Triethylamine olefination

Fluorine and sulfur (in the form of a methylthio group) are added to nucleophilic olefins with Markovnikov regwselectivity and anti stereoselectivity by di-methyl(niethylthio)sulfoninni fluoroborate and triethylamine tris(hydrogen fluoride) [777] (equation 21)... 

I. 2-Methylcyclohexanol EK Decahydro-2-naphthol A a-Bromo-p-xylene A, EK, MCB Trimethylamine, anhydrous EK Phenothiazine EK, MCB Dibenzyl ketone EK, MCB Triethylamine MCB, EK Olefins A... 

Dipolar cycloadditkm reactions of nitrones to olefins, 46, 1,3-Dipolar cycloadditions with 3-phenylsydnone, 45, 98 Dispiro[5 1 5 l]tetradecane-7,14-dione, photolysis to cyclohexylidene-cyclohexane, 47, 34 preparation from cyclohexanecarbonyl chlonde and triethylamine, 47,34 Displacement of bromine from 1-bromo-2-fluoroheptane to give 2-fluoro-heptyl acetate, 46, 37... 

In a typical procedure61144 the sulfonyl chloride in ether is added to an etheral solution of the diazoalkane and triethylamine. Filtration and evaporation gives the relatively pure thiirane dioxide. Further purification can be easily achieved by recrystallizations preferentially below room temperature in order to avoid fragmentation of the product into sulfur dioxide and the olefin. In general, when the temperature of the above reaction is lowered, the yields are improved without a drastic decrease in reactivity144. Many thiirane dioxides have been successfully synthesized through this method and a detailed list of them can be found elsewhere2. 

Block and Aslam441 reported a novel variant of the Ramberg-Backlund reaction in which a,/J-unsaturated a -bromoalkyl sulfones 368 afforded 1,3-dienes upon treatment with base. Since a -bromoalkyl sulfones 368 can be obtained readily by the initial treatment of olefins with bromomethanesulfonyl bromide under photoirradiation and subsequent treatment with triethylamine, this reaction was utilized for preparation of dienes which contain one additional carbon over that of the corresponding olefin. Starting from the cyclic olefins 369-372 the 1,3-dienes 373-376 were obtained442. 

The most radiation-stable poly(olefin sulfone) is polyethylene sulfone) and the most radiation-sensitive is poly(cyclohexene sulfone). In the case of poly(3-methyl-l-butene sulfone) there is very much isomerization of the olefin formed by radiolysis and only 58.5% of the olefin formed is 3-methyl-l-butene. The main isomerization product is 2-methyl-2-butene (37.3% of the olefin). Similar isomerization, though to a smaller extent, occurs in poly(l-butene sulfone) where about 10% of 2-butene is formed. The formation of the olefin isomer may occur partly by radiation-induced isomerization of the initial olefin, but studies with added scavengers73 do not support this as the major source of the isomers. The presence of a cation scavenger, triethylamine, eliminates the formation of the isomer of the parent olefin in both cases of poly(l-butene sulfone) and poly(3-methyl-1-butene sulfone)73 indicating that the isomerization of the olefin occurred mainly by a cationic mechanism, as suggested previously72. 

Sulfoxides containing an a-chloro group 1191 or an a-trimethylsilyl group 1193 rearrange on silylation with TMSOTf 20/triethylamine or with LDA followed by TCS 14 to the olefins 1192 and 1194 in 86 and 75% yield and HMDSO 7 [22, 23], whereas a sulfoxide with an a-cyano or a-carbomethoxy group as in 1195 reacts... 

Another instructive example is provided by a series of a-phenyl-a,P-dibromo-phosphonates 170, 171, 172. While the phosphonate dianion 170 fragments instantaneously at room temperature with formation of the POf ion (see also Sect. 4.1.3), the analogous reaction of the phosphonic monoester anion 171 leading to methyl metaphosphate 151 requires more drastic conditions and is at least 1000 times slower the diester 172 is essentially stable under the reaction conditions described for 171 addition of triethylamine leads to slow demethylation H0). The behavior of 171 contrasts with that of simple (3-haloalkylphosphonic monoesters which merely eliminate HHal on treatment with bases94. Thus it is the possibility of formation of a phenyl-conjugated double bond which supports the fragmentation of 171 to olefin + 151. 

Treatment of the elimination product 107 with triethylamine resulted in smooth isomerization of the olefin, to afford the a,p-unsaturated ketone 108. Ally lie oxidation of 108 then generated the secondary alcohol 109 in 72 % yield. The acetonide and silyl ether functions of 109 were cleaved in one reaction to afford a tetraol intermediate that was regioselectively acylated at the secondary alcohol functions, to provide the triacetate 110 in high yield (89 %). Hydrogenolysis of the benzyl ether... 

Palladium catalyzed reaction of aryl halides and olefins provide a useful synthetic method for C-C bond formation reaction [171, 172], The commonly used catalyst is palladium acetate, although other palladium complexes have also been used. A sol-vent-free Heck reaction has been conducted in excellent yields using a household MW oven and palladium acetate as catalyst and triethylamine as base (Scheme 6.51) [173], A comparative study revealed that the longer reaction times and deployment of high pressures, typical of classical heating method, are avoided using this MW procedure. 

Intramolecular nitrile oxide—olefin cycloaddition of oxazolidine and thiazoli-dine oximes 407 (R = H, Me R1 =H, Me X = 0, S n = 1,2) proceed stereose-lectively, yielding tricyclic fused pyrrolidines and piperidines. Thus, 407 (n =2 R = H R1 =Me X=S) has been oxidized to the nitrile oxides with sodium hypochlorite, in the presence of triethylamine in methylene chloride, to give the isoxazolothiazolopyridine 408 in 68% yield. Reduction of 408 with lithium aluminum hydride affords mercaptomethylmethylpiperidine 409 in 24% yield (448). 

Although the reaction of a titanium carbene complex with an olefin generally affords the olefin metathesis product, in certain cases the intermediate titanacyclobutane may decompose through reductive elimination to give a cyclopropane. A small amount of the cyclopropane derivative is produced by the reaction of titanocene-methylidene with isobutene or ethene in the presence of triethylamine or THF [8], In order to accelerate the reductive elimination from titanacyclobutane to form the cyclopropane, oxidation with iodine is required (Scheme 14.21) [36], The stereochemistry obtained indicates that this reaction proceeds through the formation of y-iodoalkyltitanium species 46 and 47. A subsequent intramolecular SN2 reaction produces the cyclopropane. 

Treatment of RCH(SPh)COCl with triethylamine resulted in the in situ generation of alkyl (phenylthio) ketenes, which were trapped by olefinic compounds following thermal[2 + 2]cycloaddition to form cyclobutanes (223) 74). 

In 1991, Mandai et al. reported that the palladium-catalyzed reaction of propargyl carbonates with olefins proceeded smoothly in DMF at 70 °C in the presence of triethylamine and potassium bromide to give vinylallenes in good yields [54], The active palladium catalyst was generated in situ from Pd(OAc)2 and PPh3. A typical example is shown in Scheme 3.19. 

Reactions of amines with alkenes have been reviewed298,299. Alkali metal amides are active homogeneous catalysts for the amination of olefins. Thus diethylamine and ethylene yield triethylamine when heated at 70-90 °C at 6-10 atm in the presence of lithium diethylamide and /V./V./V. /V -tetrarncthylcthylcncdiaminc. Solutions of caesium amide promote the addition of ammonia to ethylene at 100 °C and 110 atm to give mixtures of mono-, di- and triethylamines300. The iridium(I)-catalysed addition of aniline to norbomene affords the anilinonorbomane 274301. Treatment of norbomene with aniline... 

Successive treatment of primary or secondary nitroalkanes with triethylamine and hex-adecyltrimethylammonium permanganate affords aldehydes or ketones, respectively (e.g. equation 129). Hydroxyl groups and olefinic double bonds are not affected421. 

For comparison, fluorous-phase-soluble Pd complexes are only 74-98% selective towards the trans product [168-170]. The isolated yields of the product approached 70% when a threefold excess of olefin to iodobenzene was used (Table 3) however, the percent yield decreased with the use of bromobenzene as expected since activation of bromine-carbon bonds is less favorable than iodo-carbon bonds. It was also possible to catalyze the reaction in the absence of additional triethylamine base (Table 3). In this case, the tertiary amines of the den-drimer most likely act as the base. The catalysts, in general, were fully recover-... 

Recently it has been shown that radical anionic cyclization of olefinic enones effectively compete with intramolecular [2 -I- 2]-cycloaddition to form spirocy-clic compounds [205, 206], 3-Alkenyloxy- and 3-alkenyl-2-cyclohexenones 235 are irradiated in the presence of triethylamine. As depicted in Scheme 46 two reaction pathways may operate. Both involve electron transfer steps, either to the starting material (resulting in a direct cyclization) or to the preformed cyclobutane derivative 239, which undergoes reductive cleavage. The second... 

Other useful dehydrating agents are dimethylaminosulfur trifluoride (DAST), methyl A -(triethylammoniosulfonyl)carbamate (Burgess salt), acetic anhydride, oxalyl chloride, and phosphorous oxychloride, each one in combination with triethylamine (89). Dehydration of O-sUylated hydroxamic acids using trifluoro-methanesulfonic anhydride and triethylamine under mild conditions also gave nitrile oxides, which in the presence of olefins led to the formation of 2-isoxazolines in moderate to good yields (90). In view of the less readily available starting materials, this method probably will be of limited use. 

Hosokawa, Murahashi, and coworkers demonstrated the ability of Pd" to catalyze the oxidative conjugate addition of amide and carbamate nucleophiles to electron-deficient alkenes (Eq. 42) [177]. Approximately 10 years later, Stahl and coworkers discovered that Pd-catalyzed oxidative amination of styrene proceeds with either Markovnikov or anti-Markovnikov regioselectivity. The preferred isomer is dictated by the presence or absence of a Bronsted base (e.g., triethylamine or acetate), respectively (Scheme 12) [178,179]. Both of these reaction classes employ O2 as the stoichiometric oxidant, but optimal conditions include a copper cocatalyst. More recently, Stahl and coworkers found that the oxidative amination of unactivated alkyl olefins proceeds most effectively in the absence of a copper cocatalyst (Eq. 43) [180]. In the presence of 5mol% CUCI2, significant alkene amination is observed, but the product consists of a complicated isomeric mixture arising from migration of the double bond into thermodynamically more stable internal positions. 

Reaction of l-aryl-3-carbethoxy-6-phenyl-l,4,5,6-tetrahydropyridazin-4-ones 718 with activated olefins such as benzalacetophenone, benzalacetone, 3-benzylideneacetylacetone, diethyl 2-benzylidenemalonate, and a-cyano-/3-phenylacrylic acid in the presence of an organic base like pyrrolidine, morpholine, piperidine, or triethylamine gave the corresponding 2,8-dihydro-l//-pyrano[2,3-t7 pyridazines 719-723, respectively. The 1-oxo- and 1-imino derivatives of the pyrano[2,3-r/ pyridazine ring system were also prepared from the respective 6-oxo or 6-imino derivative of the starting pyridazine 718 under the same conditions (Equation 60) <1989IJB733>. 

The olefins formed under these conditions using other tertiary alcohols tend to follow the Hofmann rule [6a]. However, tertiary alcohols and phenols [6b] can be made to react with isocyanates to give urethanes when they are catalyzed by acids or bases such as pyridine [6b], triethylamine, sodium acetate, boron trifluoride etherate, hydrogen chloride, or aluminum chloride [7]. Table I indicates the results of preparing phenylurethanes of tertiary alcohols... 

Next to the cyclopropane formation, elimination represents the simplest type of a carbon-carbon bond formation in the homoenolates. Transition metal homoenolates readily eliminate a metal hydride unit to give a,p-unsaturated carbonyl compounds. Treatment of a mercurio ketone with palladium (II) chloride results in the formation of the enone presumably via a 3-palladio ketone (Eq. (24), Table 3) [8], The reaction can be carried out with catalytic amounts of palladium (II) by using CuCl2 as an oxidant. Isomerization of the initial exomethylene derivative to the more stable endo-olefin can efficiently be retarded by addition of triethylamine to the reaction mixture. 

---