Size exclusion chromatography adsorption

Column Si. Size-exclusion chromatography columns are generally the largest column on a process scale. Separation is based strictly on diffusion rates of the molecules inside the gel particles. No proteins or other solutes are adsorbed or otherwise retained owing to adsorption, thus, significant dilution of the sample of volume can occur, particularly for small sample volumes. The volumetric capacity of this type of chromatography is determined by the concentration of the proteins for a given volume of the feed placed on the column. 

The total stationary-phase volume required to process a given feed stream is proportional to the inlet concentration and volume of the feed. For example, for a typical inlet concentration of protein of 10 g/L, in a 100 L volume of feed, a column volume of at least 100 L is needed for size-exclusion chromatography. In comparison, an ion-exchange column having an adsorption capacity of 50 g/L would only require 20 L of column volume for the same feed. 

In 1971, Hiatt et al. found that polyethylene oxide (PEO) of molecular weight about 100000 prevented the adsorption of rabies virus to porous glass with an average pore diameter of 1250 A. The support was modified by passage of one void volume of 0.4% solution of the polymer in water, followed by 5 or more volumes of distilled water or buffered salt solution. The virus was effectively purified from the admixtures of brain tissue fluid by means of size-exclusion chromatography on the modified glass column [28]. 

For multi-analyte and/or multi-matrix methods, it is not possible to validate a method for all combinations of analyte, concentration and type of sample matrix that may be encountered in subsequent use of the method. On the other hand, the standards EN1528 andEN 12393 consist of a range of old multi-residue methods. The working principles of these methods are accepted not only in Europe, but all over the world. Most often these methods are based on extractions with acetone, acetonitrile, ethyl acetate or n-hexane. Subsequent cleanup steps are based on solvent partition steps and size exclusion or adsorption chromatography on Florisil, silica gel or alumina. Each solvent and each cleanup step has been successfully applied to hundreds of pesticides and tested in countless method validation studies. The selectivity and sensitivity of GC combined with electron capture, nitrogen-phosphorus, flame photometric or mass spectrometric detectors for a large number of pesticides are acceptable. 

The stationary phase in gel permeation (also called size exclusion) chromatography contains cavities of a defined size distribution, called pores. Analytes larger than the pores are excluded from the pores and pass through the column more rapidly than smaller analytes. There may be secondary effects due to hydrophobic adsorption, ionic interaction, or other interactions between the stationary phase and analyte. Gel permeation and non-ideal interactions in gel permeation are described more fully in Chapter 6. 

Although the overwhelming majority of theoretical papers in liquid chromatography are dealing with the various aspects of RP-HPLC separation, theoretical advances have also been achieved in some other separation modes. Thus, a theoretical study on the relation between the kinetic and equilibrium quantities in size-exclusion chromatography has been published, hi adsorption chromatography the probability of adsorbing an analyte molecule in the mobile phase exactly r-times is described by... 

A variety of procedures were utilized to analyze this reaction mixture and to characterize a,10-diaminopolystyrene. Thin layer chromatographic analysis using toluene as eluent exhibited three spots with Rf values of 0.85, 0.09, and 0.05 which corresponded to polystyrene, poly(styryl)amine and a,w-diaminopolystyrene (see Figure 1). Pure samples of each of these products were obtained by silica gel column Chromatography of the crude reaction mixture initially using toluene as eluent [for polystyrene and poly(styryl)amine] followed by a methanol/toluene mixture (5/100 v/v) for the diamine. Size-exclusion chromatography could not be used to characterize the diamine since no peak was observed for this material, apparently because of the complication of physical adsorption to the column packing material. Therefore, the dibenzoyl derivative (eq. 5) was prepared and used for most of the analytical characterizations. 

There are four different mechanisms of separation utilized in HPLC adsorption, partition, ion-exchange, and size exclusion chromatography. 

Eor means of determination and quantification of the material porosity, different methods like mercury intrusion porosity, nitrogen gas adsorption, or inverse-size exclusion chromatography (ISEC) have been established and are nowadays routinely employed for that purpose. As an alternative to these well-known methods, a new approach based on near-infrared spectroscopy (NIR) for the characterization of monoliths is introduced in this chapter. 

Kilduff, J. E., T. Karanfil, Y. P. Chin, and W. J. Weber. 1996. Adsorption of natural organic polyelectrolytes by activated carbon A size-exclusion chromatography study. Environmental Science and Technology 30 1336. 

---