Chlorination thiophenes

With one equivalent of IV-chlorosuccinimide (NCS) in acetic acid at 25°, thienothiophene 1 gives the initial thienothiophene 1 (11%), 2-chloro- (78%) and 2,5-dichlorothieno[2,3-6]thiophene (10%), while a 70% yield of 2,5-dichlorothieno[2,3-6]thi(q)hene is produced with two equivdents of NCS. Similar results were obtained from thienothiophene 2 with one and two equivalents of NCS. About 0.4% 3-chlorothieno[2,3-6]thiophene was detected by gas-liquid chromatography among the chlorination products of 1. The same amount of /9-isomer is found in thiophene chlorination products. In the case of thienothiophene 2, the corresponding /9-isomer was not observed in the reaction products. To identify 3-chloro-substituted thiophene and thienothiophenes 1 and 2 in reaction mixtures, these compounds were prepared independently from the corresponding 3-bromo derivatives by Uthiation followed by chlorination at —70°. 

Investigations led to the conclusion that A-chlorosuccinimide (NCS) in acetic acid is the reagent of choice for the selective monochlorination of various thiophenes [85]. Other chlorinating agents such as sulfuryl chloride, hypochlorous acid [86], benzyltrimethylammonium tetrachloroiodate [87] or tin(IV) chloride in the presence of lead(IV) acetate [88] were shown to be useful reagents for thiophene chlorination. 

The halogenation of thiophene follows a similar pattern in that (a) chlorination is the most difficult to control and (b) substitution occurs preferentially in the a-positions. With... 

Halogens react with benzo[6]furan by an addition-elimination mechanism to give 2- and 3-substituted products (76JCS(P2)266). Treatment of benzo[6]thiophene with chlorine or bromine in acetic acid gives predominantly 3-substituted products (71JCS(B)79). 2,2,3,3,4,5,6,7-Octachloro-2,3-dihydrobenzothiophene is obtained when benzo[6]thio-phene is treated with chlorine in the presence of 1 mole of iodine (80JOC2l5l). 

Nitration of 4-(2-thienyl)- (301) and 4-(3-thienyl)-pyrazoles (302) mainly occurs on the thiophene ring, but when acetyl nitrate is used as the nitration agent small quantities of products nitrated on the pyrazole ring are isolated (position of the nitro group uncertain) (80CS( 15)102). Pyrazol-l -ylpyridines (303) undergo electrophilic reactions (bromination, chlorination and nitration) preferentially in the pyrazole ring. Thus, the nitration of (303 R = R = = H) either with a mixture of nitric acid and sulfuric acid at 10-15 °C or with... 

Ethylene, /3-(dimethylamino)-nitro-in pyrrole synthesis, 4, 334 Ethylene, dithienyl-in photochromic processes, 1, 387 Ethylene, furyl-2-nitro-dipole moments, 4, 555 Ethylene, l-(3-indolyl)-2-(pyridyl)-photocyclization, 4, 285 Ethylene, l-(2-methyl-3-indolyl)-l,2-diphenyl-synthesis, 4, 232 Ethylene, (phenylthio)-photocyclization thiophenes from, 4, 880 Ethylene carbonate C NMR, 6, 754 microwave spectroscopy, 6, 751 photochemical chlorination, 6, 769 synthesis, 6, 780 Ethylene oxide as pharmaceutical, 1, 157 thiophene synthesis from, 4, 899 Ethylene sulfate — see 2,2-dioxide under 1,3,2-Dioxathiolane... 

The reduction of the C— Br and C—1 group moments from 1.10 and 0.90 in bromo- and iodo-benzene to about 0.80 and 0.50 in 2-bromo- and 2-iodo-thiophene has been ascribed to the larger weight of resonance forms such as (8) and (9) in the thiophene series. The chlorine, nuclear, quadrupole, resonance frequencies of chloro-substituted thiophenes are much higher than those of the corresponding benzene derivatives. This has been ascribed to a relayed inductive effect originating in the polarity of the C—S o-bond in thiophenes. The refractive indices, densities, and surface tension of thiophene, alkyl- and halo-thiophenes, and of some other derivatives have been... 

Dichlorothiophene has become easily available through chlorination and dehydrochlorination of tetrahydrothiophened Another example of the aromatization of tetrahydrothiophene derivatives is the preparation of 3-substituted thiophenes by the reaction of 3-ketotetrahydrothiophene with Grignard reagents followed by the aromatization of the intermediate dihydrothiophene. Recent gas chromatographic analysis showed, however, that 2,3-dichlorothio-phene is the main product from the dehydrochlorination of tetra-chlorotetrahydrothiophene. 

It is thus apparent that the selectivity of a reagent toward thiophene and benzene can differ appreciably, and this difference in selectivity is also strongly noticeable in the proportions of 2- and 3-isomers formed. Although in certain reactions no 3-isomer has been detected, appreciable amounts have been found in other reactions. Thus 0.3% of the 3-isomer has been found in the chlorination of thiophene.- Earlier results indicated that 5-10% 3-nitrothiophene is formed in the nitration of thiophene and a recent gas-chromatographic analysis by Ostman shows that the mononitrothiophene fraction contains as much as 16% of the 3-isomer. It appears that gas-chromatographic analysis should be very useful for the detection of small amounts of 3-isomers in other substitution reactions. However, from routine analyses of IR spectra, it appears to the present author that the amount of 3-isomers formed in acylation, formylation, and bromina-tion of thiophene are certainly less than a few per cent. 

With weakly directing — I + M-substituents such as the halogens, the a-directing power of the ring sulfur dominates and substitution appears to occur exclusively in the 5-position. 2-Chloro-, 2-bromo-, and 2-iodo-thiophene are sulfonated both with chlorosulfonic aeid and in the 5-position. In the chlorination of chloro-... 

This activation of the ortho position is most strikingly illustrated in the reactivity of 2,5-dimethylthiophene, which competitive experiments have shown to undergo the SnCb-catalyzed Friedel-Crafts reaction more rapidly than thiophene and even 2-methylthiophene. The influence of the reagent on the isomer distribution is evident from the fact that 2-methoxythiophene is formylated and bromi-nated (with A -bromosuccinimide) only in the 5-position. Similarly, although 3-bromo-2-methylthiophene has been detected in the bromi-nation of 2-methylthiophene with bromine, only the 5-isomer (besides some side-chain bromination) is obtained in the bromination of alkylthiophenes with A -bromosuccinimide. ° However, the mechanism of the latter type of bromination is not established. No lines attributable to 2-methyl-3-thiocyanothiophene or 2-methyl-3-chIoro-thiophene could be detected in the NMR spectra of the substitution products (5-isomers) obtained upon thiocyanation with thiocyanogen or chlorination with sulfuryl chloride. 2-Methyl- and 2-ethyl-thiophene give, somewhat unexpectedly, upon alkylation with t-butyl chloride in the presence of Feds, only 5-t-butyl monosubstituted and... 

From resonance structure (12) it is obvious that a —I—M-substit-uent strongly deactivates the 2-position toward electrophilic substitution, and one would thus expect that monosubstitution occurs exclusively in the 5-position. This has also been found to be the case in the chlorination, bromination, and nitration of 3-thiophenecarboxylic acid. Upon chlorination and bromination a second halogen could be introduced in the 2-position, although further nitration of 5-nitro-3-thiopheneearboxylic acid could not be achieved. Similarly, 3-thiophene aldehyde has been nitrated to 5-nitro-3-thiophene aldehyde, and it is further claimed that 5-bromo-3-thiopheneboronic acid is obtained upon bromination of 3-thiopheneboronic acid. ... 

In the reactions of 2,5-disubstituted thiophenes elimination of an a-substituent occurs to a much greater extent than in the benzene series. The Friedel-Crafts acetylation of 5-bromo-2-ethylthiophene in the presence of SnCE gives 2-ethyl-5-acetyIthiophene. Elimination of an a-bromine occurs also in the chloromethylation of 2,5-di-bromothiophene, leading to a mixture of 2-bromo-5-chloromethyIthio-phene and 2,5-dibromo-3-chloromethyIthiophene. Bromine atoms at both the and -position are exchanged for chlorine in the... 

Catalytic reduction of thiophenes over cobalt catalysts leads to thiolane derivatives, or hydrocarbons. " Noncatalytic reductions of thiophenes by sodium or lithium in liquid ammonia leads, via the isomeric dihydrothiophenes, to complete destructions of the ring system, ultimately giving butenethiols and olefins. " Exhaustive chlorination of thiophene in the presence of iodine yields 2,2,3,4,5,5,-hexachloro-3-thiolene, Pyrolysis of thiophene at 850°C gives a... 

Millan and coworkers (99-101) also studied the effect of tacticity on the nucleophilic substitution reactions of PVC. Sodium thiophenate and phenol were used for these reactions. The central chlorine in isotactic triads and, to a lesser extent, in heterotactic triads was found to be most reactive. It was concluded that initiation of degradation may occur by normal structures, and polyene build-up may be favored by syndiotic sequence. This... 

When thieno[2,3- ]pyrazine was chlorinated, the reaction resembled the corresponding pyridine and pyrimidine (152) analogues in that 13-substitution in the thiophene ring was observed (80JHC1019). 

Despite the relative simplicity of the kinetics of molecular chlorination, there has so far been only one measurement of the rate coefficient with a heterocyclic compound and the need for more work in this area is indicated. Marino265 found that chlorination of thiophene by chlorine in acetic acid at 25 °C gave the second-order rate coefficient of 10.0 1.5, so that thiophene is 1.7 x 109 times as reactive as benzene in this reaction and this large rate spread is clearly consistent with the neutral and hence relatively unreactive electrophile. 

Although chlorination, bromination and iodination of thiophenes by polyhalide salts require forcing conditions with the addition of zinc chloride [52], halogenation of acridine and acridone has been recorded to yield both 3-halo and 3,7-dihalo derivatives under relatively mild reaction conditions [53], However, whereas chloro-, bromo- and iodo-compounds are readily obtained from acridone, acridine only forms the bromo derivatives, as it produces stable complexes with the dichloroiodate and tetrachloroiodate salts [53]. 

The influence of catalysts on the exhaustive chlorination of thiophene was discussed by Hartough and his associates (15). 

Additional acylation studies were also reported (24), (26). In the first case it is claimed that acylation of thiophene is achieved by means of HC104 and acetic anhydride affording a 65 % yield of 2-acetylthiophene. In the second paper Levine and coworkers reported that while 2,5-dimethylthiophene could be readily acetylated, 2,5-dichlorothiophene acetylated sluggishly. This is, however, readily explained, since the presence of chlorine atoms on the thiophene ring decreased its reactivity in electrophilic substitution reactions. In the case of methyl substitution, however, the 3 and 4 positions of the ring are activated toward electrophilic substitution by the inductive and hyperconjugative effects. Thus 2,5-dimethylthiophene was successfully acylated by the boron fluoride etherate method in high yield with three aliphatic anhydrides. 

Thiophene. III. Influence of Catalysts in the Exhaustive Chlorination of Thiophene. J. Amer. chem. Soc. 74, 163 (1952). 

---