Cooling liquid nitrogen

Ketene [463-51-4] M 42.0, b 127-130 , d 1.093, n 1.441. Prepared by pyrolysis of acetic anhydride. Purified by passage through a trap at -75° and collected in a liquid-nitrogen-cooled trap. Ethylene was removed by evacuating the ethylene in an isopentane-liquid-nitrogen slush pack at -160°. Stored at room temperature in a suitable container in the dark. See diketene on p. 209. 

Deuterium oxide (7.5 ml) is added dropwise to aluminum isopropoxide (25 g.) The mixture is shaken for about 5 min and then warmed to 70° for 10 min to complete the reaction. The resulting deuterioisopropanol is distilled at room temperature and 1 mm pressure into a liquid nitrogen-cooled trap. Redistillation at atmospheric pressure yields pure isopropanol-OD (9.5 g bp 82-83°). All operations must be protected from moisture. 

Samples may either be those in which the surface of interest has been exposed to the environment before analysis, or the surface to be examined is created in the UHV chamber of the instrument. The latter method is generally preferable, and also argon-ion bombardment is commonly used to clean sample surfaces in situ in the spectrometer. In metallurgical studies, the fracture sample is particularly important the sample is machined to fit the sample holder, and a notch is cut at the desired point for fracture. The fracture stage is isolated from the analytical chamber and is pumped down to UHV. Liquid nitrogen cooling is often provided, as this encourages... 

The source is usually a temperature-stabilized ceramic filament operating around 1500K. The detector in FTIR is usually a deuterium triglycine sulphate (DTGS) detector, although in RAIRS experiments the liquid nitrogen-cooled mercury cadmium telluride (MCT) detector is employed. 

The experiments described here were performed with a Digilab FTS40 Fourier transform instrument, with a liquid nitrogen-cooled Mercury Cadmium Telluride, (MCT), detector. The instrument is provided with a computer for data acquisition, storage and mathematical treatment. P-polarized incident light was obtained by means of an A1 wire-grid polarizer supported on a BaF2 substrate. 

A terpene inhibitor is usually added to the monomer to prevent spontaneous polymerisation, and in its absence, the monomer will spontaneously explode at pressures above 2.7 bar. The inhibited monomer will explode if ignited [1]. Explosion under thermal initiation is now held to be a disproportionation, that to tetrafluo-romethane and carbon gives 3.2 kJ/g, the same energy as black powder [3], Liquid tetrafluoroethylene, being collected in a liquid nitrogen-cooled trap open to air, formed a peroxidic polymer which exploded [2]. 

Introduction. In a typical experiment, the metal vapor is co-condensed at a liquid nitrogen-cooled surface with the ligand substrate vapor. Upon... 

X-ray diffraction (XRD) patterns for the materials were recorded on a X-ray diffractometer using nickel-filtered CuKa (0.154 nm) radiation and a liquid nitrogen-cooled germanium solid-state detector. Thermal stability of the materials was performed using a thermogravimetric analyser. The acidity of calcined samples were determined... 

Precursors for this task were obtained by addition of /-butylmagnesium bromide to the central bond of [1.1.1 ]propellane 40a followed by conversion of the 3-f-butylbicyclo[ 1.1.1 Jpentyl-1 -y 1-magnesium bromide (88) into the ketones 89 by standard methods.27 Reaction of ketones 89 with tosyl hydrazide afforded the hydrazones 90, which gave the corresponding lithium salts 91 by reaction with MeLi in ether. These salts were dried under high vacuum and then pyrolized at 4 x 10 5 torr in the temperature range of 100-130°C and the volatile products condensed in a liquid nitrogen-cooled trap. 

Since the flow system can be made with such a fast response, it becomes important to improve the response of the infrared detector. Use of a liquid-nitrogen-cooled Hg-CdTe detector, with 200 to 1000 Hz chopping and a lock-in amplifier, permits the IR... 

Snowman, J. W. Replacement of conventional refrigeration systems in freeze-drying by liquid nitrogen cooled systems. PDA Asian Symposium, p. 329-345, Tokyo, 1994 Copyright 1994 PDA, Inc. Bethesda, Maryland, USA... 

---