Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Triglycine sulfate

DTGS = deuterated triglycine sulfate KRS — 5 = mixed thallium bromide-iodide LT = lithium tantalate MCT = mercury cadmium telluride and OPO = optical parametric oscillator. [Pg.313]

DTGS Deuterated triglycine sulfate EN Electronic nose... [Pg.753]

Cu(II)-Doped Organic Ferroelectric Crystals Cu(II)-Doped Triglycine Sulfate... [Pg.74]

Several ENDOR investigations on X-irradiated, Cu(II)-, and VO(II)-doped single crystals of triglycine sulfate (TGS) in its ferroelectric phase have been reported by Windsch... [Pg.74]

Pyroelectric detectors depend on the use of a thin slice of ferroelectric material (deuterated triglycine sulfate [DTGS], Figure 5.6, is the standard example) - in which the molecules of the organic crystal are naturally aligned with a permanent electric dipole. The thin slab is cut and arranged such that the direction... [Pg.115]

CEE cyclic fluctuation error DTGS deuterated triglycine sulfate... [Pg.581]

ETIR Measurements. FTIR spectra were recorded using a Nicolet model 870 spectrometer (Madison, WI) equipped with a deuterated triglycine sulfate (DTGS) detector. [Pg.92]

The combination of Fellgett s and Jacquinot s advantage coupled with the inherent speed differential should lead to an enormous difference between FT-IR and dispersive instruments. However, in practice, part of this advantage is offset by the difference in the performance of the triglycine sulfate (TGS) and thermocouple detectors. At low modulation frequencies, the thermocouple detector is about an order of magnitude more sensitive than TGS. [Pg.96]

Practically, the intetferograms are substracted in order to avoid some phase correction problems. If one is working with a room temperature triglycine sulfate (TGS) detector, the four-measurement experiments are not necessary to correct the background 150), whereas with a liquid nitrogen cooled HgCdTe detector, the background correction is necessary. [Pg.114]

Deuterated triglycine sulfate (abbreviated DTGS) is a common ferroelectric infrared detector material. Explain how it works. [Pg.450]

The modulated beam is directed through either the sample or reference side of the sample compartment and is finally focused on the detector. For most mid-infrared work, a triglycine sulfate (TGS) pyroelectric bolometer is used as the detector because of its very high frequency response (> 1 MHz). [Pg.16]

The infrared absorption spectrum of atorvastatin calcium, Form-I, was obtained using a Nicolet FT-IR Impact 410 spectrophotometer equipped with deuterated triglycine sulfate detector, and using Omnic 5.1 a software. The sample was contained in a pressed KBr pellet, with each spectrum being derived from 16 single scans over the range of 4000-400 cm-1 at a... [Pg.19]

The investigated resonance circuit consists of a linear inductance Lo and the dielectric nonlinear capacitance C-nl (see Figure 14.1). Let us consider the case, that a ferroelectric triglycine sulfate crystal (tgs) is used as nonlinear capacitance. [Pg.263]

The OMA technology has been recently applied to infra-red spectroscopy ( 18) as well. A pyroelectric vidicon (utilizing a triglycine sulfate as the sensor element) has been used as a thermal rather than a photon multichannel detector. Simultaneous spectral detection, in the 1-30 um spectral region, was accomplished that has proven to be particularly useful for IR pulse laser applications, Fig.12,... [Pg.22]

Capillary Electrophoresis Chemical Warfare Agents Chemical Weapons Convention Deuterated L-Alanine Triglycine Sulfate Dimethyl Ethylphosphonate Dimethyl Isopropylphosphonate Dimethyl Methylphosphonate Dimethyl Propylphosphonate Dimercaptotoluene Diffuse Reflectance Infrared Fourier Transform Functional Group Chromatograms Flame-Ionization Detector Fourier Transform Infrared Spectroscopy Gas Chromatography Gas Chromatography/Chemical Ionization/Mass Spectrometry Gas Chromatography/Chemical Ionization/Tandem Mass Spectrometry... [Pg.381]

FTIR Spectroscopy. Infrared spectra were recorded on a Perkin Elmer Spectrum One FTIR spectrometer equipped with a Deuterated Triglycine Sulfate (DTGS) detector and KBr optics. Data collection was performed at 4 cm-1 spectral resolution in the region of 4000-450 cm-1 and averaged over 5 scans. All samples were measured in transmission mode. [Pg.55]


See other pages where Triglycine sulfate is mentioned: [Pg.289]    [Pg.980]    [Pg.1018]    [Pg.193]    [Pg.308]    [Pg.312]    [Pg.760]    [Pg.767]    [Pg.370]    [Pg.395]    [Pg.104]    [Pg.107]    [Pg.72]    [Pg.175]    [Pg.435]    [Pg.437]    [Pg.1022]    [Pg.1527]    [Pg.52]    [Pg.291]    [Pg.193]    [Pg.111]    [Pg.468]    [Pg.226]    [Pg.52]    [Pg.599]    [Pg.358]    [Pg.29]   
See also in sourсe #XX -- [ Pg.72 , Pg.73 ]

See also in sourсe #XX -- [ Pg.223 ]

See also in sourсe #XX -- [ Pg.743 ]

See also in sourсe #XX -- [ Pg.86 , Pg.151 ]

See also in sourсe #XX -- [ Pg.147 ]




SEARCH



Crystal of triglycine sulfate

Detector, triglycine sulfate pyroelectric

Deuterated triglycine sulfate

Deuterated triglycine sulfate detector

Deuterated triglycine sulfate pyroelectric detector

Triglycine

Triglycine sulfate (pyroelectric

© 2024 chempedia.info