Steric effects rate constants

The amino group activates the thiazole ring toward electrophilic centers. This point is illustrated by the rate constants of the reaction between 2-dialkylaminothiazoles (32) and methyl iodide in nitromethane at 25 C (Scheme 23) (158). The steric effects of substituents on nitrogen are... 

If the rate constants for quaternization of 2-alkylthiazoles depended on electronic factors, they would all be greater than that of thiazole, which has the low est pK. and all of the same order. The decrease in rate constants that is observed is attributed wholly to steric effects. In Table III-50 we report the main parameters for the reaction of 2-alkylthiazoles with methyl iodide. 

Taft began the LFER attack on steric effects as part of his separation of electronic and steric effects in aliphatic compounds, which is discussed in Section 7.3. For our present purposes we abstract from that treatment the portion relevant to aromatic substrates. Hammett p values for alkaline ester hydrolysis are in the range +2.2 to +2.8, whereas for acid ester hydrolysis p is close to zero (see Table 7-2). Taft, therefore, concluded that electronic effects of substituents are much greater in the alkaline than in the acid series and. in fact, that they are negligible in the acid series. This left the steric effect alone controlling relative reactivity in the acid series. A steric substituent constant was defined [by analogy with the definition of cr in Eq. (7-22)] by Eq. (7-43), where k is the rate constant for acid-catalyzed hydrolysis of an orr/to-substituted benzoate ester and k is the corresponding rate constant for the on/to-methyl ester note that CH3, not H, is the reference substituent. ... 

If the assumptions underlying the Taft treatment of the separation of electronic and steric effects are valid, then the relative rates of acid-catalyzed reactions of esters should be a measure of the steric effect. Taft " accordingly defined a steric constant Es by Eq. (7-52). 

Some authors use O] instead of cr as the substituent constant in such correlations.) An example is provided by the aminolysis of phenyl esters in dioxane the substrates RCOOPh were reacted with -butylamine, and the observed first-order rate constants were related to amine concentration by = k2 [amine] kj [amine]. The rate constants kz and k could be correlated by means of Eq. (7-54), the reaction constants being p = +2.14, b = + 1.03 (for A 2) and p = -1-3.03,8 = -1-1.08 (for ks). Thus, the two reactions are about equally sensitive to steric effects, whereas the amine-catalyzed reaction is more susceptible to electronic effects than is the uncatalyzed reaction. 

A very interesting steric effect is shown by the data in Table 7-12 on the rate of acid-catalyzed esterification of aliphatic carboxylic acids. The dissociation constants of these acids are all of the order 1(T, the small variations presumably being caused by minor differences in polar effects. The variations in esterification rates for these acids are quite large, however, so that polar effects are not responsible. Steric effects are, therefore, implicated indeed, this argument and these data were used to obtain the Es steric constants. Newman has drawn attention to the conformational role of the acyl group in limiting access to the carboxyl carbon. He represents maximum steric hindrance to attack as arising from a coiled conformation, shown for M-butyric acid in 5. 

Hydrolysis of an enamine yields a carbonyl compound and a secondary amine. Only a few rate constants are mentioned in the literature. The rate of hydrolysis of l-(jS-styryl)piperidine and l-(l-hexenyl)piperidine have been determined in 95% ethanol at 20°C 13). The values for the first-order rate constants are 4 x 10 sec and approximately 10 sec , respectively. Apart from steric effects the difference in rate may be interpreted in terms of resonance stabilization by the phenyl group on the vinyl amine structure, thus lowering the nucleophilic reactivity of the /3-carbon atom of that enamine. 

The rate of saponification of ethyl 2-thenoate, in contrast to ethyl 3-thenoate, was found to be considerably slower than predicted from the pKa of the acid, showing that the reactivities of thiophenes do not parallel those of benzene. The first explanation, that this was produced by a steric effect of the ring sulfur similar to the case in or /lo-substituted benzenes and in ethyl 1-naphthoate, could not be upheld when the same effect was found in ethyl 2-furoate. It was later ascribed to a stereospecific acid strengthening factor, involving the proper relation of the carboxylic hydrogen and the heteroatom, as the rate of saponification of 2-thienylacrylic acid was in agreement with that predicted from the acid constants. ... 

The lack of steric effects in oxidations of hydrocarbons by Cr(VI) renders D and E unacceptable. The activated complex of scheme C is non-linear and hence does not comply with the magnitude of the observed isotope effect. Two pieces of evidence are quoted which indicate A to be the more probable of the remaining two. Firstly, the p constant of —1.17 is more in agreement with that obtained for bromine atom abstraction from toluenes (—1.369 to —1.806) than those found for solvolyses involving electron-deficient carbon ( — 2.57 to —4.67) . Secondly, the correlation between the relative rates of oxidation of the series... 

An unusually slow relaxation has been observed for the 2,6-pyridine-dicarboxaldimine cobalt(II) complex [Co(2,6-(CH3NH=CH)2py)2](PFg)2 in solution. Thus a relaxation time -c = 83 ns has been reported [99], the rate constants being among the lowest found. It has been suggested that nonelectronic factors such as partial ligand dissociation, steric effects or solvent interaction may be rate determining in this equilibrium. 

The Claisen-Schmidt condensation of 2 -hydroxyacetophenone and different chlorinated benzaldehydes over MgO has been investigated through kinetic and FTIR spectroscopic studies. The results indicate that the position of the chlorine atom on the aromatic ring of the benzaldehyde substantially affects the rate of this reaction. In particular, the rate increases in the following order p-chlorobenzaldehyde < m-chlorobenzaldehyde < o-chlorobenzaldehyde. The difference between the meta and para-substituted benzaldehyde can be attributed to electronic effects due to the difference in the Hammett constants for these two positions. Steric effects were found to be responsible for the higher rate observed with the o-chlorobenzaldehyde. 

---