Addition of Hydrogen Chloride

It has been reported that a diene iron carbonyl complex does not maintain its configuration upon the addition of hydrogen chloride, as evidenced by the different salts obtained from the reaction of butadieneiron tricarbonyl with HBF4 or HCl followed by AgBp4. Thus piperylene Fe(CO)3 reacts with HCl to give the syn-syn dimethyl allyl derivative [6-16]. 

The NMR spectrum of the salt obtained from [6-16] upon reaction with silver perchlorate shows only one type of methyl group. This is not noted in the spectrum of the analogous salt protonated with HBF4. Since inversion does not occur, the NMR spectrum reveals two types of methyl groups derived from this syn-anti derivative, equation (6-29). 

A mechanism involving cis addition of HCl and rotation to permit the halogen attack on the metal is probably involved, equation (6-30). 

---

Cinnamic acid can be readily esterified by the Fischer-Speier method without any risk of the addition of hydrogen chloride at the double bond. Proceed precisely as for the preparation of ethyl benzoate (p. 104), using 20 g. of cinnamic acid and 20 ml. of rectified spirit. When the crude product is poured into water, a sharp separation of the ester is not readily obtained, and hence the addition of about 10 ml. of carbon tetrachloride is particularly desirable. Finally distil off the carbon... 

Addition of hydrogen chloride to 2 methyl 1 3 butadiene is a kmetically controlled reaction and gives one product in much greater amounts than any isomers What is this product ... 

The regioselectivity of electrophilic addition is governed by the ability of an aro matic ring to stabilize an adjacent carbocation This is clearly seen m the addition of hydrogen chloride to mdene Only a single chloride is formed... 

Sa.lts Salting out metal chlorides from aqueous solutions by the common ion effect upon addition of HCl is utilized in many practical apphcations. Typical data for ferrous chloride [13478-10-9] FeCl2, potassium chloride [7447-40-7] KCl, and NaCl are shown in Table 9. The properties of the FeCl2-HCL-H2 0 system are important to the steel-pickling industry (see Metal SURFACE TREATMENTS Steel). Other metal chlorides that are salted out by the addition of hydrogen chloride to aqueous solutions include those of magnesium, strontium, and barium. 

Dehydrochlorination of 1,1,2-trichloroethane [25323-89-1] produces vinyHdene chloride (1,1-dichloroethylene). Addition of hydrogen chloride to vinyHdene chloride in the presence of a Lewis acid, such as ferric chloride, generates 1,1,1-trichloroethane. Thermal chlorination of 1,2-dichloroethane is one route to commercial production of trichloroethylene and tetrachloroethylene. 

Hydrochlorination. The addition of hydrogen chloride to alkenes in the absence of peroxides takes place by an electrophilic substitution mechanism. The orientation is in accord -with Markovnikov s mle in -which the hydrogen atom adds to the side of the double bond that -will result in the... 

A reflux condenser is not necessary if the mixture is kept ice-cold during the addition of hydrogen chloride. 

Among the cases in which this type of kinetics have been observed are the addition of hydrogen chloride to 2-methyl-1-butene, 2-methyl-2-butene, 1-mefliylcyclopentene, and cyclohexene. The addition of hydrogen bromide to cyclopentene also follows a third-order rate expression. The transition state associated with the third-order rate expression involves proton transfer to the alkene from one hydrogen halide molecule and capture of the halide ion from the second ... 

Kinetic studies of the addition of hydrogen chloride to styrene support the conclusion that an ion-pair mechanism operates because aromatic conjugation is involved. The reaction is first-order in hydrogen chloride, indicating that only one molecule of hydrogen chloride participates in the rate-determining step. ... 

Similar studies have been carried out on the addition of hydrogen chloride to norbor-nene. 

The addition of hydrogen chloride to olefins in nitromethane follows the rate expression... 

Product mixtures from radical-chain addition of hydrogen chloride to alkenes are much more complicated than is the case for addition of hydrogen bromide. The problem is that the rate of abstraction of hydrogen from hydrogen chloride is not fast relative to the rate of addition of the alkyl radical to the alkene. This results in the formation of low-... 

Chemistry of polychloroprene rubber. Polychloroprene elastomers are produced by free-radical emulsion polymerization of the 2-chloro-1,3-butadiene monomer. The monomer is prepared by either addition of hydrogen chloride to monovinyl acetylene or by the vapour phase chlorination of butadiene at 290-300°C. This latter process was developed in 1960 and produces a mixture of 3,4-dichlorobut-l-ene and 1,4-dichlorobut-2-ene, which has to be dehydrochlorinated with alkali to produce chloroprene. 

Addition of hydrogen chloride to 3,3-dimethyl-1-butene gives a... 

Is the electrophilic addition of hydrogen chloride to 2-methyl-propene the reverse of the El or the E2 elimination reaction of fe/t-butyl chloride ... 

Chloro-1,3-butadiene (chloroprene) is the monomer from which the elastomer neoprene is prepared. 2-Chloro-1,3-butadiene is the thermodynamically controlled product formed by addition of hydrogen chloride to vinylacetylene (H2C=CHC=CH). The principal product under conditions of kinetic control is the allenic chloride 4-chloro-1,2-butadiene. Suggest a mechanism to account for the formation of each product. 

Ingham proposed the following sequence to explain the formation of oxazole products following his study of the reaction of benzaldehyde with mandelonitrile and hydrogen chloride. In the event, addition of hydrogen chloride to the cyanide is the first step providing the intermediate iminochloride 5 (Ari = Ph), which upon reaction with benzaldehyde affords oxazole 2 (Ari, Ar2 = Ph) via intermediate 6 (Ari, Ar2 = Ph). 

The addition of hydrogen chloride to the triple bond of alk-l-ynylphos-phines in aqueous solutions is a rra/ii-addition. The rate-determining step involves attack of chloride ion on the jS-carbon atom of the protonated alk-l-ynylphosphine ... 

Arenesulfinate esters are usually prepared from an arenesulfinyl chloride and an alcohol in ether and pyridine. The arenesulfinyl chloride is usually prepared from the sodium arenesulfinate which is made by reduction of the arenesulfonyl chloride, preferably by aqueous sodium sulfite. After the crystalline sulfinate epimer has been removed by filtration, the equilibrium between the epimers remaining in the mother liquor may be reestablished by the addition of hydrogen chloride as shown by Herbrandson and Cusano . In this way the yield of the least soluble diastereomer may be increased beyond that which exists in the original reaction mixture (Scheme 1). Solladie prepared sulfinate ester 19 in 90% yield using this technique and published the details of his procedure. Estep and Tavares also published a convenient recipe for this method, although their yields were somewhat lower than Solladie s. 

The stereochemistry of addition of hydrogen halides to alkenes depends on the structure of the alkene and also on the reaction conditions. Addition of hydrogen bromide to cyclohexene and to E- and Z-2-butene is anti.6 The addition of hydrogen chloride to 1 -methylcyclopentene is entirely anti when carried out at 25° C in nitromethane.7... 

Dimethylcyclohexene is an example of an alkene for which the stereochemistry of hydrogen chloride addition is dependent on the solvent and temperature. At —78° C in dichloromethane, 88% of the product is the result of syn addition, whereas at 0° C in ether, 95% of the product results from anti addition.8 Syn addition is particularly common with alkenes having an aryl substituent. Table 4.1 lists several alkenes for which the stereochemistry of addition of hydrogen chloride or hydrogen bromide has been studied. 

See also Acetoacetyl-CoA in citric acid cycle, 6 633 Acetyl cyclohexanesulfonyl peroxide (ACSP), 74 282 78 478 Acetylene(s), 7 177-227, 227-228 25 633 addition of hydrogen chloride to, 73 821 from calcium carbide, 4 532, 548 carbometalation of, 25 117 as catalyst poison, 5 257t chemicals derived from, 7 227-265 decomposition of, 70 614 Diels-Alder adduct from cyclopentadiene, 8 222t direct polymerization, 7 514 economic aspects of, 7 216-217 explosive behavior of, 7 181-187 as fuel, 7 221-222 health and safety factors related to, 7 219... 

This enhanced reactivity of fluoromethyl cyanide is undoubtedly due to the inductive effect of the fluorine atom which produces an electron deficit on the carbon atom linked to the nitrogen, and presumably increases still further the polarity of the carbon-nitrogen bond, so that the electron displacements can be pictured as (IX). The increased polarity of the carbon-nitrogen bond will obviously facilitate polar addition of hydrogen chloride and alcohols (or phenols). 

---