Alkanes, superacid

All lation with Alkanes. Superacids such as HF-SbF abstract hydride ion from alkanes to form carbocations at low temperatures. The... 

The key initiation step in cationic polymerization of alkenes is the formation of a carbocationic intermediate, which can then interact with excess monomer to start propagation. We studied in some detail the initiation of cationic polymerization under superacidic, stable ion conditions. Carbocations also play a key role, as I found not only in the acid-catalyzed polymerization of alkenes but also in the polycondensation of arenes as well as in the ring opening polymerization of cyclic ethers, sulfides, and nitrogen compounds. Superacidic oxidative condensation of alkanes can even be achieved, including that of methane, as can the co-condensation of alkanes and alkenes. 

Protoiiation (and protolysis) of alkanes is readily achieved with superacids. The protonation of methane itself to CH5, as discussed earlier, takes place readily. 

Not only protolytic reactions but also a whole range of varied elee-trophilic reactions can be carried out on alkanes under superacidic conditions. 

Carboxoninm ions, for example, do not react with alkanes. However, in superacid solution acetaldehyde (or acetone), for example, readily reacts with isobutane involving diprotonated, highly reactive carbocationic species. 

On the other hand, under superacidic conditions, alkanes are readily alkylated via front-side CJ-iasertion by carbocationic alkylating agents. The direct alkylation of the tertiary C—H CJ-bond of isobutylene with isobutane has been demonstrated (71). The stericaHy unfavorable reaction of tert-huty fluoroantimonate with isobutane gave a Cg fraction, 2% of which was 2,2,3,3-tetramethylbutane ... 

Lower alkanes such as methane and ethane have been polycondensed ia superacid solutions at 50°C, yielding higher Hquid alkanes (73). The proposed mechanism for the oligocondensation of methane requires the involvement of protonated alkanes (pentacoordinated carbonium ions) and oxidative removal of hydrogen by the superacid system. 

Elemental sulfur reacts with alkanes such as cyclopentane in the presence of superacidic trifluoromethanesulfonic acid to give symmetrical dialkyl sulfides in moderate yields. 

These reactions involve the intermediate formation of thiols, followed by condensation to the sulfides. The observation of isomerized products in suitable cases indicates the intermediate formation of carbocations, either by protolysis of alkanes by the superacid or reversible ionisation of the thiol products (149). 

Carbocations generated from alkanes using superacids react with carbon monoxide under mild conditions to form carboxyUc acid (188). In this process isomeric carboxyUc acids are produced as a mixture. However, when the reaction is mn with catalytic amounts of bromine (0.3 mmol eq) in HF-SbF solution, regio-selective carboxylation is obtained. / -Propane was converted almost exclusively to isobutyric acid under these conditions. 

Even alkanes, when treated with superacids, can undergo oligocondensation. Eor example, highly branched polyalkanes, of molecular weight up to 700, were obtained by treating gaseous alkanes (C —with Hquid superacids at room temperature (81). 

It has been shown, however, that such catalysts may contain protons, either by design or because of the difficulty in removing all traces of moisture, and these protons have been shown to be superacidic with Hammett acidities up to —18. These protons will also play some role in the catalytic activity of these ionic liquids in practical situations. Ionic liquids in which superacidic protons have deliberately been generated by addition of small amounts of water, HCl or H2SO4 have been used to catalytically crack polyethene under relatively mild conditions. The main products are mixed C3-C5 alkanes, which would be a useful feedstock from waste polyethene recycling. In contrast to other cracking procedures no aromatics or alkenes are produced, although small amounts of polycyclic compounds are obtained. 

Theoretically, even the direct alkylation of carbenium ions with isobutane is feasible. The reaction of isobutane with a r-butyl cation would lead to 2,2,3,3-tetramethylbutane as the primary product. With liquid superacids under controlled conditions, this has been observed (52), but under typical alkylation conditions 2,2,3,3-TMB is not produced. Kazansky et al. (26,27) proposed the direct alkylation of isopentane with propene in a two-step alkylation process. In this process, the alkene first forms the ester, which in the second step reacts with the isoalkane. Isopentane was found to add directly to the isopropyl ester via intermediate formation of (non-classical) carbonium ions. In this way, the carbenium ions are freed as the corresponding alkanes without hydride transfer (see Section II.D). This conclusion was inferred from the virtual absence of propane in the product mixture. Whether this reaction path is of significance in conventional alkylation processes is unclear at present. HF produces substantial amounts of propane in isobutane/propene alkylation. The lack of 2,2,4-TMP in the product, which is formed in almost all alkylates regardless of the feed (55), implies that the mechanism in the two-step alkylation process is different from that of conventional alkylation. 

A variety of solid acids besides zeolites have been tested as alkylation catalysts. Sulfated zirconia and related materials have drawn considerable attention because of what was initially thought to be their superacidic nature and their well-demonstrated ability to isomerize short linear alkanes at temperatures below 423 K. Corma et al. (188) compared sulfated zirconia and zeolite BEA at reaction temperatures of 273 and 323 K in isobutane/2-butene alkylation. While BEA catalyzed mainly dimerization at 273 K, the sulfated zirconia exhibited a high selectivity to TMPs. At 323 K, on the other hand, zeolite BEA produced more TMPs than sulfated zirconia, which under these conditions produced mainly cracked products with 65 wt% selectivity. The TMP/DMH ratio was always higher for the sulfated zirconia sample. These distinctive differences in the product distribution were attributed to the much stronger acid sites in sulfated zirconia than in zeolite BEA, but today one would question this suggestion because of evidence that the sulfated zirconia catalyst is not strongly acidic, being active for alkane isomerization because of a combination of acidic character and redox properties that help initiate hydrocarbon conversions (189). The time-on-stream behavior was more favorable for BEA, which deactivated at a lower rate than sulfated zirconia. Whether differences in the adsorption of the feed and product molecules influenced the performance was not discussed. 

In the 1970s, Brouwer and Kifflin reported the reactions of saturated hydrocarbons with aliphatic aldehydes and ketones in superacidic media. Analysis of the products from these reactions suggested that the protonated aldehydes and ketones (carboxonium ions) were reacting at the carbon-hydrogen o-bonds of the alkanes. This was a surprising observation because carboxonium... 

Much of our research has involved the use of dicationic electrophiles in reactions with very weak nucleophiles, such as non-activated arenes and alkanes. By comparison to similar monocationic electrophiles, we have been able to show the extent of electrophilic activation by adjacent cationic centers. For example, carbocations show an increased reactivity with a nearby cationic charge (eqs 3-4).9 When 1,1-diphenyletheneis reacted with superacidic CF3SO3H... 

Olah, G. A. Germain, A. Lin, H. C. Forsyth, D. Electrophilic reactions at Single Bonds. XVIII.1 Indication of Protosolvated de facto Substituting Agents in the Reactions of Alkanes with Acetylium and Nitronium Ions in Superacidic Media. J. Am. Chem. Soc. 1975, 97, 2928-2929. 

Oxidation of unfunctionalized alkanes is notoriously difficult to perform selectively, because breaking of a C-H bond is required. Although oxidation is thermodynamically favourable, there are limited kinetic pathways for reaction to occur. For most alkanes, the hydrogens are not labile, and, as the carbon atom cannot expand its valence electron shell beyond eight electrons, there is no mechanism for electrophilic or nucleophilic substitution short of using extreme (superacid or superbase) conditions. Alkane oxidations are therefore normally radical processes, and thus difficult to control in terms of selectivity. Nonetheless, some oxidations of alkanes have been performed under supercritical conditions, although it is probable that these actually proceed via radical mechanisms. 

Several metal oxides could be used as acid catalysts, although zeolites and zeo-types are mainly preferred as an alternative to liquid acids (Figure 13.1). This is a consequence of the possibility of tuning the acidity of microporous materials as well as the shape selectivity observed with zeolites that have favored their use in new catalytic processes. However, a solid with similar or higher acid strength than 100% sulfuric acid (the so-called superacid materials) could be preferred in some processes. From these solid catalysts, nation, heteropolyoxometalates, or sulfated metal oxides have been extensively studied in the last ten years (Figure 13.2). Their so-called superacid character has favored their use in a large number of acid reactions alkane isomerization, alkylation of isobutene, or aromatic hydrocarbons with olefins, acylation, nitrations, and so forth. 

In the case of C4-hydrocarbons, the use of acid or superacid solids will depend on both the acid strength required in each reaction and the reaction conditions required to optimize the thermodynamic equilibrium (Figure 13.3). For example, catalysts with very high acid strength could be substituted for a solid with a lower acidity by increasing reaction temperature. This has been proposed in both the isomerization of lineal alkanes and in the alkylation of isobutene with olefins, although the thermodynamic equilibrium should also be considered. 

Berkessel, A. and Thauer, R. K. (1995) On the mechanism of catalysis by a metal-free hydro-genase from methanogenic archaea Enzymic transformation of H2 without a metal and its analogy to the chemistry of alkanes in superacidic solution. Angew. Cbem., Int. Ed. Engl., 34, 2247-50. 

In alkane condensations in superacid media it is assumed, albeit never observed in solution, that reversible methane or ethane protonation is the first step." Subsequent loss of dihydrogen, yielding the highly unstable methyl and ethyl cations, and reaction with excess alkane builds up higher hydrocarbons [Equation (6)]. 

General considerations on the mechanism of C3Hg reaction over HZSM-5 and Ga- HZSH-5. The products obtained from the reaction of C2 C5 alkanes over H-ZSM-5 zeolites were nicely interpreted (3-6) according to the classical carbenlum ion theory and the non-classical theory developed for reactions occurring in superacid media where an alkane is protonated to form the carbocation species. The general scheme proposed for propane reaction over H-ZSM-5 is ... 

Significant practical problems, however, remain to carry out the condensation effectively. Conversion was so far achieved only in low yields. Because of the easy cleavage of longer chain alkanes by the same superacids, C -C products predominate. 

---