Screws, processing injection molding

Fluoropolymers can be injection-molded in plunger or ram-type equipment but a screw machine works best with this family of plastics. The screw-type injection molding machines have a number of advantages including those listed in Table 6.23. Various components of screw-type machines for processing fluoropolymers are described in this section. 

An extruder. Fig. 17, has essentially the same structural components as the plasti-fication unit in a screw-type injection molding machine. Fig. 11. The screw in this case is not an axial plunger in the extruder it only rotates. The significance of extrusion per se is the continuity of the process. The method is used to produce plates, tubing, profiles, films, etc. 

Blends of polypropylene (PP) and liquid crystalline polymer (LCP) processed without melting the LCP were compared with conventional melt processed blends. In a first stage, PP was blended with 20 wt% of LCP in a twin-screw extruder with the take-up speed varied to achieve blends with different LCP fiber dimensions. In the second stage, these blends were processed both below and above the Tm of the LCP by extrusion and injection molding. 

The standard injection molding machine used had a screw diameter of 30 mm and the aspect ratio of 23.70. The barrel temperature profile was 270, 280, 290, and 295°C. The mold temperature was about 90°C. The injection molded tensile samples were processed according to the CAMPUS specification (Computer Aided Materials Preselection by Uniform Standards) [24] and DIN 53455 Form 3. To obtain the different flow conditions, four groups of samples were injection molded by varying melt... 

Plasticator A very important component in a melting process is the plasticator with its usual specialty designed screw and barrel used that is used in different machines (extruders, injection molding, blow molding, etc.). If the proper screw design is not used products may not meet or maximize their performance and meet their cost requirements. The hard steel shaft screws have helical flights, which rotates within a barrel to mechanically process and advance (pump) the plastic. There are general purposes and dedicated screws used. The type of screw used is dependent on the plastic material to be processed. 

Processing and Application. Polystyrene and the other thermoplastics would not have been able to enter on their triumphal march if the manufacturers of processing equipment had not been able to provide efficient fabrication methods. A decisive factor was that between 1950 and 1960 the injection molding machine with a screw preplasticizer was developed and extrusion through slit dies to give sheeting or film followed by thermoforming was evolved. 

The plasticator on an injection-molding machine is a specialized plasticating single-screw extruder. The plasticator has two main differences there is a nonreturn valve on the tip of the screw, and the screw retracts as molten material accumulates between the nonreturn valve and the end of the barrel. Pressure is maintained on the accumulated material by a constant force applied to the shank of the screw via the drive system. This force is typically measured as a pressure applied to the shank and is referred to as the back pressure. During the injection step of the process, the screw is forced forward, the nonreturn valve closes, and the material is injected into the mold. Additional information on the injection-molding process can be obtained elsewhere [Ij. 

---