Sulfonamides, alkyl

Primary amines. After N-alkoxycarbonylation (Boc, Cbz, etc.) of the sulfonamide, alkylation at the nitrogen atom and treatment with a thiolate anion complete the preparation of a protected primary amine. 

Urea derivadves are of general interest in medicinal chemistry. They may be obtained cither from urea itself (barbiturates, sec p. 306) or from amines and isocyanates. The latter are usually prepared from amines and phosgene under evolution of hydrogen chloride. Alkyl isocyanates are highly reactive in nucleophilic addidon reactions. Even amides, e.g. sulfonamides, are nucleophilic enough to produce urea derivatives. 

Aluminum chloride [7446-70-0] is a useful catalyst in the reaction of aromatic amines with ethyleneknine (76). SoHd catalysts promote the reaction of ethyleneknine with ammonia in the gas phase to give ethylenediamine (77). Not only ammonia and amines, but also hydrazine [302-01-2] (78), hydrazoic acid [7782-79-8] (79—82), alkyl azidoformates (83), and acid amides, eg, sulfonamides (84) or 2,4-dioxopyrimidines (85), have been used as ring-opening reagents for ethyleneknine with nitrogen being the nucleophilic center (1). The 2-oxopiperazine skeleton has been synthesized from a-amino acid esters and ethyleneknine (86—89). 

Commercially important arenesulfonyl isocyanates are not directly accessible from the corresponding sulfonamides via phosgenation due to lack of reactivity or by-product formation at elevated temperatures. A convenient method for their preparation consists of the reaction of alkyl isocyanates with sulfonamides to produce mixed ureas which, upon phosgenation, yield a mixture of alkyl and arenesulfonyl isocyanates. The desired product can be obtained by simple distillation (16). Optionally, the oxalyl chloride route has been employed for the synthesis of arenesulfonyl isocyanate (87). 

Incorporation of less than a stoichiometric amount of alkyl sulfonamides of copper phthalocyanines into copper phthalocyanine improves the pigment s properties in rotogravure inks (67). Monomeric and polymeric phthalocyanine derivatives with basic substituents adsorb strongly to the pigment surface and promote the adsorption of binder molecules (68—72). 

Developing agents must also be soluble in the aqueous alkaline processing solutions. Typically such solutions are maintained at about pH 10 by the presence of a carbonate buffer. Other buffers used include borate and, less frequendy, phosphate. Developer solubiUty can be enhanced by the presence of hydroxyl or sulfonamide groups, usually in the A/-alkyl substituent. The solubilization also serves to reduce developer allergenicity by reducing partitioning into the lipophilic phase of the skin (46). 

Sulfonamides (R2NSO2R ) are prepared from an amine and sulfonyl chloride in the presence of pyridine or aqueous base. The sulfonamide is one of the most stable nitrogen protective groups. Arylsulfonamides are stable to alkaline hydrolysis, and to catalytic reduction they are cleaved by Na/NH3, Na/butanol, sodium naphthalenide, or sodium anthracenide, and by refluxing in acid (48% HBr/cat. phenol). Sulfonamides of less basic amines such as pyrroles and indoles are much easier to cleave than are those of the more basic alkyl amines. In fact, sulfonamides of the less basic amines (pyrroles, indoles, and imidazoles) can be cleaved by basic hydrolysis, which is almost impossible for the alkyl amines. Because of the inherent differences between the aromatic — NH group and simple aliphatic amines, the protection of these compounds (pyrroles, indoles, and imidazoles) will be described in a separate section. One appealing proj>erty of sulfonamides is that the derivatives are more crystalline than amides or carbamates. 

Amides are stable compounds. The lower-melting members (such as acetamide) can be readily purified by fractional distillation. Most amides are solids which have low solubilities in water. They can be recrystallised from large quantities of water, ethanol, ethanol/ether, aqueous ethanol, chloroform/toluene, chloroform or acetic acid. The likely impurities are the parent acids or the alkyl esters from which they have been made. The former can be removed by thorough washing with aqueous ammonia followed by recrystallisation, whereas elimination of the latter is by trituration or recrystallisation from an organic solvent. Amides can be freed from solvent or water by drying below their melting points. These purifications can also be used for sulfonamides and acid hydrazides. 

Another point for structural diversification is the sulfonamide group. Imai had already shown that a wide variety of groups could be introduced at this position to optimize the reaction. Since a wide variety of sulfonyl chlorides are commercially available, a number of different types of groups could be examined (Scheme 3.34). Testing of a variety of aryl and alkyl groups on the 1,2-cyclohexanediamine backbone demonstrates that the simple methanesulfonamide 122 is clearly superior or equal to many other analogs in the cyclopropanation of cinnamyl alcohol (Table 3.11). Another concern which was directly addressed by this survey was the question of catalyst solubility. 

Alkylated sulfonamide groups have proven useful additions to the phenothiazine nucleus. The same seems to hold true in the thioxanthene series. Chlorosulfonation of the benzoic acid, 38, followed by displacement with dimethylamine affords the sulfonamide, 39. This is then taken on to the substituted thioxanthone (41) by the sequence of steps shown above Grignard condensation followed by dehydration gives thiothixine (42). 

The method illustrates the ability of the sodium hydride-dimethylformamide system to effect the alkylation of aromatic sulfonamides under mild conditions and in good yield. The method appears to be fairly general. The submitters have prepared N,N-diethyl- and N,N-di- -butyl- >-toluenesulfonamide as well as 2-(/ -tolyIsuIfonyl)benz[/]isoindoline from 2,3-bis-(bromomethyl)naphthalene, and 1 %-tolylsulfony])pyrrolidine from 1,4-dichIorobutane the yield of purified product exceeded 75% in each case. 

The initial studies of LSDAs were carried out with oleochemicals because of their structural similarity to soap. However, since the molecular structure of an efficient LSDA is characterized by a bulky hydrophilic polar head attached to a long hydrophobic tail, it is also possible to prepare LSDAs from petrochemicals. Sulfated sulfonamide derivatives of alkylbenzenes, such as commercially available detergent alkylates, were synthesized as follows [17] ... 

The sulfated alkylbenzenesulfonamides (no. 7-8) and alkylaroylsulfo-propionates (no. 9) were found to be efficient lime soap dispersants [27]. Although the nonionics (nos. 10-11) had low LSDR values they did not potentiate the detergency of soap and exhibited some antagonism. Amphoteric surfactants with alkyl side chains from C12 to C18 (nos. 12-13) possessed the lowest LSDR values, ranging from 2 to 4. The amine oxide derived from an aromatic sulfonamide had a low LSDR of 5 close to that of amphoterics. 

O-Alkyl-7 und O-Aryl-hydroxylamine8 lassen sich mit Lithiumalanat in die Komponenten spalten bzw. re-duktivumlagern , O-Acyl-10bzw. N-Sulfonyl-hydroxylamine11 imerstenSchritt zum Hydroxylamin und Al-kohol bzw. Sulfonamid reduzieren. 

Amides are very weak nucleophiles, far too weak to attack alkyl halides, so they must first be converted to their conjugate bases. By this method, unsubstituted amides can be converted to N-substituted, or N-substituted to N,N-disubstituted, amides. Esters of sulfuric or sulfonic acids can also be substrates. Tertiary substrates give elimination. O-Alkylation is at times a side reaction. Both amides and sulfonamides have been alkylated under phase-transfer conditions. Lactams can be alkylated using similar procedures. Ethyl pyroglutamate (5-carboethoxy 2-pyrrolidinone) and related lactams were converted to N-alkyl derivatives via treatment with NaH (short contact time) followed by addition of the halide. 2-Pyrrolidinone derivatives can be alkylated using a similar procedure. Lactams can be reductively alkylated using aldehydes under catalytic hydrogenation... 

Amides can also be alkylated with diazo compounds, as in 10-49. Salts of sulfonamides (ArS02NH ) can be used to attack alkyl halides to prepare N-alkyl sulfonamides (ArS02NHR) that can be further alkylated to ArS02NRR. Hydrolysis of the latter is a good method for the preparation of secondary amines. Secondary amines can also be made by crown ether assisted alkylation of F3CCONHR (R = alkyl or aryl) and hydrolysis of the resulting F3CCONRR. ... 

Trialkylboranes react rapidly and in high yields with a-halo ketones,a-halo esters, a-halo nitriles, and a-halo sulfonyl derivatives (sulfones, sulfonic esters, sulfonamides) in the presence of a base to give, respectively, alkylated ketones, esters, nitriles, and sulfonyl derivatives. Potassium tert-butoxide is often a suitable base, but potassium 2,6-di-tert-butylphenoxide at 0°C in THF gives better results in most cases, possibly because the large bulk of the two tert-buXy groups prevents the base from coordinating with the R3B. The trialkylboranes are prepared by treatment of 3 mol of an alkene with 1 mol of BH3 (15-16). With appropriate boranes, the R group transferred to a-halo ketones, nitriles, and esters can be vinylic, or (for a-halo ketones and esters) aryl. " °... 

Sulfonic esters are most frequently prepared by treatment of the corresponding halides with alcohols in the presence of a base. The method is much used for the conversion of alcohols to tosylates, brosylates, and similar sulfonic esters. Both R and R may be alkyl or aryl. The base is often pyridine, which functions as a nucleophilic catalyst, as in the similar alcoholysis of carboxylic acyl halides (10-21). Primary alcohols react the most rapidly, and it is often possible to sulfonate selectively a primary OH group in a molecule that also contains secondary or tertiary OH groups. The reaction with sulfonamides has been much less frequently used and is limited to N,N-disubstituted sulfonamides that is, R" may not be hydrogen. However, within these limits it is a useful reaction. The nucleophile in this case is actually R 0 . However, R" may be hydrogen (as well as alkyl) if the nucleophile is a phenol, so that the product is RS020Ar. Acidic catalysts are used in this case. Sulfonic acids have been converted directly to sulfonates by treatment with triethyl or trimethyl orthoformate HC(OR)3, without catalyst or solvent and with a trialkyl phosphite P(OR)3. ... 

The treatment of sulfonyl chlorides with ammonia or amines is the usual way of preparing sulfonamides. Primary amines give N-alkyl sulfonamides, and secondary amines give N,N-dialkyl sulfonamides. The reaction is the basis of the Hinsberg test for distinguishing between primary, secondary, and tertiary amines. N-Alkyl sulfonamides, having an acidic hydrogen, are soluble in alkali, while N,N-dialkyl sulfon-... 

Treatment with sodium hypochlorite or hypobromite converts primary amines into N-halo- or N,N-dihaloamines. Secondary amines can be converted to N-halo secondary amines. Similar reactions can be carried out on unsubstituted and N-substituted amides and on sulfonamides. With unsubstituted amides the N-halo-gen product is seldom isolated but usually rearranges (see 18-13) however, N-halo-N-alkyl amides and N-halo imides are quite stable. The important reagent NBS is made in this manner. N-Halogenation has also been accomplished with other reagents, (e.g., sodium bromite NaBr02) benzyltrimethylammonium tribromide (PhCH2NMe3 Br3"), and NCS. The mechanisms of these reactions involve attack by a positive halogen and are probably similar to those of 12-47 and 12-49.N-Fluorination can be accomplished by direct treatment of amines °° or... 

Mg or Ca in MeOH, " baker s yeast, Sm/l2, LiMe2NBH3, and tin complexes prepared from SnCl2 or Sn(SR)2. This reaction, combined with RX —+ RN3 (10-65), is an important way of converting alkyl halides RX to primary amines RNH2 in some cases the two procedures have been combined into one laboratory step. Sulfonyl azides (RSO2N3) have been reduced to sulfonamides (RSO2NH2) by irradiation in isopropyl alcohol and with NaH. ... 

---