Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Silylenes alkenes

Thermolysis of l,l-diadamantyl-2,3-dialkylsilacyclopropanes generated diadamantylsilylene, which was then trapped with cis- and /ra/M-2-butene and -3-hexene. The complete stereospecificity of silacyclopropane decomposition and silylene-alkene addition suggests an intermediate silylene in a singlet ground state (Equations (43) and (44)) <91JA1281). [Pg.327]

The activation of silylene complexes is induced both photochemically or by addition of a base, e.g. pyridine. A similar base-induced cleavage is known from the chemistry of carbene complexes however, in this case the carbenes so formed dimerize to give alkenes. Finally, a silylene cleavage can also be achieved thermally. Melting of the compounds 4-7 in high vacuum yields the dimeric complexes 48-51 with loss of HMPA. The dimers, on the other hand, can be transformed into polysilanes and iron carbonyl clusters above 120 °C. In all cases, the resulting polymers have been identified by spectroscopic methods. [Pg.27]

In 1971, a short communication was published [54] by Kumada and co-workers reporting the formation of di- and polysilanes from dihydrosilanes by the action of a platinum complex. Also the Wilkinson catalyst (Ph3P)3RhCl promotes hydrosilation. If no alkenes are present, formation of chain silanes occurs. A thorough analysis of the product distribution shows a high preference for polymers (without a catalyst, disproportionation reactions of the silanes prevail). Cross experiments indicate the formation of a silylene complex as intermediate and in solution, free silylenes could also be trapped by Et3SiH [55, 56],... [Pg.30]

The silacyclopropanation of acyclic and cyclic alkenes with 169, catalyzed by AgOTf, occur at room temperature or even below to yield new cyclosilapropanes 173-177. In the case of chiral /3-pinene, the silacyclopropanation occurs enantioselectively (dr > 95 5) (Scheme 26).312 Mechanistic studies have been undertaken, which suggest that silyl silver complexes play an important role in the catalytic cycle of the silylene transfer.310... [Pg.425]

Lewis base strengths of, 11 253 handling of, 11 250-284 Siliranes, from silylenes and alkenes, 29 12,... [Pg.275]

Though hexamethylsilirane is far too reactive to provide a convenient source of dimethyl-silylene, it is a useful precursor to other siliranes formed through alkene exchange. The insertion of styrenes into the silirane ring suggests that its thermal decomposition proceeds through a diradical intermediate (Scheme 11) (76JOM(ll7)C51). [Pg.578]

Further reactions of the silylene r-Bu2Sit produced by photolysis of hexa-r-butylcyclotrisilane with alkenes and cycloalkenes have recently been described213. [Pg.1304]

A key report investigated a variety of substrates in their reaction with silicon in an effort to find evidence for silylene intermediates during the silicon direct process reaction. When silicon, copper and methanol were reacted as described above but in the presence of alkenes, alkyldimethoxysilanes and (MeO SiH were formed95-97. The use of allyl propyl ether instead of alkenes gave allyldimethoxysilane, with 38% selectivity. These results and the reaction of silicon with MeCl in the presence of butadiene to give silacyclopent-3-enes indicates intermediate formation of silylenes. [Pg.1591]

Further cycloaddition reactions of silylenes generated by the photolysis of cyclotrisilanes have been published since Weidenbruch and coworkers summarized these reactions in an excellent review. Different siliranes were prepared by [2+1]-cycloaddition of di-t-butylsilylene to various alkenes and dienes (Scheme 6)46. Quite interesting results are obtained from the photolysis of hexa-i-butylcyclotrisilane in the presence of unsaturated five-membered ring compounds47 (Scheme 7). With cyclopentadiene and furane, [4 + 2]-cycloaddition of the photolytically generated disilene occurs only as a side reaction. Furthermore, [2 + 1]-cycloaddition of the intermediately formed silylene is highly favored and siliranes are primarily obtained. A totally different course is observed for the reaction in the presence of thiophene. The disilene abstracts the sulfur atom with the formation of the 1,2-disilathiirane as the major product with an extremely short Si—Si distance of 230.49 pm. [Pg.2185]

Siliranes are also formed by the reaction of the cyclotrisilane [2-(Me2NCH2)C6H4]6Si3 with terminal and strained internal olefins under mild thermal conditions. The products obtained from the thermolysis of the siliranes thus prepared suggest a thermal equilibrium of the silirane with the cyclotrisilane and the corresponding alkene. This observation provides evidence for an equilibrium between the silylene and the cyclotrisilane and, moreover, proves that free silylenes are involved in the silylene transfer reaction48. [Pg.2187]

Extrusion of a silylene from a silirane or silirene is of course the inverse of silylene addition to alkenes or alkynes, respectively. The reversibility of most silylene reactions allows the inverse of addition to 1,3-dienes to also be employed as a silylene source. The first such reaction was reported by Chernyshev and coworkers, who found that transfer of SiCl2 units from l,l-dichlorosilacyclopent-3-enes was a unimolecular process and hence was likely to consist of silylene extrusion and readdition (equation 38)82. Dimethylsilylene extrusion has been found in the pyrolysis of silacyclopentenes and other products of... [Pg.2479]

The above theoretical analysis for a variety of dimer structures of silylenes requires inevitably a definition of disilenes different from that of alkenes, molecules with carbon carbon double bonds. Geometry around a typical C=C double bond is planar and the double bond length (134 pm) is shorter than the corresponding single bond (154 pm). BDE of ethylene to two methylenes is ca. 170 kcal mol-1 which is 1.9 times larger than for the C C single bond (90 kcal mol-1 for H3C-CH3) the BDE of ethylene really almost doubles the BDE for ethane ... [Pg.96]

The experimental data demonstrate that in their transition metal chemistry silylenes 83-85 are able to replace carbonyl, tertiary phosphine or alkene ligands from a metal and it suggests that the silylene behaves as a strong cr-donor and a weak 7i-acceptor. Therefore, it behaves more like the isolobal PR3 ligand than CO. Differences in reactivity between the two silylenes 83 and 85 are due to the different steric requirements. The sterically more flexible ligand is silylene 85. [Pg.679]

The stable silylenes 83-85 do not react with conventional C=C double bonds however, diazasilole 83 is an efficient catalyst for the polymerization of alkenes, terminal alkynes, and 1,3-butadienes <2000ACR704, 2002USP028920, 2004JOM4165>. The stable bisaminosilylene 85 reacts with the activated double bond in 177-phosphirenes 134. The heterobicyclobutane 135 is however only a transient species and after addition of a second silylene 85 phosphasiletes 136 were isolated. Use of more sterically demanding substituted phosphirenes hampered the attack of the second silylene and the phosphasiletes 137 and 138, which are valence isomers of bicyclobutane 135, were obtained (Scheme 14) <2004AGE3474>. [Pg.684]

Silver compounds are versatile catalysts for various cycloaddition reactions, including [2 + 1]-, [2 + 2]-, [3 + 2]-, and [4 + 2]-cycloadditions. An example for the silver-catalyzed formation of three-membered rings by [2+ l]-cycloaddi-tion is the silacyclopropanation reaction of mono- and disubstituted alkenes by silylene transfer from the cyclohexene silacyclopropane 432 that was reported recently by Woerpel et /.355,355a (Scheme 127). The reaction tolerates a number of functionalities in the substrate (OBn, OSiR3, BuTlC, etc.,) and is stereospecific with regard to the cisjtrans... [Pg.564]

The photolysis of tris(trimethylsilyl)phenylsilane results in formation of trimethylsilylphenylsilylene in high yield, together with a small amount of a silicon-carbon double-bonded intermediate, which will be described in detail later. This silylene has a high reactivity toward unsaturated organic substrates such as alkenes and alkynes (44). [Pg.59]

The formation of isopropyldichlorosilane can be explained by the reaction of elemental silicon with, hydrogen chloride and isopropyl chloride formed by the hydrochlorination of propylene. As an alternative, it is possible that a silicon-carbon bond is formed by the reaction of a silylene intermediate, generated on the surface of silicon metal powders, with alkene... [Pg.173]


See other pages where Silylenes alkenes is mentioned: [Pg.12]    [Pg.12]    [Pg.844]    [Pg.539]    [Pg.564]    [Pg.653]    [Pg.158]    [Pg.655]    [Pg.677]    [Pg.167]    [Pg.577]    [Pg.578]    [Pg.579]    [Pg.582]    [Pg.27]    [Pg.29]    [Pg.34]    [Pg.844]    [Pg.237]    [Pg.171]    [Pg.1238]    [Pg.1283]    [Pg.2402]    [Pg.2477]    [Pg.2493]    [Pg.237]    [Pg.97]    [Pg.689]    [Pg.397]    [Pg.61]    [Pg.152]    [Pg.174]    [Pg.86]   
See also in sourсe #XX -- [ Pg.237 ]

See also in sourсe #XX -- [ Pg.237 ]

See also in sourсe #XX -- [ Pg.237 ]

See also in sourсe #XX -- [ Pg.97 , Pg.237 ]




SEARCH



Silylene

Silylenes

Silylenes silylene

Silylenes with alkenes

© 2024 chempedia.info