Tetrakis 3,5-bis

If the water content of the diazotization system is too high, the halogen atom in halogen-substituted mono- and dinitroanilines may be replaced by a hydroxy group in a bimolecular aromatic substitution. Analogous behaviour was observed in the diazotization of pentafluoroaniline, where the 4-fluoro substituent became hydrolysed (Brooke et al., 1965). As already mentioned in Section 2.1, this side reaction does not take place if the diazotization is conducted in a dichloromethane-aqueous sulfuric acid two-phase system in the presence of tetrakis[3,5-bis(trifluoromethyl)-phenyl]borate (Iwamoto et al., 1983a, 1984). 

Experience in PTC with cationic catalysts showed that, in general, the most suitable compounds have symmetrical structures, are lipophilic, and have the active cationic charge centrally located or sterically shielded by substituents. For anionic catalysis sodium tetraphenylborate fulfills these conditions, but it is not stable under acidic conditions. However, certain derivatives of this compound, namely sodium tetra-kis[3,5-bis(trifluoromethyl)phenyl]borate (TFPB, 12.162) and sodium tetrakis[3,5-bis-(l,l,l,3,3,3-hexafluoro-2-methoxy-2-propyl)phenyl]borate (HFPB) are sufficiently stable to be used as PTC catalysts for azo coupling reactions (Iwamoto et al., 1983b 1984 Nishida et al., 1984). These fluorinated tetraphenylborates were found to catalyze strongly azo coupling reactions, some of which were carried out with the corresponding diazotization in situ. 

An unprecedented carbene insertion reaction was observed on reaction of the cationic re-arene ruthenium amidinates with trimethylsilyldiazo-methane (Scheme 145, TFPB = tetrakis[3,5-bis(trifluoromethyl)phenyl]borate). 

The formation of ethers such as 1806 by EtsSiH 84b can also be catalyzed by trityl perchlorate to convert, e.g., benzaldehyde in 84% yield into dibenzyl ether 1817 [48]. The combination of methyl phenethyl ketone 1813 with O-silylated 3-phenyl-n-pro-panol 1818, in the presence of trityl perchlorate, leads to the mixed ether 1819 in 68% yield [48] (Scheme 12.15). Instead of trityl perchlorate, the combination of trityl chloride with MesSiH 84a or EtsSiH 84b and sodium tetrakis[3,5-bis-(trifluoro-methyl)phenyl]borane as catalyst reduces carbonyl groups to ethers or olefins [49]. Employing TMSOTf 20 as catalyst gives very high yields of ethers. Thus benzaldehyde reacts with O-silylated allyl alcohol or O-silylated cyclohexanol to give the... 

Suitable electrolytes for the aqueous phase (w) comprise, for example, LiCl, HCl, MgCl2, MgS04, while suitable electrolytes for the organic phase (o) comprise salts of, for example, tetrabutylammonium, tetraphenylarsonium, or bis(triphenyl-phosphoranylidene)ammonium cations with tetraphenylborate, tertrakis(4-chloro-phenyl)borate, or tetrakis[3,5-bis(trifluoromethyl)phenyl]borate anion. 

FIG. 9 Differential capacity C of the interface between 0.1 M LiCl in water and 0.02 M tetrabu-tylammonium tetraphenylborate ( ) or tetrapentylammonium tetrakis[3,5-bis(trifluoromethyl)phe-nyl]borate ( ) in o-nitrophenyl octyl ether as a function of the interfacial potential difference (From Ref 73.)... 

These rod-shaped ligands share a sterically efficient terminal N-donor and their divalent Co chemistry is well established. They will be discussed here only with selected examples. [Co (NCMe)6](TFPB)2 (TFPB- = tetrakis(3,5-bis(trifhioromethyl)phenyl)borate)) has been synthesized and characterized in the solid state along with a number of other divalent transition metal analogs.357 As a result of the extremely poor coordinating ability of the anion and facile loss of MeCN ligands from the cation, the salt is an excellent source of naked Co2+ ions. Thermolysis up to 100 °C leads to the loss of one MeCN and formation of a r -bound nitrile, whereas above 130 °C decomposition occurs with loss of MeCN and abstraction of fluoride from the anion to form CoF2. 

Cyclododecanone is reduced to a mixture of cis- and /ra .s -cyclododecenc in high yield with trimethylsilane and tetrakis-3,5-bis(trifluoromethylphenyl)borate (TFPB, 77) (Eq. 254).424... 

This complex is not the actual catalyst for the hydrovinylation, but needs to be activated in the presence of a suitable co-catalyst. The role of this additive is to abstract the chloride ion from the nickel centre to generate a cationic allyl complex that further converts to the catalytically active nickel hydride species. In conventional solvents this is typically achieved using strong Lewis acids such as Et2AlCl. Alternatively, sodium or lithium salts of non-coordinating anions such as tetrakis-[3,5-bis(trifluoromethyl)phenyl]borate (BARF) can be used to activate hydrovinylation... 

Scheme 39.2 Examples of typical rhodium-based catalyst systems and modified derivatives of triphenylphosphine as used to control their solubility with scC02 in homogeneous or multiphase systems (BARF=tetrakis[3,5-bis (trifluoromethyl)phenyl]borate).

A very reactive Lewis acid is obtained when the complex [(EBTHI)Zr(Me)2] is converted in situ to a dicationic species by protonation with the acid H-BARF (BARF = tetrakis[3,5-bis(trifluoromethyl)phenyl]borate) in the presence of the Diels—Alder substrate oxazolidi-none [88] (Scheme 8.48). The dicationic species is stabilized through coordination by the oxazolidinone and by diethyl ether (derived from the acid etherate employed). The catalyst loading in the Diels—Alder reaction could be lowered to 1 mol% (Zr) and the reaction still... 

Amino acids may be determined by measuring the amines obtained after the action of a carboxylase with a specific electrode for amines, which is based on a poly(vinyl chloride) membrane containing sodium tetrakis[3,5-bis(trifluoromethyl)phenyl]borate (166) as ion exchanger and tricresyl phosphate as solvent mediator. LOD was 20 and 50 i-M for tyroxine and phenylalanine, determined as tyramine (5) and phenethylamine (33), respectively364. 

An iridium(I) complex with the l,2-bis(tcrt-butylmethylphosphino)ethane (4) and tetrakis(3,5-bis(trifluoromethyl)phenyl)borate as the counter anion catalyzes the hydrogenation of several acyclic aromatic Ai-arylimines under atmospheric hydrogen pressure at room temperature, giving the desired chiral amines with high-to-excellent enantioselectivities (up to 99%, Fig. 6) [19]. The authors also tested (S )-BINAP (Fig. 1) and (/ )-Ph-PHOX (PHOX = 2-[2-(diphenylphosphino) phenyl]-4,5-dihydrooxazole) hgands with lower enantioselectivities [19]. Both steric and electronic properties of the ligand and the combination with the BArF anion are in the base of the efficacy of this catalytic system. On the other hand, attempted hydrogenations of Ai-(2,2,2-trifluoro-l-phenylethylidene)aniline and M-(l,2,2-trimethyl-propylidene)aniline under the same conditions resulted in... 

After extensive experimentation, a simple solution for avoiding catalyst deactivation was discovered, when testing an Ir-PHOX catalyst with tetrakis[3,5-bis (trifluoromethyl)phenyl]borate (BArp ) as counterion [5]. Iridium complexes with this bulky, apolar, and extremely weakly coordinating anion [18] did not suffer from deactivation, and full conversion could be routinely obtained with catalyst loadings as low as 0.02 mol% [19]. In addition, the BArp salts proved to be much less sensitive to moisture than the corresponding hexafluorophosphates. Tetrakis (pentafluorophenyl)borate and tetrakis(perfluoro-tert-butoxy)aluminate were equally effective with very high turnover frequency, whereas catalysts with hexafluorophosphate and tetrafluoroborate gave only low conversion while reactions with triflate were completely ineffective (Fig. 1). 

Phosphinodihydroxazole (PHOX) compounds, L2-4, act as P/N bidentate ligands showing excellent enantioselectivity in Ir-catalyzed hydrogenation of simple a,a-disubstituted and trisubstituted olefins (Figure 1.12). " The use of tetrakis[3,5-bis(trifluoromethyl)phenyl]borate (BArp) as a counter anion achieves high catalytic efficiency due to avoidance of an inert Ir trimer... 

In 1998 the groups of Jprgensen and Helmchen reported the preparation of the chiral silyl cationic salt 2 (Scheme 3) [30]. This was the first time that a chiral silyl cation was used as a catalyst in an enantioselective reaction, hi order to ensure that the silyl salt had a high reactivity, the almost chemically inert and non-coordinating anions tetrakis[pentafluorophenyl]borate [TPFPB] and tetrakis[3,5-bis (trifluor-omethyl)phenyl]borate [TFPB] were chosen as counter anions. 

Since silyl cations are highly reactive and moisture sensitive, the salts (S)-2a and (S)-2b were prepared in situ from the air and moisture stable precursor (S)-5 via a hydride transfer [34, 35] with trityl tetrakis[3,5-bis(trifluoromethyl)phenyl]borate [Tr][TFPB] or trityl tetrakis[pentafluorophenyl]borate [Tr][TPFPB], The authors showed by Si-NMR studies that the desired salts were formed. The silyl salt (5)-2a was then tested in the Diels-Alder reaction as shown in Scheme 5. A good reactivity was found, and the product was obtained in 95% yield with higher than 95% endo selectivity at -40 °C in 1 h. However, only 10% ee was achieved. 

---