Tetraalkylammonium

In spite of being ionic many quaternary ammonium salts dissolve m nonpolar media The four alkyl groups attached to nitrogen shield its positive charge and impart lipophilic character to the tetraalkylammonium ion The following two quaternary ammonium salts for example are soluble m solvents of low polarity such as benzene decane and halo genated hydrocarbons... 

Creager and colleagues designed a salicylate ion-selective electrode using a PVC membrane impregnated with tetraalkylammonium salicylate. To determine the ion-selective electrode s selectivity coefficient for benzoate,... 

Small amounts of propionitrile and bis(cyanoethyl) ether are formed as by-products. The hydrogen ions are formed from water at the anode and pass to the cathode through a membrane. The catholyte that is continuously recirculated in the cell consists of a mixture of acrylonitrile, water, and a tetraalkylammonium salt the anolyte is recirculated aqueous sulfuric acid. A quantity of catholyte is continuously removed for recovery of adiponitrile and unreacted acrylonitrile the latter is fed back to the catholyte with fresh acrylonitrile. Oxygen that is produced at the anodes is vented and water is added to the circulating anolyte to replace the water that is lost through electrolysis. The operating temperature of the cell is ca 50—60°C. Current densities are 0.25-1.5 A/cm (see Electrochemical processing). 

The electrochemical route to duoroaromatics (90) based on controlled potential electrolysis in the absence of hydrogen duoride (platinum anode, +2.4 V acetonitrile solvent tetraalkylammonium duoride electrolyte) has not been commercialized. However, considerable industrial interest in the electrochemical approach stiU exists (91—93). 

The lanthanides form many compounds with organic ligands. Some of these compounds ate water-soluble, others oil-soluble. Water-soluble compounds have been used extensively for rare-earth separation by ion exchange (qv), for example, complexes form with citric acid, ethylenediaminetetraacetic acid (EDTA), and hydroxyethylethylenediaminetriacetic acid (HEEDTA) (see Chelating agents). The complex formation is pH-dependent. Oil-soluble compounds ate used extensively in the industrial separation of rate earths by tiquid—tiquid extraction. The preferred extractants ate catboxyhc acids, otganophosphoms acids and esters, and tetraaLkylammonium salts. 

Hydrogen Sulfide andMercaptans. Hydrogen sulfide and propylene oxide react to produce l-mercapto-2-propanol and bis(2-hydroxypropyl) sulfide (69,70). Reaction of the epoxide with mercaptans yields 1-aLkylthio- or l-arylthio-2-propanol when basic catalysis is used (71). Acid catalysts produce a mixture of primary and secondary hydroxy products, but ia low yield (72). Suitable catalysts iaclude sodium hydroxide, sodium salts of the mercaptan, tetraaLkylammonium hydroxide, acidic 2eohtes, and sodium salts of an alkoxylated alcohol or mercaptan (26,69,70,73,74). 

A mild and effective method for obtaining N- acyl- and N- alkyl-pyrroles and -indoles is to carry out these reactions under phase-transfer conditions (80JOC3172). For example, A-benzenesulfonylpyrrole is best prepared from pyrrole under phase-transfer conditions rather than by intermediate generation of the potassium salt (81TL4901). In this case the softer nature of the tetraalkylammonium cation facilitates reaction on nitrogen. The thallium salts of indoles prepared by reaction with thallium(I) ethoxide, a benzene-soluble liquid. 

This method is based on the generation of the tetraalkylammonium salt of pyrrolidorle, which acts as a base. The method is compatible with a large variety of carboxylic acids and alkylating agents. The method is effective for the preparation of macrolides. 

Electronegatively substituted acetylenes, such as dimethyl acetylenedicar-boxylate, do not react under normal conditions but will add the elements of hydrogen fluoride by reaction with fluoride ion (e g, CsF or tetraalkylammonium dihydrogen trifluoride) and a proton source under phase-transfer conditions [49, 50] (equation 8)... 

Various sources of fluoride ion have been investigated, of which highly nucleophilic tetraalkylammonium fluorides ate the most effective Thuf, fluoro alkyl halides and N (fluoroalkyl)amines are efficiently synthesized by treatment of the corresponding trifluoromethanesulfonic esters with tetrabutylammonium fluoride trihydrate in aprotic solvents [5fl] (equation 34) The displacement reactions proceed quantitatively at room temperature within seconds, but tail with hydrogen fluoride-pyridine and give reasonable yields only with hydrogen fluo ride-alkylamine reagents... 

A/-Phenyl, 449 A/,A/ -Diisopropyl, 450 Phenyl Group, 450 Tetraalkylammonium salts, 451... 

In a rather nontraditional approach to acid protection, the tetraalkylammonium salts of amino acids allow for coupling of HOBt-activated amino acids in yields of 55-84%. ... 

In some cases only the first step is required, as with the formation of ethylam-monium nitrate. In many cases the desired cation is commercially available at reasonable cost, most commonly as a halide salt, thus requiring only the anion exchange reaction. Examples of these are the symmetrical tetraalkylammonium salts and trialkylsulfonium iodide. 

Table 3.1-3 Changes in melting points for symmetric tetraalkylammonium bromide salts with increasing size of alkyl substituents.

Table 3.1-4 Effects of cation symmetry on the melting points of isomeric tetraalkylammonium salts. In each case the cation (designated [N op] ) has four linear alkyl substituents, together containing a total of 20 carbons. Salts that are liquid at room temperature are indicated by /.

Table 3.5-1 lists the E-r values for the allcylammonium thiocyanates and nitrates and the substituted imidazolium salts. It can be seen that the values are dominated by the nature of the cation. For instance, values for monoallcylammonium nitrates and thiocyanates are ca. 0.95-1.01, whereas the two tetraalkylammonium salts have values of ca. 0.42-0.46. The substituted imidazolium salts lie between these two extremes, with those with a proton at the 2-position of the ring having higher values than those with this position methylated. This is entirely consistent with the expected hydrogen bond donor properties of these cations. 

Here, the relative stability of the anion radical confers to the cleavage process a special character. Thus, at a mercury cathode and in organic solvents in the presence of tetraalkylammonium salts, the mechanism is expected16 to be an ECE one in protic media or in the presence of an efficient proton donor, but of EEC type in aprotic solvents. In such a case, simple electron-transfer reactions 9 and 10 have to be associated chemical reactions and other electron transfers (at the level of the first step). Those reactions are shown below in detail ... 

---