Absolute advantage

Finally, in the field of full-spectrum NIRS methods, Fourier transform near-infrared (FTIR) analyzers are included (Figure 5.5). FTIR techniques are predominant in mid-infrared spectroscopy because there are clear and absolute advantages for the FTIR analyzer in the mid-infrared compared with any other available technology. This arises because of the low power output of mid-infrared sources and the low specific detectivity... 

The absolute advantage of the biomimetic systems suggested above is that they possess a set of properties that cannot be reproduced in one stage by traditional methods of chemical... 

Economist David Ricardo coined the term comparative advantage in 1817 that extends Smith s concept. It is counter-intuitive because comparative advantage says that, even if a country has an absolute advantage in... 

While the canal viscometer provides absolute viscosities and the effect of the substrate drag can be analyzed theoretically, the shear rate is not constant and the measurement cannot be made at a single film pressure as a gradient is required. Another basic method, more advantageous in these respects, is one that goes back to Plateau... 

Recently, the state-selective detection of reaction products tluough infrared absorption on vibrational transitions has been achieved and applied to the study of HF products from the F + H2 reaction by Nesbitt and co-workers (Chapman et al [7]). The relatively low sensitivity for direct absorption has been circumvented by the use of a multi-pass absorption arrangement with a narrow-band tunable infrared laser and dual beam differential detection of the incident and transmission beams on matched detectors. A particular advantage of probing the products tluough absorption is that the absolute concentration of the product molecules in a given vibration-rotation state can be detenuined. 

Sensitivity levels more typical of kinetic studies are of the order of lO molecules cm . A schematic diagram of an apparatus for kinetic LIF measurements is shown in figure C3.I.8. A limitation of this approach is that only relative concentrations are easily measured, in contrast to absorjDtion measurements, which yield absolute concentrations. Another important limitation is that not all molecules have measurable fluorescence, as radiationless transitions can be the dominant decay route for electronic excitation in polyatomic molecules. However, the latter situation can also be an advantage in complex molecules, such as proteins, where a lack of background fluorescence allow s the selective introduction of fluorescent chromophores as probes for kinetic studies. (Tryptophan is the only strongly fluorescent amino acid naturally present in proteins, for instance.)... 

Drying by hydrolysis. The production of extremely dry (99 -9-(- per cent.) ethyl alcohol from commercial absolute alcohol (99-f percent.) is possible by taking advantage of the fact that the hydrolysis of an ester consumes water. Thus if the absolute alcohol is treated with a little sodium in the presence of an ester of high boiling point e.g., ethyl... 

Random comparisons of predictions with 2.26 versus 2.6 show no consistent advantage for either value, however. It has been suggested to replace the exponent of 0.6 with 0.7 and to use an association factor of 0.7 for systems containing aromatic hydrocarbons. These modifications, however, are not recommended by Umesi and Danner. Lees and Sarram present a comparison of the association parameters. The average absolute error for 87 different solutes in water is 5.9 percent. 

If such fasteners are stove-enamelled (which is normally not done), the trapped hydrogen is removed automatically while being stoved. Since the fasteners are used only for the assembly of switchgear or busbar systems, they are used at room temperature only. Therefore, if they are electroplated, they must be tampered, which is time consuming and adds to the cost of production. Moreover this has no technical advantage. The HT hardware must therefore be used as they are. When it is absolutely necessary to electroplate them, tampering will be essential. 

The advantage of using relative risk results is that you can decide on the best way to improve safety at a facility without having to defend the absolute accuracy of the results. Relative results are also much less likely to be misinterpreted by people unfamiliar with QRA. The disadvantage of using relative results is that they, by definition, cannot give direct advice... 

---