Treatment titanate

Fig. X-4. Water contact angle of titania-coated glass after treatment with trimethyloc-tadecylammonium chloride as a function of the number of coating treatments with 1.1% polydibutyl titanate. (From Ref. 51.)...

Flame-Retardant Treatments For Wool. Although wool is regarded as a naturally flame-resistant fiber, for certain appHcations, such as use in aircraft, it is necessary to meet more stringent requirements. The Zirpro process, developed for this purpose (122,123), is based on the exhaustion of negatively charged zirconium and titanium complexes on wool fiber under acidic conditions. Specific agents used for this purpose are potassium hexafluoro zirconate [16923-95-8] [16923-95-8] K ZrF, and potassium hexafluoro titanate [16919-27-0], K TiF. Various modifications of this process have been... 

Strontium titanate [12060-59-2] SrTiO, becomes an n-ty e semiconductor when additional electrons are created on the Ti lattice sites by donor doping or when oxygen is removed from the material through heat treatment in a reducing atmosphere. The mobiUty of the electrons in the conduction band is about 6 crc] j(V-s). On the other hand, when ZnO is reduced, 2inc interstitials are formed and these act as donors, each yielding a free electron. 

ESR spectra were recorded on a JEOL JES-RE2X spectrometer. About 250 mg of ruthenium-free titanate samples was subjected to heat treatment either in vacuum at 573 K or in a hydrogen atmosphere at 973 K. For measurements of ESR spectra, 30 Torr of O2 or N2O was introduced at room temperature and then cooled to 77 K without evacuation. The spectra were obtained in the dark and under UV irradiation with a 500 W low pressure mercury lamp. 

Characterization of the surface impurities on the catalyst is also essential, and photoreactivity data should be analyzed in terms of active and accessible surface area. The defect state of the surface and nanostructure are also important aspects to understand. Current advances in the synthesis allow preparing Titania or titanate nanorods with different diameter and aspect ratio, and different surface nanostructure as well. Limiting the discussion here to only preparations by hydrothermal treatment (for reasons of conciseness), various mechanisms of growing of the nanorods has been reported. The differences in the mechanism of formation would imply differences in the surface characteristics of the nanorods, but there is no literature available on this topic. 

An alternative formation of titanated alkoxyallenes could be achieved by reaction of 3-alkoxy-2-propyn-l-yl carbonates 78 with (r/2-propene)titanium diisopropoxylate (79). Successive addition of 80 to benzaldehyde afforded the corresponding addition products 81 in high yield (Scheme 8.22) [70]. The results demonstrate that titanium species 75 and 80 can serve as easily available ester homoenolate equivalents. Notably, conversion of lithiated alkoxyallenes to the magnesium species by treatment with MgBr2 followed by addition to chiral carbonyl compounds resulted in a mixture of a- and y-products [71]. 

The compound also may be prepared by other methods. These include ignition of barium and titanium alcoholates in an organic solvent treatment of tetraethyl titanate or other alkyl ester of titanium with an aqueous solution of barium hydroxide and ignition of barium titanyloxalate. 

Various investigations have considered the effects of titanate treatments on melt rheology of filled thermoplastics [17,41]. Figure 10, for example, shows that with polypropylene filled with 50% by weight of calcium carbonate, the inclusion of isopropyl triisostearoyl titanate dispersion aid decreases melt viscosity but increases first normal stress difference. This suggests that the shear flow of the polymer is promoted by the presence of titanate treatment, and is consistent with the view that these additives provide ineffective coupling between filler particles and polymer matrix [42]. 

Reduction of ammonium chlororuthenate with titanous chloride gives a solution containing divalent ruthenium which will absorb ethylene or propylene to give a 1 1 ruthenium-olefin complex which was not isolated (108). Ethylene was previously reported not to form stable complexes on treatment with ruthenium halides (97). 

Titanous chloride also reduces sulphurous acid or sodium hydrogen sulphite solution with formation of an orange-yellow solution of hydro-sulphurous acid,5 from which sodium hydrosulphite is obtainable by further treatment with sodium hydroxide solution ... 

Diazotization has been reported for all the pyrazolopyridines, and in some cases the salts have been isolated. A 7-aminopyrazolo[4,3-c]pyridine (191a) was converted to the corresponding hydroxy compound with sodium nitrite in hot glacial acetic acid.159 Analogous products were obtained from a 3-aminopyrazolo[3,4-b]-15 and 2-aminopyrazolo[l,5-a]pyridine.186 Decomposition of diazonium salts with hydrobromic acid afforded 3-bromo-pyrazolo[3,4-c]-u0 or -[4,3-bjpyridines111 deamination of 3-aminopyra-zolo[3,4-h]pyridines was achieved via treatment of the diazonium salts with hypophosphorous acid,10 titanous chloride,238 or ferrous ammonium sulfate.238 Kocevar et al.236 have made a detailed study of the reactions of the latter diazonium salt. 

---