Smoothness coated surface

The melting point of this wax was 64° C, and it was found that excessive growth and rough coated surfaces were obtained when the bed temperature was held at 58° C. However, particles coated at bed temperatures of 54 and 50° C had uniform, smooth coated surfaces. 

Figure 9.10. An incident light can be either (a) reflected by a smooth coating surface or (b) scattered to all different directions by a surface with micro-roughness.

Surfactant-coated surfaces may also rearrange on contact with a liquid as shown by Israelachvili and co-workers [77]. This mechanism helps to explain hysteresis occurring on otherwise smooth and homogeneous surfaces. 

In the majority of cases maximum durability will be produced by a multicoat system comprising priming and finishing paints only. Other considerations, however, such as uniformity of colour and smoothness of surface, may make it desirable to introduce intermediate coats, e.g. putty, filler and undercoat. The appearance of the final film or of the final painted structure is of some importance, and a final colour coat, which may contribute very little resistance to corrosion, may be necessary. 

Processing. The process requires a monofilament carbon-fiber core which is heated resistively in a tubular glass reactor shown schematically in Fig. 19.1. PI A carbon monofilament is pre-coated with a 1 pm layer of pyrolytic graphite to insure a smooth deposition surface and a constant resistivity. 1 1 SiC is then deposited by the reaction of silane and a hydrocarbon. Other precursors such as SiCl4, and CH3SiCl3 are also being investigated. A fiber cross-section is shown in Fig. 19.2.P1... 

The surface forces apparatus (SEA) can measure the interaction forces between two surfaces through a liquid [10,11]. The SEA consists of two curved, molecularly smooth mica surfaces made from sheets with a thickness of a few micrometers. These sheets are glued to quartz cylindrical lenses ( 10-mm radius of curvature) and mounted with then-axes perpendicular to each other. The distance is measured by a Fabry-Perot optical technique using multiple beam interference fringes. The distance resolution is 1-2 A and the force sensitivity is about 10 nN. With the SEA many fundamental interactions between surfaces in aqueous solutions and nonaqueous liquids have been identified and quantified. These include the van der Waals and electrostatic double-layer forces, oscillatory forces, repulsive hydration forces, attractive hydrophobic forces, steric interactions involving polymeric systems, and capillary and adhesion forces. Although cleaved mica is the most commonly used substrate material in the SEA, it can also be coated with thin films of materials with different chemical and physical properties [12]. 

Can be used to remove only surface coatings, leaving a smooth processed surface. 

---