Substitutions Iodination

Radical substitution reactions by iodine are not practical because the abstraction of hydrogen from hydrocarbons by iodine is endothermic, even for stable radicals. The enthalpy of the overall reaction is also slightly endothermic. Thus, because of both the kinetic problem excluding a chain reaction and an unfavorable equilibrium constant for substitution, iodination cannot proceed by a radical-chain mechanism. 

Sensitivity for fluorine-substituted < chlorine-substituted < broaine-substituted < iodine-substituted coapounds... 

Repeat, substituting iodine for bromine, and note that the deep violet color, which the free iodine imparts to the globule of carbon disulphide, is likewise bleached on shaking the globule with chlorine water. 

The rotational isomers exist in cis and trans, anti and syn, or endo and exo forms. The cis and trans forms arise from slow rotation of the side-chain carbonyl groups, hindered by adjacent ortho-substituted iodine atoms in the ring, resulting in the two carbonyl groups aligned either parallel or antiparallel to each other (268,269). The anti and syn forms refer to the position of N-methyl or N-alkyl group relative to that of adjacent carbonyl oxygen (266). The endo and exo forms refer to the po-... 

Electrophilic Substitution Iodine labeling can be obtained by using molecular iodine and oxidation reagents, such as peracetic acid, imides and amides, which increase the electrophilic reactivity of the halogen toward aromatic compounds. 

If you have to iodize a peptide that can withstand pH 3 and 100° C, you can iodize it first with iodine. After separating out the free iodine, you substitute iodine for the iodine you incorporated into the peptide (Breslav et al. 1996). The advantage The products of the iodination (see Section 2.1.4) can comfortably be separated on the (cold) reversed-phase HPLC and then examined for their biological activity. For the active iodine derivative, you then switch the iodine with Todine. You can also skip the iodination reaction and instead synthesize the peptide with suitable iodine amino acid at the desired site (peptide synthesizer). 

The most widely used reactions are those of electrophilic substitution, and under controlled conditions a maximum of three substituting groups, e.g. -NO2 (in the 1,3,5 positions) can be introduced by a nitric acid/sul-phuric acid mixture. Hot cone, sulphuric acid gives sulphonalion whilst halogens and a Lewis acid catalyst allow, e.g., chlorination or brom-ination. Other methods are required for introducing fluorine and iodine atoms. Benzene undergoes the Friedel-Crafts reaction. ... 

If cold benzene is treated with bromine in the absence of sunlight, very little reaction occurs if, however, a halogen carrier, such as iron, iodine, pyridine, etc., is also present, a rapid reaction by substitution occurs, forming first... 

The iodine atom in iodobenzene (unlike that in the corresponding aliphatic compounds) is very resistant to the action of alkalis, potassium cyanide, silver nitrite, etc. This firm attachment of the iodine atom to the benzene ring is typical of aromatic halides generally, although in suitably substituted nitio-compounds, such as chloro-2,4-dinitrobenzene, the halogen atom does possess an increased reactivity (p. 262). 

The heats of formation of Tt-complexes are small thus, — A//2soc for complexes of benzene and mesitylene with iodine in carbon tetrachloride are 5-5 and i2-o kj mol , respectively. Although substituent effects which increase the rates of electrophilic substitutions also increase the stabilities of the 7r-complexes, these effects are very much weaker in the latter circumstances than in the former the heats of formation just quoted should be compared with the relative rates of chlorination and bromination of benzene and mesitylene (i 3 o6 x 10 and i a-Sq x 10 , respectively, in acetic acid at 25 °C). 

The majority of preparative methods which have been used for obtaining cyclopropane derivatives involve carbene addition to an olefmic bond, if acetylenes are used in the reaction, cyclopropenes are obtained. Heteroatom-substituted or vinyl cydopropanes come from alkenyl bromides or enol acetates (A. de Meijere, 1979 E. J. Corey, 1975 B E. Wenkert, 1970 A). The carbenes needed for cyclopropane syntheses can be obtained in situ by a-elimination of hydrogen halides with strong bases (R. Kdstcr, 1971 E.J. Corey, 1975 B), by copper catalyzed decomposition of diazo compounds (E. Wenkert, 1970 A S.D. Burke, 1979 N.J. Turro, 1966), or by reductive elimination of iodine from gem-diiodides (J. Nishimura, 1969 D. Wen-disch, 1971 J.M. Denis, 1972 H.E. Simmons, 1973 C. Girard, 1974),... 

Oxidative dimerization of various 2-benzyloxy-2-thiazoline-5-ones (222) catalyzed by iodine and triethylamine is another example of the nucleophilic reactivity of the C-4 atom (469) (Scheme 112). Treatment of 212 with pyrrolidinocyclohexene yields the amide (223) (Scheme 113). The mechanism given for the formation of 223 is proposed by analogy with the reactivitx of oxazolones with enamines (4701. 4-Substituted 2-phenylthiazol-5(4Hi-ones react with A -morphoiino-l-cyclohexene in a similar manner (562j. Recently. Barret and Walker have studied the Michael addition products... 

The order of alkyl halide reactivity in nucleophilic substitutions is the same as their order m eliminations Iodine has the weakest bond to carbon and iodide is the best leaving group Alkyl iodides are several times more reactive than alkyl bromides and from 50 to 100 times more reactive than alkyl chlorides Fluorine has the strongest bond to car bon and fluonde is the poorest leaving group Alkyl fluorides are rarely used as sub states m nucleophilic substitution because they are several thousand times less reactive than alkyl chlorides... 

Iodine is only slightly soluble in water and no hydrates form upon dissolution. The solubiHty increases with temperature, as shown in Table 2 (36). Iodine is soluble in aqueous iodide solutions owing to the formation of polyiodide ions. For example, an equiHbrium solution of soHd iodine and KI H2O at 25°C is highly concentrated and contains 67.8% iodine, 25.6% potassium iodide, and 6.6% water. However, if large cations such as cesium, substituted ammonium, and iodonium are present, the increased solubiHty may be limited, owing to precipitation of sparingly soluble polyiodides. Iodine is also more... 

Direct iodination or fluorination leads to ill-defined products and fragmentation, respectively. Sandmeyer chemistry and nucleophilic substitution of... 

The steric bulk of the three iodine atoms in the 2,4,6-triiodoben2ene system and the amide nature of the 1,3,5-substituents yield rotational isomers of the 5-A/-acyl-substituted 2,4,6-triiodoisophthalamides. Rotational motion in the bonds connecting the side chains and the aromatic ring is restricted. These compounds also exhibit stereoisomerism when chiral carbon atoms are present on side chains. (R,5)-3-Amino-l,2-propanediol is incorporated in the synthesis of iohexol (11) and ioversol (12) and an (3)-2-hydroxypropanoyl group is used in the synthesis of iopamidol (10). Consequendy, the resulting products contain a mixture of stereoisomers, ie, meso-isomers, or an optical isomer. 

Nitration of > -hydroxyben2oic acid with filming nitric acid in the presence of sulfuric acid and acetic anhydride gives a mixture of the 2-nitro [602-00-6] and 4-nitro [619-14-7] substitution products. Bromination and iodination yield the 4-halogenated derivatives (4-bromo [14348-38-0] and 4-iodo [58123-77-6]). When > -hydroxyben2oic acid is treated with formalin in the presence of hydrochloric acid, 4-hydroxyphthahde [13161 -32-5] is obtained as shown in equation (10). 

Nucleophilic aromatic substitutions involving loss of hydrogen are known. The reaction usually occurs with oxidation of the intermediate either intramoleculady or by an added oxidizing agent such as air or iodine. A noteworthy example is the formation of 6-methoxy-2-nitrobenzonitrile from reaction of 1,3-dinitrobenzene with a methanol solution of potassium cyanide. In this reaction it appears that the nitro compound itself functions as the oxidizing agent (10). 

Addition to the Double Bond. Chlorine, bromine, and iodine react with aHyl chloride at temperatures below the inception of the substitution reaction to produce the 1,2,3-trihaLides. High temperature halogenation by a free-radical mechanism leads to unsaturated dihalides CH2=CHCHC1X. Hypochlorous and hypobromous acids add to form glycerol dihalohydrins, principally the 2,3-dihalo isomer. Dehydrohalogenation with alkah to epicbl orobydrin [106-89-8] is ofgreat industrial importance. 

The determination of iodine value (IV), AOCS Tg 1-64, is sometimes used to determine the extent of unsaturation. Because the tertiary aUyflc hydrogen ia the compounds is capable of substitution by halogen atoms, this only approximates a value for the degree of unsaturation. 

Pyridazines form complexes with iodine, iodine monochloride, bromine, nickel(II) ethyl xanthate, iron carbonyls, iron carbonyl and triphenylphosphine, boron trihalides, silver salts, mercury(I) salts, iridium and ruthenium salts, chromium carbonyl and transition metals, and pentammine complexes of osmium(II) and osmium(III) (79ACS(A)125). Pyridazine N- oxide and its methyl and phenyl substituted derivatives form copper complexes (78TL1979). 

Halogens react with benzo[6]furan by an addition-elimination mechanism to give 2- and 3-substituted products (76JCS(P2)266). Treatment of benzo[6]thiophene with chlorine or bromine in acetic acid gives predominantly 3-substituted products (71JCS(B)79). 2,2,3,3,4,5,6,7-Octachloro-2,3-dihydrobenzothiophene is obtained when benzo[6]thio-phene is treated with chlorine in the presence of 1 mole of iodine (80JOC2l5l). 

---