Acetic chlorination

Processability Styrene-acrylonitrile, methacrylate-butadiene-styrene, chlorinated polyethylene, PVC-ethyl acrylate, ethylene-vinyl acetate, chlorinated polyoxymethylenes (acetals)... [Pg.347]

Bromine (dry gas) Bromine (liquid) Bromobenzene Butanol Butyl acetate Butylamine Butylchloride Butyric acid Calcium chloride Carbon tetrachloride Castor oil Cellosolve Cellosolve acetate Chlorine (dry gas) Chlorine water Chloroacetic acid Chlorobenzene Chloroform Chlorosulfonic acid Chromic acid Citric acid Colza oil Copper sulfate Cyclohexane Cyclohexanol Cyclohexanone... [Pg.511]

Oil Crude Copper Acetate Chlorine Trifluoride Calcium Arsenate Cumene... [Pg.37]

The oxidation of oximes by lead(IV) acetate, chlorine and other oxidants results in the formation of a-substituted nitroso compounds R R C(X)NO by attack of the oxidant at carbon. This is also the reaction commonly observ with dinitrogen tetroxide (the Ponzio reaction), the products being gem-... [Pg.751]

It is important to use sulfuric acid at this point to ensure efficient extraction. The sulfate salt of the alkaloid is more soluble in water and less soluble in organic solvents than the hydrochloride salt. In the ADH of other alkenes the preferred system is sulfuric acid/diethyl ether. However stilbene diol Is only sparingly soluble in diethyl ether, which necessitates the use of ethyl acetate. Chlorinated hydrocarbon solvents should be avoided since both alkaloid salts have appreciable solubility in them. When diethyl ether is used as the organic phase, not all of the reaction mixture dissolves in it, but the material that remains undissolved is derived solely from 4-methylmorpholine. [Pg.26]

Tetrahydrofurfuryl alcohol [97-99-4] is a colorless liquid with a weak odor that is miscible with water and organic solvents except aliphatic hydrocarbons. It dissolves cellulose nitrate and acetate, chlorinated rubber, shellac, resin esters, and many other binders. [Pg.358]

Hydrocarbons (benzene, hexane, pentane, cyclohexane, toluene, xylene, mineral oil) ethers (dioxane, diethyl ether, ethyl vinylether) ketones (acetone, cyclohexanone) esters (ethyl acetate, methyl acetate) chlorinated hydrocarbons (carbon tetrachloride, chlorobenzene)... [Pg.962]

FluorosiUcones Ethylene acrylate Ethylene vinyl acetate Chlorinated polyethylene Good Resistance Polychloroprene Fair Resistance Nitrile... [Pg.449]

The compositional variability of environments is so vast that only very few attempts have been made to classify corrosion behavior from the point-of-view of the discrete environment at hand. A noteworthy exeeption is the Dechema handbook [6], in which valuable information may be found if the corrosive agent is simple and known (e.g. acetates, chlorine, steam). However, its main thrust is on the corrosion of metals. [Pg.142]

Properties Ground sol. In esters, ketones, aromatics, glycol ether acetates, chlorinated hydrocarbons Insol. In alcohols, petrol, hydrocarbons dens. 1.17 g/cm vise. 40-50 cmVg Storage 5 yr shelf life If stored cool and dry Degalan M 914 [Rohm GmbH RohmAm,]... [Pg.237]

Properties Liq. dilutable with esters, ketones, aromatic hydrocarbons, glycol ethers, glycol ether acetates, chlorinated hydrocarbons misc. with aliphatic hydrocarbons, alcohols dens. 0.95 g/cm dynamic vise. 250-450 cps (20 C) acid no. 2-3 flash pt. 23 C 40 01% solids Toxicology TSCA listed Storage Store tightly closed in cool place Degamin IPDA [DegussaAG/Marl]... [Pg.237]

Chem. Descrip. Tribulyl phosphate CAS 126-73-8 EINECS/ELINCS 204-800-2 Uses Flame retardant, plasticizer for nitrocellulose, cellulose acetate, chlorinated mbber. and vinyls antifoam for paper coalings, water-based adhesives, inks, textile sizes, detergent sol ns. high boiling solv. for lithographic inks latex paints also suitable for epoxy, PS, PVAc Prqietties Colorless liq. sp.gr. 0.980 (20/20 C) vise. 6 mPa s 11.7% P Phosflex 61B [AkzoNobeQ... [Pg.622]

Properties Bead polymer sol. in esters, ketones, aromatics, glycol ether acetates, chlorinated hydrocarbons insol. in alcohols, aliphatic hydrocarbons m.w. 70,000-80,000 dens. 1.15 g/cm reduced vise. 35-404 cm /g acid no. < 1 Toxicology TSCA listed Storage Store cool and dry... [Pg.701]

Properties Powd., gran., cast sheet and block sol. in ethyl acetate, chlorinated soivs. m.w. 60,000 (molding grades), 1,000,000 (cast sheet) dens. 1.188 ref. index 1.4100 tens. str. 72 MPa tens. mod. 2400 MPa... [Pg.1300]

Tributyl phosphate (TBP) n. (C4H90)3P0. A colorless liquid used as a primary plasticizer and solvent for cellulose acetate, chlorinated rubber and, in special applications, for vinyl resins. Its relatively high volatility limits its use as a plasticizer for vinyls. [Pg.998]

Additional examples of the application of the Flory EOS to polymer blends include polystyrene/poly(vinyl methyl ether) [15,20,21], oligomeric polystyrene/polybutadiene [22], ethylene-vinyl acetate/chlorinated polyethylene [23], poly(e-caprolactone)/PVC [24], poly-(ether sulfone)/poly(ethylene oxide) [25]. [Pg.22]

Poly(ethylene-co-vinyl acetate)-chlorinated polyethylene... [Pg.164]

Systems with UCST include polystyrene-poly(methyl methacrylate), and polystyrene-polyisoprene and LCST is found with poly(a-methyl styrene)-poly(methyl methacrylate), poly(styrene-co-acrylonitrile) (SAN)-polycaprolactone and poly(ethylene-co-vinyl acetate)-chlorinated polyethylene [ 5 ] as well as various polyvinylidene fluoride-polyacrylate copolymer blends [35]. [Pg.166]

Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...