Stereoselectivity/stereochemistry

Klunder A. J. H., Zhu J., Zwanenburg B. The Concept of Transient Chirality in the Stereoselective Synthesis of Fnnctionalized Cycloalkenes Applying the Retro-Diels-Alder Methodology Chem. Rev. (Washington, D. C.) 1999 99 1163-1190 Keywords stereochemistry, stereoselective synthesis, retro-Diels-Alder methodology... 

Stereospecificity of this reaction reaches 15 1 for telomer T3. Telomer T3 is a crystalline product, this allowed the authors to use X-ray diffraction analysis for studying stereochemistry. Stereoselectivity observed in the formation of T3 shows that both addition step and the step of halogen transfer to the growing radical proceed stereoselectively in this case. 

Note that the stereochemistry comes out right. H s a and b are cis because they were cis in the starting quinone and the Diels-Alder reaction is stereospecific in this respect. H is also cis to and H " because the Diels-Alder reaction is stereoselectively endo. These points are described in more detail in Norman p.284-6 and explained in Ian Fleming Frontier Orbitals and Organic Chemical Reactions, Wiley 1976, p. 106-109. How would you make diene A ... 

General problems with synthetic organic reactions are discussed together with some practical solutions for specific examples. These problems include 9 regio- and stereoselectivity by exploitation of the substrates stereochemistry (e.g., p. 20ff.) and differentiated nucleophilicity (p. 24f, 44f, 56ff.)... 

Stereoselectivities of 99% are also obtained by Mukaiyama type aldol reactions (cf. p. 58) of the titanium enolate of Masamune s chired a-silyloxy ketone with aldehydes. An excess of titanium reagent (s 2 mol) must be used to prevent interference by the lithium salt formed, when the titanium enolate is generated via the lithium enolate (C. Siegel, 1989). The mechanism and the stereochemistry are the same as with the boron enolate. 

The early Escherunoser-Stork results indicated, that stereoselective cyclizations may be achieved, if monocyclic olefins with 1,5-polyene side chains are used as substrates in acid treatment. This assumption has now been justified by many syntheses of polycyclic systems. A typical example synthesis is given with the last reaction. The cyclization of a trideca-3,7-dien-11-ynyl cyclopentenol leads in 70% yield to a 17-acetyl A-norsteroid with correct stereochemistry at all ring junctions. Ozonolysis of ring A and aldol condensation gave dl-progesterone (M.B. Gravestock, 1978 see p. 279f.). 

Cyclopentene derivatives with carboxylic acid side-chains can be stereoselectively hydroxy-lated by the iodolactonization procedure (E.J. Corey, 1969, 1970). To the trisubstituted cyclopentene described on p. 210 a large iodine cation is added stereoselectively to the less hindered -side of the 9,10 double bond. Lactone formation occurs on the intermediate iod-onium ion specifically at C-9ot. Later the iodine is reductively removed with tri-n-butyltin hydride. The cyclopentane ring now bears all oxygen and carbon substituents in the right stereochemistry, and the carbon chains can be built starting from the C-8 and C-12 substit""" ... 

Diacetoxylation of various conjugated dienes including cyclic dienes has been extensively studied. 1,3-Cyclohexadiene was converted into a mixture of isomeric l,4-diacetoxy-2-cyclohexenes of unknown stereochemistry[303]. The stereoselective Pd-catalyzed 1,4-diacetoxylation of dienes is carried out in AcOH in the presence of LiOAc and /or LiCI and beiizoquinone[304.305]. In the presence of acetate ion and in the absence of chloride ion, /rau.v-diacetox-ylation occurs, whereas addition of a catalytic amount of LiCl changes the stereochemistry to cis addition. The coordination of a chloride ion to Pd makes the cis migration of the acetate from Pd impossible. From 1,3-cyclohexadiene, trans- and ci j-l,4-diacetoxy-2-cyclohexenes (346 and 347) can be prepared stereoselectively. For the 6-substituted 1,3-cycloheptadiene 348, a high diaster-eoselectivity is observed. The stereoselective cij-diacetoxylation of 5-carbo-methoxy-1,3-cyclohexadiene (349) has been applied to the synthesis of dl-shikimic acid (350). 

The Pd-catalyzed hydrogenolysis of vinyloxiranes with formate affords homoallyl alcohols, rather than allylic alcohols regioselectively. The reaction is stereospecific and proceeds by inversion of the stereochemistry of the C—O bond[394,395]. The stereochemistry of the products is controlled by the geometry of the alkene group in vinyloxiranes. The stereoselective formation of stereoisomers of the syn hydroxy group in 630 and the ami in 632 from the ( )-epoxide 629 and the (Z)-epoxide 631 respectively is an example. 

The high degree of stereoselectivity observed with enzyme reactions provides further evidence as to the importance of dmg stereochemistry for pharmaceutical activity. 

An asymmetric synthesis of estrone begins with an asymmetric Michael addition of lithium enolate (178) to the scalemic sulfoxide (179). Direct treatment of the cmde Michael adduct with y /i7-chloroperbenzoic acid to oxidize the sulfoxide to a sulfone, followed by reductive removal of the bromine affords (180, X = a and PH R = H) in over 90% yield. Similarly to the conversion of (175) to (176), base-catalyzed epimerization of (180) produces an 85% isolated yield of (181, X = /5H R = H). C8 and C14 of (181) have the same relative and absolute stereochemistry as that of the naturally occurring steroids. Methylation of (181) provides (182). A (CH2)2CuLi-induced reductive cleavage of sulfone (182) followed by stereoselective alkylation of the resultant enolate with an allyl bromide yields (183). Ozonolysis of (183) produces (184) (wherein the aldehydric oxygen is by isopropyUdene) in 68% yield. Compound (184) is the optically active form of Ziegler s intermediate (176), and is converted to (+)-estrone in 6.3% overall yield and >95% enantiomeric excess (200). 

The strategy of the catalyst development was to use a rhodium complex similar to those of the Wilkinson hydrogenation but containing bulky chiral ligands in an attempt to direct the stereochemistry of the catalytic reaction to favor the desired L isomer of the product (17). Active and stereoselective catalysts have been found and used in commercial practice, although there is now a more economical route to L-dopa than through hydrogenation of the prochiral precursor. 

Substituted 2-haloaziridines are also known to undergo a number of reactions without ring opening. For example, displacement of chlorine in (264) with various nucleophilic reagents has been found to occur with overall inversion of stereochemistry about the aziridine ring (65JA4538). The displacements followed first order kinetics and faster rates were noted for (264 R = Me) than for (264 R = H). The observed inversion was ascribed to either ion pairing and/or stereoselectivity. 

Electrophilic attack on the sulfur atom of thiiranes by alkyl halides does not give thiiranium salts but rather products derived from attack of the halide ion on the intermediate cyclic salt (B-81MI50602). Treatment of a s-2,3-dimethylthiirane with methyl iodide yields cis-2-butene by two possible mechanisms (Scheme 31). A stereoselective isomerization of alkenes is accomplished by conversion to a thiirane of opposite stereochemistry followed by desulfurization by methyl iodide (75TL2709). Treatment of thiiranes with alkyl chlorides and bromides gives 2-chloro- or 2-bromo-ethyl sulfides (Scheme 32). Intramolecular alkylation of the sulfur atom of a thiirane may occur if the geometry is favorable the intermediate sulfonium ions are unstable to nucleophilic attack and rearrangement may occur (Scheme 33). 

The formation of g-alkyl-a,g-unsaturated esters by reaction of lithium dialkylcuprates or Grignard reagents in the presence of copper(I) iodide, with g-phenylthio-, > g-acetoxy-g-chloro-, and g-phosphoryloxy-a,g-unsaturated esters has been reported. The principal advantage of the enol phosphate method is the ease and efficiency with which these compounds may be prepared from g-keto esters. A wide variety of cyclic and acyclic g-alkyl-a,g-unsaturated esters has been synthesized from the corresponding g-keto esters. However, the method is limited to primary dialkylcuprates. Acyclic g-keto esters afford (Zl-enol phosphates which undergo stereoselective substitution with lithium dialkylcuprates with predominant retention of stereochemistry (usually > 85-98i )). It is essential that the cuprate coupling reaction of the acyclic enol phosphates be carried out at lower temperatures (-47 to -9a°C) to achieve high stereoselectivity. When combined with they-... 

The addition of methylmagnesium iodide to 2-phenylpropanal is stereoselective in producing twice as much syn-3-phenyl-2-butanol as the anti isomer (entry 5). The stereoselective formation of a particular configuration at a new stereogenic center in a reaction of a chiral reactant is called asymmetric induction. This particular case is one in which the stereochemistry can be predicted on the basis of an empirical correlation called Cram s rule. The structural and mechanistic basis of Cramls rule will be discussed in Chapter 3. 

A very important relationship between stereochemistry and reactivity arises in the case of reaction at an 5 carbon adjacent to a chiral center. Using nucleophilic addition to the carbonyl group as an example, it can be seen that two diastereomeric products are possible. The stereoselectivity and predictability of such reactions are important in controlling stereochemistry in synthesis. 

The preferred stereochemistry of addition to cyclic alkenes is anti The additions are not as highly stereoselective as hydrogen bromide addition, however. 

In summary, modem synthetic methodology allows the stereoselective generation of one, two, or even more stereocenters in a single reaction with or without spatial control by the substrate. The application of transforms to retrosynthetic simplification of stereochemistry requires the selection of transforms on the basis of both structural and stereochemical information in the target and also validation of the corresponding synthetic processes by analysis for both chemical feasibility and stereoselectivity. 

Stereoselective epoxidation can be realized through either substrate-controlled (e.g. 35 —> 36) or reagent-controlled approaches. A classic example is the epoxidation of 4-t-butylcyclohexanone. When sulfonium ylide 2 was utilized, the more reactive ylide irreversibly attacked the carbonyl from the axial direction to offer predominantly epoxide 37. When the less reactive sulfoxonium ylide 1 was used, the nucleophilic addition to the carbonyl was reversible, giving rise to the thermodynamically more stable, equatorially coupled betaine, which subsequently eliminated to deliver epoxide 38. Thus, stereoselective epoxidation was achieved from different mechanistic pathways taken by different sulfur ylides. In another case, reaction of aldehyde 38 with sulfonium ylide 2 only gave moderate stereoselectivity (41 40 = 1.5/1), whereas employment of sulfoxonium ylide 1 led to a ratio of 41 40 = 13/1. The best stereoselectivity was accomplished using aminosulfoxonium ylide 25, leading to a ratio of 41 40 = 30/1. For ketone 42, a complete reversal of stereochemistry was observed when it was treated with sulfoxonium ylide 1 and sulfonium ylide 2, respectively. ... 

Perhydro derivatives of pyrido[l,2-7)][l,2]oxazines are frequently applied in the total synthesis of various alkaloids to control the stereochemistry, and pyrido[l,2-c][l,3]oxazines and [l,3]oxazino[3,4-u]quinolines were also used in the stereoselective syntheses of different alkaloids. Perhydropyrido[l,2-c][l,3]oxazines and their benzologs are formed form 2-(2-hydroxyethyl) piperidines and from their benzologs to justify the stereochemistry of 2-(2-hydroxyethyl) derivatives. Different optically active pipecolic acids can be prepared via 4-phenylperhydropyrido[2,l-c][l,4]oxazin-l-ones. 

---