Isomerization acetal

The p-methoxybenzylidene ketal can be prepared by DDQ oxidation of a p-methoxybenzyl group that has a neighboring hydroxyl. This methodology has been used to advantage in a number of syntheses. " In one case, to prevent an unwanted acid-catalyzed acetal isomerization, it was necessary to recrystallize the DDQ and use molecular sieves. The following examples serve to illustrate the reaction " ... 

Unfortunately, research work on taxines was hampered by their instability and the loss of activity upon storage because of the loss of dimethylamino moiety from the C-3 atom (Fig. 1) and the formation of corresponding cinnamates. Isolation of taxines is accomplished by alka-line/base extraction but it is difficult to obtain them in a purified form because of rapid acetate isomerization and/ or decomposition to taxinines. To the author s knowledge, there are no taxine/taxinine reference compounds commercially available. It is no surprise therefore that there are limited works that report on the high-performance liquid chromatography (HPLC) of taxines. Taxines were found in plant extracts interfering in extraction, isolation, and analysis of paclitaxel from plant material. ... 

Acetals. Isomerization of allyUc ethers to enol ethers by the Ru complex enables addition of alcohols to form acetals. ... 

Although the authors did not specifically address the issue of silyl ketene acetal geometry, the stereoselectivity of the silyl ketene acetal in these cases is noteworthy. Ireland had previously shown that phenyl acetic esters gave low E-stereoselec-tivity upon treatment with LDA and TBSCl (vide infra, Section 4.6.1.1). Either LHMDS/TMSCl gives higher f-selectivity in the case of phenyl acetic esters or the Lewis acid may be playing a role in both ketene acetal isomerization as well as rearrangement... 

Pyrrolidinium acetate Isomeric 2-cyclohexenones from 1,5-dioxo compds. Regiospecific ring closure... 

Propargylic acetates isomerize regiospecifically to allenic acetates in quantitative yield when treated with copper(i) chloride in boiling benzene. ... 

Allyl halides and acetates isomerize easily with acid catalysts via cationic allylic spe-cies. Alkyl substitution at allylic position increases the rate to an intermediate extent between alkyl cation (solid acid) and allylic anion (solid base). ... 

Locked Anomeric Configuration Method for Mannosyl Stannylene Acetal Isomerization of Acetal [25, 26]... 

A simple application of the reaction may bo mentioned. Refluxing of (I) with 48 per cent, hydrobromic aeid and glacial acetic acid leads to hydrolysis and decarboxylation and the production of a mixture of the yl tctone yr-di-phonylbutyrolaotone (II) and the isomeric unsaturated acid yY-dlphenyl-vinylacotic acid (III) reduction by the Clemmonsen method or catalytically... 

Nitration in acetic acid, in sulpholan and in carbon tetrachloride showed kinetic phenomena similar to those shown in nitromethane this is significant for it denies nitromethane a chemical involvement in the slow step. (Originally the rate of isomerization of nitromethane to its aci-form was believed to be a factor in the reaction. )... 

A mild procedure which does not involve strong adds, has to be used in the synthesis of pure isomers of unsymmetrically substituted porphyrins from dipyrromethanes. The best procedure having been applied, e.g. in unequivocal syntheses of uroporphyrins II, III, and IV (see p. 251f.), is the condensation of 5,5 -diformyldipyrromethanes with 5,5 -unsubstituted dipyrromethanes in a very dilute solution of hydriodic add in acetic acid (A.H. Jackson, 1973). The electron-withdrawing formyl groups disfavor protonation of the pyrrole and therefore isomerization. The porphodimethene that is formed during short reaction times isomerizes only very slowly, since the pyrrole units are part of a dipyrromethene chromophore (see below). Furthermore, it can be oxidized immediately after its synthesis to give stable porphyrins. 

Diacetoxylation of various conjugated dienes including cyclic dienes has been extensively studied. 1,3-Cyclohexadiene was converted into a mixture of isomeric l,4-diacetoxy-2-cyclohexenes of unknown stereochemistry[303]. The stereoselective Pd-catalyzed 1,4-diacetoxylation of dienes is carried out in AcOH in the presence of LiOAc and /or LiCI and beiizoquinone[304.305]. In the presence of acetate ion and in the absence of chloride ion, /rau.v-diacetox-ylation occurs, whereas addition of a catalytic amount of LiCl changes the stereochemistry to cis addition. The coordination of a chloride ion to Pd makes the cis migration of the acetate from Pd impossible. From 1,3-cyclohexadiene, trans- and ci j-l,4-diacetoxy-2-cyclohexenes (346 and 347) can be prepared stereoselectively. For the 6-substituted 1,3-cycloheptadiene 348, a high diaster-eoselectivity is observed. The stereoselective cij-diacetoxylation of 5-carbo-methoxy-1,3-cyclohexadiene (349) has been applied to the synthesis of dl-shikimic acid (350). 

Furthermore, the catalytic allylation of malonate with optically active (S)-( )-3-acetoxy-l-phenyl-1-butene (4) yields the (S)-( )-malonates 7 and 8 in a ratio of 92 8. Thus overall retention is observed in the catalytic reaction[23]. The intermediate complex 6 is formed by inversion. Then in the catalytic reaction of (5 )-(Z)-3-acetoxy-l-phenyl-l-butene (9) with malonate, the oxidative addition generates the complex 10, which has the sterically disfavored anti form. Then the n-a ir rearrangement (rotation) of the complex 10 moves the Pd from front to the rear side to give the favored syn complex 6, which has the same configuration as that from the (5 )-( )-acetate 4. Finally the (S)-( )-mal-onates 7 and 8 are obtained in a ratio of 90 10. Thus the reaction of (Z)-acetate 9 proceeds by inversion, n-a-ir rearrangement and inversion of configuration accompanied by Z to isomerization[24]. 

As supporting evidence, rapid isomerization of the ds- and maui-Tr-allylpal-ladium complexes 27 and 28 is catalyzed by Pd(Ph3P)4 in THF even at -15 C to give a 45 55 equilibrium mixture from either 27 or 28[29-31].. Actually, in the intramolecular reaction of soft nucleophiles of 29 and 30, a trans-ds mi.xttire (31 and 32) (1 1) was obtained from /raiw-allylic acetate 29. On the... 

Carboxylic acids react with butadiene as alkali metal carboxylates. A mixture of isomeric 1- and 3-acetoxyoctadienes (39 and 40) is formed by the reaction of acetic acid[13]. The reaction is very slow in acetic acid alone. It is accelerated by forming acetate by the addition of a base[40]. Addition of an equal amount of triethylamine achieved complete conversion at 80 C after 2 h. AcONa or AcOK also can be used as a base. Trimethylolpropane phosphite (TMPP) completely eliminates the formation of 1,3,7-octatriene, and the acetoxyocta-dienes 39 and 40 are obtained in 81% and 9% yields by using N.N.N M -tetramethyl-l,3-diaminobutane at 50 in a 2 h reaction. These two isomers undergo Pd-catalyzed allylic rearrangement with each other. 

NMR Chemical shift differences m their H NMR spectra aid the structure deter mmation of esters Consider the two isomeric esters ethyl acetate and methyl propanoate As Figure 20 9 shows the number of signals and their multiplicities are the same for both esters Both have a methyl singlet and a triplet-quartet pattern for their ethyl group... 

Heating with cuprous chloride in aqueous hydrochloric acid isomerizes 2-butene-l,4-diol to 3-butene-l,2-diol (98)] Various hydrogen-transfer catalysts isomerize it to 4-hydroxybutyraldehyde [25714-71-0] (99), acetals of which are found as impurities in commercial butanediol and... 

Reactions of /l-Butane. The most important industrial reactions of / -butane are vapor-phase oxidation to form maleic anhydride (qv), thermal cracking to produce ethylene (qv), Hquid-phase oxidation to produce acetic acid (qv) and oxygenated by-products, and isomerization to form isobutane. 

Production of maleic anhydride by oxidation of / -butane represents one of butane s largest markets. Butane and LPG are also used as feedstocks for ethylene production by thermal cracking. A relatively new use for butane of growing importance is isomerization to isobutane, followed by dehydrogenation to isobutylene for use in MTBE synthesis. Smaller chemical uses include production of acetic acid and by-products. Methyl ethyl ketone (MEK) is the principal by-product, though small amounts of formic, propionic, and butyric acid are also produced. / -Butane is also used as a solvent in Hquid—Hquid extraction of heavy oils in a deasphalting process. 

The synthesis of 2,4-dihydroxyacetophenone [89-84-9] (21) by acylation reactions of resorcinol has been extensively studied. The reaction is performed using acetic anhydride (104), acetyl chloride (105), or acetic acid (106). The esterification of resorcinol by acetic anhydride followed by the isomerization of the diacetate intermediate has also been described in the presence of zinc chloride (107). Alkylation of resorcinol can be carried out using ethers (108), olefins (109), or alcohols (110). The catalysts which are generally used include sulfuric acid, phosphoric and polyphosphoric acids, acidic resins, or aluminum and iron derivatives. 2-Chlororesorcinol [6201-65-1] (22) is obtained by a sulfonation—chloration—desulfonation technique (111). 1,2,4-Trihydroxybenzene [533-73-3] (23) is obtained by hydroxylation of resorcinol using hydrogen peroxide (112) or peracids (113). 

---