture is held at 0°C for about one hour. The precipitated 16/3-methyl-1,4-pregnadiene-9o-chloro-11/3,17o,21-triol-3,20-dione-21-acetate is recovered by filtration. A solution of 250 mg of the chlorohydrin in 5 ml of 0.25N perchloric acid in methanol is stirred for about 18 hours at room temperature to produce 16/3-methyl-9o-chloro-11/3,17o,21-trihydroxy-1,4-pregnadiene-3,20-dione which is recovered by adding water to the reaction mixture and allowing the product to crystallize. Propionic anhydride is then used to convert this material to the dipropionate. 

Johnson s classic synthesis of progesterone (1) commences with the reaction of 2-methacrolein (22) with the Grignard reagent derived from l-bromo-3-pentyne to give ally lie alcohol 20 (see Scheme 3a). It is inconsequential that 20 is produced in racemic form because treatment of 20 with triethyl orthoacetate and a catalytic amount of propionic acid at 138 °C furnishes 18 in an overall yield of 55 % through a process that sacrifices the stereogenic center created in the carbonyl addition reaction. In the presence of propionic acid, allylic alcohol 20 and triethyl orthoacetate combine to give... 

The reason for the efficient epoxidation of explicitly allylic alcohols with this system can be found in the strong associative interactions occurring between the substrate and the catalyst. The [Ti(tartrate)(OR)2]2 dimer 1, which is considered to be the active catalyst in the reaction, will generate structure 2 after the addition of... 

---