Reactions vibrational spectroscopy

To identify the surface species generated with molecular adsorption and the species generated by surface reactions, vibrational spectroscopy provides the most definitive method. In principle, any technique that can be used to obtain vibrational data from solid state or gas phase samples can be applied to the study of surfaces. 

Vibrational Spectroscopy. Infrared absorption spectra may be obtained using convention IR or FTIR instrumentation the catalyst may be present as a compressed disk, allowing transmission spectroscopy. If the surface area is high, there can be enough chemisorbed species for their spectra to be recorded. This approach is widely used to follow actual catalyzed reactions see, for example. Refs. 26 (metal oxide catalysts) and 27 (zeolitic catalysts). Diffuse reflectance infrared reflection spectroscopy (DRIFT S) may be used on films [e.g.. Ref. 28—Si02 films on Mo(llO)]. Laser Raman spectroscopy (e.g.. Refs. 29, 30) and infrared emission spectroscopy may give greater detail [31]. 

Angeli s salt Na2N203 has been shown by vibration spectroscopy to contain the trioxodinitrate(II) anion structure (2). Its decomposition and reactions in aqueous solutions have been extensively studied by nmr spectroscopy and other techniques. 

Monomeric neutral SO4 can be obtained by reaction of SO3 and atomic oxygen photolysis of S03/ozone mixtures also yields monomeric SO4, which can be isolated by inert-gas matrix techniques at low temperatures (15-78 K). Vibration spectroscopy indicates either an open peroxo Cj structure or a closed peroxo C2v structure, the former being preferred by the most recent study, on the basis of agreement between observed and calculated frequencies and reasonable values for the force constants ... 

This last reaction is typical of many in which F3CIO can act as a Lewis base by fluoride ion donation to acceptors such as MF5 (M = P, As, Sb, Bi, V, Nb, Ta, Pt, U), M0F4O, Sip4, BF3, etc. These products are all white, stable, crystalline solids (except the canary yellow PtFe ) and contain the [F2CIO] cation (see Fig. 17.26h) which is isostructural with the isoelectronic F2SO. Chlorine trifluoride oxide can also act as a Lewis acid (fluoride ion acceptor) and is therefore to be considered as amphoteric (p. 225). For example KF, RbF and CsF yield M [F4C10] as white solids whose stabilities increase with increasing size of M+. Vibration spectroscopy establishes the C4 structure of the anion (Fig. 17.29g). 

If H2 80 is used in the reaction, the label can be followed. After the products are separated, vibrational spectroscopy or mass spectrometry can be used to determine whether the product has incorporated the l8(). If an O atom came from the water, the molar mass of the methanol produced would be 34 g-mol", not 32 g-mol. ... 

Methane-to-methanol conversion by gas-phase transition metal oxide cations has been extensively studied by experiment and theory see reviews by Schroder, Schwarz, and co-workers [18, 23, 134, 135] and by Metz [25, 136]. We have used photofragment spectroscopy to study the electronic spectroscopy of FeO" " [47, 137], NiO [25], and PtO [68], as well as the electronic and vibrational spectroscopy of intermediates of the FeO - - CH4 reaction. [45, 136] We have also used photoionization of FeO to characterize low lying, low spin electronic states of FeO [39]. Our results on the iron-containing molecules are presented in this section. 

J. Phys. Chem. B, 106, 5143-5154. Somorjai, G. A. and Rupprechter, G. (1999) Molecular studies of catalytic reactions on crystal surfaces at high pressures and high temperatures by infrared-visible sum frequency generation (SFG) surface vibrational spectroscopy. J. Phys. Chem., 103, 1623-1638. 

Remarkably, the photoelectron spectrum provides more than just the energy of the transition state. As can be seen in Figure 5.5, the spectrum also contains peaks corresponding to the transition state in excited vibrational levels, where the activated vibrations are orthogonal to the reaction coordinate. Therefore, NIPES can even be used to carry out vibrational spectroscopy of reaction transition states. 

Vibrational spectroscopy provides the most definitive means of identifying the surface species arising from molecular adsorption and the species generated by surface reaction, and the two techniques that are routinely used for vibrational studies of molecules on surfaces are Infrared (IR) Spectroscopy and Electron Energy Loss Spectroscopy (HREELS) (q.v.). 

Le Bourdon, G., Adar, F., Moreau, M. et al. (2003) In situ characterization by Raman and IR vibrational spectroscopies on a single instrument deNO, reaction over a Pd/y-Al203 catalyst, Phys. Chem. Chem. Phys., 5, 4441. 

Stoner-Ma D, Melief EH, Nappa J et al (2006) Proton relay reaction in green fluorescent protein (GFP) polarization-resolved ultrafast vibrational spectroscopy of isotopically edited GFP. J Phys Chem B 110 22009-22018... 

Cuf1101-HC00 The decomposition of formic acid on metal and oxide surfaces is a model heterogeneous reaction. Many studies have since shown that it proceeds via a surface formate species. Thus on Cu 110) adsorbed formic acid is found at low temperature. On heating to 270 K deprotonation occurs, giving rise to the surface formate, which in turn decomposes at 450 K with evolution of H2 and C02- In previous studies, particularly with vibrational spectroscopy, it had been demonstrated that the two C-0 bonds are equivalent and that the symmetry is probably C2v [19]. A NEXAFS study by Puschmann et al. [20] has subsequently shown that the molecular plane is oriented perpendicular to the surface and aligned in the <110> azimuth. 

The experiments using Sn adatoms are Intended to test for a correlation between the activity of these species as promoters for CO oxidation kinetics and their influence on the CO vibrational spectrum. Watanabe et. al. have proposed an "adatom oxidation" model for the catalytic activity of these adatoms (23). They propose that the function of the Sn adatoms is to catalyze the generation of adsorbed 0 or OH species at a lower potential than would be required on unpromoted Pt (23). The latter species then react with neighboring adsorbed CO molecules to accomplish the overall oxidation reaction. One implication of this proposed mechanism is that the adsorbed adatom is expected to have little, if any, direct interaction with the adsorbed CO reactant partner. Vibrational spectroscopy can be used to test for such an interaction. 

A long disputed issue of the nature of strongly bound species in this reaction has been recently revived with the vibrational spectroscopy studies of Bewick et al. (30) using EMIRS technique and of Kunimatsu and Kita (31) using polarization modulation IR-reflection-absorption technique. These data indicated the only CO is a strongly bound intermediate. Heitbaum et al. (32) on the other hand advocate COH, and most recently HCO (33), as the poisoning species on the basis of differential electrochemical mass spectroscopy (DEMS). 

Spectroscopic developments have accelerated advances in the field of catalysis. This volume analyzes the impact on catalyst structure and reactivity of EXAFS, SIMS, MSssbauer, magic-angle spinning NMR (MASNMR), and electron-energy-loss vibrational spectroscopy. Many of these techniques are combined with other analytical tools such as thermal decomposition and temperature-programmed reactions. 

---