Adsorption ellipsometry

Ellipsometry is one of widely spread method for direct measurements of protein adsorption. Prior to adsorption ellipsometry measurements require determination of the optical properties of the solid surface [68-69]. For obtaining the amount of adsorbed protein the method described in [70] is applied using the values of the refractive index increments of the protein. The optical technique reflectometry is a simplified version of ellipsometry [71]. Reflectometry is especially suited to study adsorption kinetics because it can rapidly monitor the rates of adsorption using relatively simple and cheap instruments. During the experiment the protein layer is adsorbed on top of the sorbent surface and the... 

Smith [113] studied the adsorption of n-pentane on mercury, determining both the surface tension change and the ellipsometric film thickness as a function of the equilibrium pentane pressure. F could then be calculated from the Gibbs equation in the form of Eq. ni-106, and from t. The agreement was excellent. Ellipsometry has also been used to determine the surface compositions of solutions [114,115], as well polymer adsorption at the solution-air interface [116]. 

Electrolyte adsorption on metals is important in electrochemistry [167,168]. One study reports the adsorption of various anions an Ag, Au, Rh, and Ni electrodes using ellipsometry. Adsorbed film thicknesses now also depend on applied potential. 

RAIRS spectra contain absorption band structures related to electronic transitions and vibrations of the bulk, the surface, or adsorbed molecules. In reflectance spectroscopy the ahsorhance is usually determined hy calculating -log(Rs/Ro), where Rs represents the reflectance from the adsorhate-covered substrate and Rq is the reflectance from the bare substrate. For thin films with strong dipole oscillators, the Berre-man effect, which can lead to an additional feature in the reflectance spectrum, must also be considered (Sect. 4.9 Ellipsometry). The frequencies, intensities, full widths at half maximum, and band line-shapes in the absorption spectrum yield information about adsorption states, chemical environment, ordering effects, and vibrational coupling. 

Measurements of the adsorption of inhibitors on corroding metals are best carried out using the direct methods of radio-tracer detection and solution depletion measurements . These methods provide unambiguous information on uptake, whereas the corrosion reactions may interfere with the indirect methods of adsorption determination, such as double layer capacity measurements", coulometry", ellipsometry and reflectivity Nevertheless, double layer capacity measurements have been widely used for the determination of inhibitor adsorption on corroding metals, with apparently consistent results, though the interpretation may not be straightforward in some cases. 

Pleith, W., W. Kozlowski, and T. Twomey, Reflectance spectroscopy and ellipsometry of organic monolayers, in Adsorption of Molecules at Metal Electrodes, 3. Lipkowski and P. N. Ross, Eds., VCH, New York, 1992, p. 285. 

When cells are suspended in a biological fluid or culture medium, both serum proteins and cells interact with the surface substrate. Serum protein adsorption behavior on SAMs has been examined with various analytical methods, including SPR [58-61], ellipsometry [13, 62, 63], and quartz QCM [64—66]. These methods allow in situ, highly sensitive detection of protein adsorption without any fluorescence or radioisotope labeling. SPR and QCM are compatible with SAMs that comprise alkanethiols. In our laboratory, we employed SPR to monitor protein adsorption on SAMs. 

Adsorption of sodium poly(styrenesulfonate) from aqueous NaCl solutions onto a platinum plate at 25 °C was studied by ellipsometry as functions of molecular weight and concentration of NaCl. 

The aim of this paper is to offer experimental results for the molecular weight dependence of adsorption of polystyrene-sulfonate) onto a platinum plate from aqueous NaCl solution at 25 °C. Measurements of poly(styrenesulfonate) adsorption were carried out by ellipsometry. The dependences of molecular weight and added salt concentration on the thickness of the adsorbed layer and also the adsorbances of polymer and salt are examined. 

Ellipsometry. Adsorption measurements were performed with a Shimadzu P-10 Type ellipsometer at 25 °C. The light source was a Nihon Denchi SH-85 Type high pressure mercury lamp. The wavelength of the incident light was 546 nm and incident angle was 70 0. ... 

El wing, H., Protein adsorption and ellipsometry in biomaterial research, Biomaterials 1998, 19,397 406... 

Defeijter, J. A. Benjamins, J. Veer, F. A., Ellipsometry as a tool to study adsorption behavior of synthetic and biopolymers at air water interface, Biopolymers 1978, 17, 1759 1772... 

The influence of the metal on electrosorption was also considered in the adsorption of aromatic compounds. Extensive studies of adsorption of different aliphatic and aromatic compounds on a polycrystalline Pt electrode in O.OIMHCI solution were done by Bockris etal. Using different techniques (radiotracer, FTIR, and ellipsometry), they were found that aromatic molecules are adsorbed parallely to the electrode surface and that the potential dependence of adsorption is symmetrical around the pzc. It was concluded that the dependence of adsorption on the potential is mostly determined by the interaction of water with the Pt surface. 

The adsorption of alkyl and aryl isocyanides on Au film [26, 32, 33], powder [36, 37] and nanoparticles [39, 41, 42] has been studied using several different techniques IR methods (RAIR, ATR-IR, DRIFT), Raman methods (SERS), X-ray methods (NEXAFS), ellipsometry (OE, SWE) and contact angle measurements (ACA). The gold surface is not oxidized under normal conditions consequently, the experiments were performed in air at room temperature. The gold film was obtained by physical vapor deposition of 100-200 nm of gold on different substrates glass [28, 33], mica [33], silicon [25, 27, 31, 32], ZnSe crystal [26]. A... 

Adsorption of putidaredoxin on gold electrodes has been studied using dynamic spectroscopic ellipsometry and differential capacitance measurements [307]. In Ref. 307, a method for the measurement of metal surface optical perturbation during protein adsorption at a constant potential has been described. The method is based on the concept that the charged transition layer develops between the electrode substrate and the adsorbate. 

Reference electrode, 1104, 1108, 1113 potential, 819, 874 Refractive index, determination with ellipsometry, 1148. 1151 Reflection coefficient, 1151 Residence time, definition, 1310 Reversal techniques, determination of intermediate radicals, 1416 Reversible adsorption of organic molecules, 969, 970... 

Morrissey 53) used transmission infrared spectroscopy to study protein adsorption onto silica particles in a heavy water (DzO) buffer. By observing the shift in the amide I absorption band, he could deduce the fraction of protein carbonyl groups involved in bonding to the silica surface. He found that bovine IgG had a bound fraction of 0.20 at low bulk solution concentrations, but only about 0.02 at high solution concentrations. However, neither prothrombin nor bovine serum albumin exhibited a change in bound fraction with concentration. Parallel experiments with flat silica plates using ellipsometry showed that the IgG-adsorbed layers had an optical thickness of 140 A and a surface concentration of 1.7 mg/m2 at low bulk solution concentration — in concentrated solutions the surface amount was 3.4 mg/m2 with a thickness of 320 A (Fig. 17). 

Ellipsometry can follow the interactions between two types of biological macromolecules, the first of those two bound physically to the surface, the other acting from the solution. The binding of conconavalin A to adsorbed mannan 180) and of cholera toxin to adsorbed ganglioside t83) are examples. The adsorption of complement factors to an antibody-coated surface was monitored by ellipsometry and a modification of the same method was used for quantification of migration inhibition of human polymorphonuclear leucocytes 182). Interaction of proteins and cells with affinity ligands covalently coupled to silicon surfaces has been also studied 183). 

In 1985 Allara and Nuzzo [354, 355] published the results of an extensive investigation in which adsorption took place on to an aluminium oxide layer formed on a film of aluminium deposited in vacuo on to a silicon wafer. Various carboxylic acids were dissolved in high purity hexadecane and allowed to adsorb from this solution on to the prepared aluminium oxide surface. The monolayers so formed were examined by ellipsometry and infrared spectroscopy. Contact angle measurements were made on the monolayer surfaces and radioactive labelled (tritiated) compounds were employed to study the interchange of adsorbed molecules with those in solution. Various other techniques of less immediate relevance to our present interests were also employed and reference to these two papers should be made for further particulars. Aluminium... 

Concerning the experimental side of polymer adsorption studies the quantity A was only measurable at the early stage of the study, but in 19SS the thickness of the adsorbed layer became accessible to measurement by a hydrodynamic method and in 1961 the quantity p was first determined by infrared spectroscopy. Ellipsometry came up in 1963, which enabled both the adsorbance and the thickness of the adsorbed layer to be measured simultaneously. 

---