Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Stamp pad ink

Stamp-Pad Inks. These inks are impregnated into a cloth or foam mbber pad and transferred by pressure to mbber type which is then stamped or impressed against the substrate. The inks must be completely nondrying in the pad and yet dry by rapid penetration into the paper. Since it is desirable that the total ink soak into the stock, dyes are used rather than pigments. The vehicles used are usually glycols. [Pg.253]

Stalactites, 15 29 Stalagmites, 15 29 Stalk fibers, 21 18 Stamp-pad inks, 14 328 Standard cell potential, 15 750 Standard deviation, 13 257, 20 699 Standard electrode potential selected ions, 7 799t... [Pg.880]

Products and Uses An additive for cosmetics (up to 5%), printing inks, wood stains, adhesives, tobacco, ballpoint pen inks, stamp pad inks, and synthetic waxes also for airplanes and runways. Extremely varied uses include as coolant, antifreeze, deicer, and moisturizer. [Pg.133]

Liquid PEGs, solid PEGs, or their solutions are often used in a variety of ink preparations, such as thixotropic inks for ballpoint pens, water-based stencil inks, steam-set printing inks, and stamp-pad inks. [Pg.490]

Hexanedione Methyi iactate SD aicohoi 1 SD aicohoi 3-A SD aicohoi 3-C SD aicohoi 23-A SD aicohoi 30 soivent, stamp pad inks Methoxydigiycoi soivent, starch ethers Ethyi ievuiinate soivent, stencii inks Methoxydigiycoi soivent, stencii pastes Butyi-(S)-iactate soivent, stencii sheets Ethyi-(S)-iactate soivent, steriiizing soiutions SD aicohoi 1 SD aicohoi 3-A SD aicohoi 3-C SD aicohoi 12-A SD aicohoi 13-A SD aicohoi 22 SD aicohoi 23-A SD aicohoi 30 SD aicohoi 32 SD aicohoi 37 SD aicohoi 38-B SD aicohoi 42 SD aicohoi 44 SD aicohoi 46 soivent, steroids... [Pg.5714]

Figure 14.12 Pattern transfer with a flat PDMS stamp. A flat stamp is inked with a patterned ink pad. The ink is then printed on the substrate. (Adapted from Reference 105.)... Figure 14.12 Pattern transfer with a flat PDMS stamp. A flat stamp is inked with a patterned ink pad. The ink is then printed on the substrate. (Adapted from Reference 105.)...
If a vacuum manifold is not available, membranes can be dried to prevent large dots, after they have been prewetted and soaked in high salt solutions and stamped with a rubber stamp and ink pad with an array of 5 mm circles. The dry membrane is placed on a plastic box without a cover so that only the edges of the box touch... [Pg.143]

Both compounds are used to make antifreeze and de-icing solutions for cars, airplanes, and boats to make polyester compounds and as solvents in the paint and plastics industries. Ethylene glycol is also an ingredient in photographic developing solutions, hydraulic brake fluids and in inks used in stamp pads, ballpoint pens, and print shops. [Pg.186]

Chem. Descrip. Tripropylene glycol n-butyl ether CAS 55934-93-5 EINECS/ELINCS 259-910-3 Uses Solvent for heavy-duty cleaners possible additive for floor wax strippers plasticizer in selected resin systems coupling agent and grease penetrant in oven cleaners solvent for inks in bail-point and felt tip pens, stamp pads solvent, coupling agent in cosmetics, toiletries textile printing pastes suitable for indoor decorative paints Features HAPs-free... [Pg.274]

CAS 111-77-3 EINECS/ELINCS 203-906-6 Uses Solvent for coatings incl. nongrain-raising wood stains, printing inks, dye pastes for textiles coalescing aid tor PVAc latex paints solvent in stamp pad and stencil inks diluent tor hydraulic brake fluids deicer in jet fuel deactivator in pesticides coalescent for floor polishes solvent in cosmetics... [Pg.299]

TLC and GC/MS can be used to determine the age of writing inks on questioned documents. Dating techniques that use TLC are based on analysis of ink dye components, while GC/MS can date inks based on detection, identification, and quantification of the residues of the vehicle solvents in ink hnes. Capabihty to date most ballpoint, porous tip, roller pen, stamp pad, and jet printer inks by analyzing the single ink entry, stamp impression, or printed test in question was shown by testing in the Division of Identification and Forensic Science, Israel Police Headquarters. [Pg.951]

Figure 2. (a) Setup of the drop on top experiment. The ink reservoir is formed by a drop ofliquid HDT to provide quasdinear diffusion, (b) Setup of a stamp for the mold experiment. The PDMS is cured inside a metal tube (mold), which provides an extended reservoir for an ink solution, (c) Principle of the inker pad experiment. The inker pad (ink source) of initial concentration Co provides true linear diffnsion and is kept in conformal contact with the stamp during the entire experiment. [Pg.568]

Stempel, m. stamp stamper, die, punch, pestle piston brand, mark pistil post, prop, -farbe, /. stamping ink. -kissen, n. stamp-(ing) pad, -marke, /. stamp. [Pg.427]

See other pages where Stamp pad ink is mentioned: [Pg.924]    [Pg.924]    [Pg.258]    [Pg.476]    [Pg.599]    [Pg.287]    [Pg.299]    [Pg.1005]    [Pg.523]    [Pg.590]    [Pg.5692]    [Pg.1054]    [Pg.245]    [Pg.2000]    [Pg.2404]    [Pg.924]    [Pg.924]    [Pg.258]    [Pg.476]    [Pg.599]    [Pg.287]    [Pg.299]    [Pg.1005]    [Pg.523]    [Pg.590]    [Pg.5692]    [Pg.1054]    [Pg.245]    [Pg.2000]    [Pg.2404]    [Pg.28]    [Pg.397]    [Pg.274]    [Pg.298]    [Pg.1191]    [Pg.2558]    [Pg.141]    [Pg.533]    [Pg.358]    [Pg.2205]    [Pg.762]    [Pg.451]    [Pg.300]    [Pg.73]    [Pg.113]    [Pg.301]    [Pg.318]    [Pg.323]   


SEARCH



PAD

Padding

Stamping

Stampings

Stamps

© 2024 chempedia.info