Steric effect parameters

From molecular mechanics calculations4 for steric effect parameters. 

TABLE 4. Steric effect parameters for common substituents"... 

V A steric effect parameter based on van der Waals radii that has been corrected... 

Some degree of relationship between steric effect parameters and volume parameters must be expected. Consider for example monatomic substituents. A single atom, X, may be considered sperical. Its volume is therefore given by the expression for the volume of a sphere. 

TABLE 2. Steric effect parameters used in applications3... 

Structural effects on germanium, tin and lead compounds TABLE 2. Steric effect parameters used in applications ... 

The equation does not take into account such pertubation factors as steric effects, solvent effects, and ion-pair formation. These factors, however, may be neglected when experiments are carried out in the same solvent at the same temperature and concentration for an homogeneous set of substrates. So, for a given ambident nucleophile the rate ratio kj/kj will depend on A and B, which vary with (a) the attacked electrophilic center, (b) the solvent, and (c) the counterpart cationic species of the anion. The important point in this kind of study is to change only one parameter at a time. This simple rule has not always been followed, and little systematic work has been done in this field (12) stiH widely open after the discovery of the role played by single electron transfer mechanism in ambident reactivity (1689). 

If the rate constants for quaternization of 2-alkylthiazoles depended on electronic factors, they would all be greater than that of thiazole, which has the low est pK. and all of the same order. The decrease in rate constants that is observed is attributed wholly to steric effects. In Table III-50 we report the main parameters for the reaction of 2-alkylthiazoles with methyl iodide. 

Equation 4 can be classified as S, , ie, substitution nucleophilic bimolecular (221). The rate of the reaction is influenced by several parameters basicity of the amine, steric effects, reactivity of the alkylating agent, and solvent polarity. The reaction is often carried out in a polar solvent, eg, isopropanol, which may increase the rate of reaction and make handling of the product easier. 

From the standpoint of geometrical considerations, the major difference is in the far greater steric requirements of the nitro group. This could result in either primary or secondary steric effects. Nevertheless, primary steric effects do not seem to be necessarily distinguishable by direct kinetic comparison. A classic example is the puzzling similarity of the activation parameters of 2-chloropyrimidine and 2,6-dinitrochlorobenzene (reaction with piperidine in ethanol), which has been described by Chapman and Rees as fortuitous. However, that nitro groups do cause (retarding) primary steric effects has been neatly shown at peri positions in the reaction with alkoxides (see Section IV,C, l,c). 

Upon formulating these relationships, phenols with branched alkyl substituents were not included in the data of a-cyclodextrin systems, though they were included in (3-cyclodextrin systems. In all the above equations, the n term was statistically significant at the 99.5 % level of confidence, indicating that the hydrophobic interaction plays a decisive role in the complexation of cyclodextrin with phenols. The Ibrnch term was statistically significant at the 99.5% level of confidence for (3-cyclo-dextrin complexes with m- and p-substituted phenols. The stability of the complexes increases with an increasing number of branches in substituents. This was ascribed to the attractive van der Waals interaction due to the close fitness of the branched substituents to the (3-cyclodextrin cavity. The steric effect of substituents was also observed for a-cyclodextrin complexes with p-substituted phenols (Eq. 22). In this case, the B parameter was used in place of Ibmch, since no phenol with a branched... 

Arrhenius parameters for nitration of 4-aikylphenyltrimethyiammonium ions in nitric acid-sulphuric acid mixtures (Table 12). It was argued that the observed Baker-Nathan order of alkyl substituent effect was, in fact, the result of a steric effect superimposed upon an inductive order. However, a number of assumptions were involved in this deduction, and these render the conclusion less reliable than one would like it would be useful to have the thermodynamic parameters for nitration of the methyl substituted compound in particular, in order to compare with the data for the /-butyl compound, though experimental difficulties may preclude this. It would not be surprising if a true Baker-Nathan order were observed because it is observed for all other electrophilic substitutions in this medium1. 

The D parameters are thought to account for adverse steric effects on complex formation, and possibly also inability of the ligand to transfer... 

It is not necessary to look very far to find aliphatic reactions that do not yield straight line plots with [10], however and, as with previous deviations from linearity (p. 375), these departures are commonly much more informative about the details of reaction pathways than are neat straight lines. Where such departures from linear (polar effects only) plots are observed, suggesting the operation of significant—and changing—steric effects, it is possible to incorporate a steric substituent parameter, Eg, whose evaluation is based on an earlier observation. 

---