Silicon Oxycarbide Ceramic Composites

Fiber reinforced ceramic matrix composites (CMCs) are under active consideration for large, complex high temperature structural components in aerospace and automotive applications. The Blackglas resin system (a low cost polymer-derived ceramic [PDC] technology) was combined with the Nextel 312 ceramic fiber (with a boron nitride interface layer) to produce a sihcon oxycarbide CMC system that was extensively characterized for mechanical, thermal, and electronic properties and oxidation, creep mpture, and fatigue. A gas turbine tailcone was fabricated and showed excellent performance in a 1500-hour engine test. 

FIGURE 1. Pratt Whitney F-119 Tuibofan Engine with Exhaust Divertors (forthe F22 Raptor) 

But CMCs will be commercially successful only when they are produced cost-effectively. Polymer-derived ceramic (PDC) technology is one of the most promising low cost fabrication methods for ceramic matrix composites, particularly for large, complex shapes. In PDC technology, a silicon-based polymer (siloxane, carbosilane, silazane, etc) with fiber or particle reinforcement is shaped and cured in the polymer condition and then pyrolyzed in a controlled atmosphere to form a stable silicon-based ceramic, such as silicon carbide, sihcon nitride, silicon oxycarbide, or silicon oxynitride. 

This chapter will describe the processing and properties of an oxide fiber reinforced ceramic matrix composite with a silicon oxycarbide matrix based on a PDC technology, introduced by AlliedSignal (now Honeywell International) under the trademark of Blackglas ceramic. The oxide fiber in this CMC system is the Nextel 312 fiber (3M, Inc.) that has been treated to form a boron nitride surface coating. The information that follows was primarily developed from Low Cost Ceramic Matrix Composites (LC ) program funded by DARPA from 1991-1997. 

The Blackglas PDC system has a number of processing advantages compared to competitive PDC resins. The low viscosity (10 cp) Blackglas resin cures and handles like epoxy, is insensitive to moisture, and has a controllable cure cycle through catalyst content and temperature ramping. 

---

This work reports the development of a polymeric/sol-gel route for the deposition of silicon carbide and silicon oxycarbide thin films for applications such as heat-, corrosion-, and wear-resistant coatings, coatings on fibers for controlling the interaction with the matrix in ceramic matrix composites, or films in electronic and optoelectronic devices. This method, in which the pre-ceramic films are converted to a ceramic coating either by a conventional high temperature annealing or by ion irradiation, is alternative to conventional methods such as chemical or physical vapor deposition (CVD, PVD), molecular beam epitaxy, sputtering, plasma spray, or laser ablation, which are not always practical or cost efficient. 

---