Reaction rates times scales

Turbulence models are generally limited to fully developed high-Reynolds number flows. Gas-phase flows are normally characterized by 5c 1, while for liquid phase flows, 5c > 1. The value of this Damkohler number indicates the relative rates of the mixing and chemical reaction rate time scales. Reactive flows might thus be divided into three categories Slow chemistry (Da/ -C 1), fast chemistry (Da/ 1), and finite rate chemistry (Da/ 1). 

Since the complications due to solvent structure have already been discussed, the remainder of this chapter is mainly devoted to a discussion of the complications introduced into the theory of reaction rates when the collision of solvent molecules does not lead to a complete loss of memory of the molecules about their former velocity. Nevertheless, while such effects are undoubtedly important over some time scale, the differences noted by Kapral and co-workers [37, 285, 286] between the rate kernel for reaction estimated from the diffusion and reaction Green s function and their extended analysis were rather small over times of 10 ps or more (see Chap. 8, Sect. 3.3 and Fig. 40). At this stage, it is a moot point whether the correlation of solvent velocity before collision with that after collision has a significant and experimentally measurable effect on the rate of reaction. The time scale of the loss of velocity correlation is typically less than 1 ps, while even rapid recombination of radicals formed in close proximity to each other occurs over times of 10 ps or more (see Chap. 6, Sect. 3.3). 

The fact is that the reaction free energies are hardly ever determined experimentally, but are simply calculated from the Rehm-Weller equation which will be discussed in detail in the next section [26]. There are still considerable technical problems in direct experimental measurements, because standard methods of calorimetry cannot cope with reactions in time scales of ns or ps but this is slowly changing with the advent of fast calorimetric techniques such as time-resolved photoacoustic spectroscopy [27] and thermal lensing [28] these are considered in the following section. Nevertheless, it appears that all the data currently used in the rate constant-energy plots simply use the Rehm-Weller equation (sometimes with various corrections) and it is obviously important to consider the assumptions built into this equation, its limitations, and possible improvements. 

For very fast reactions, as they are accessible to investigation by pico- and femtosecond laser spectroscopy, the separation of time scales into slow motion along the reaction path and fast relaxation of other degrees of freedom in most cases is no longer possible and it is necessary to consider dynamical models, which are not the topic of this section. But often the temperature, solvent or pressure dependence of reaction rate... 

From stochastic molecnlar dynamics calcnlations on the same system, in the viscosity regime covered by the experiment, it appears that intra- and intennolecnlar energy flow occur on comparable time scales, which leads to the conclnsion that cyclohexane isomerization in liquid CS2 is an activated process [99]. Classical molecnlar dynamics calcnlations [104] also reprodnce the observed non-monotonic viscosity dependence of ic. Furthennore, they also yield a solvent contribntion to the free energy of activation for tlie isomerization reaction which in liquid CS, increases by abont 0.4 kJ moC when the solvent density is increased from 1.3 to 1.5 g cm T Tims the molecnlar dynamics calcnlations support the conclnsion that the high-pressure limit of this unimolecular reaction is not attained in liquid solntion at ambient pressure. It has to be remembered, though, that the analysis of the measnred isomerization rates depends critically on the estimated valne of... 

The method of molecular dynamics (MD), described earlier in this book, is a powerful approach for simulating the dynamics and predicting the rates of chemical reactions. In the MD approach most commonly used, the potential of interaction is specified between atoms participating in the reaction, and the time evolution of their positions is obtained by solving Hamilton s equations for the classical motions of the nuclei. Because MD simulations of etching reactions must include a significant number of atoms from the substrate as well as the gaseous etchant species, the calculations become computationally intensive, and the time scale of the simulation is limited to the... 

Fast transient studies are largely focused on elementary kinetic processes in atoms and molecules, i.e., on unimolecular and bimolecular reactions with first and second order kinetics, respectively (although confonnational heterogeneity in macromolecules may lead to the observation of more complicated unimolecular kinetics). Examples of fast thennally activated unimolecular processes include dissociation reactions in molecules as simple as diatomics, and isomerization and tautomerization reactions in polyatomic molecules. A very rough estimate of the minimum time scale required for an elementary unimolecular reaction may be obtained from the Arrhenius expression for the reaction rate constant, k = A. The quantity /cg T//i from transition state theory provides... 

In deciding whether to write an elementary reaction as either a reversible or an irreversible reaction, we take the practical view that if the reverse reaction is negligibly slow on the exp>erimental time scale, the reaction is essentially irreversible. Consider the alkaline hydrolysis of an ester, for which the rate equation is... 

If the PBR is less than unity, the oxide will be non-protective and oxidation will follow a linear rate law, governed by surface reaction kinetics. However, if the PBR is greater than unity, then a protective oxide scale may form and oxidation will follow a reaction rate law governed by the speed of transport of metal or environmental species through the scale. Then the degree of conversion of metal to oxide will be dependent upon the time for which the reaction is allowed to proceed. For a diffusion-controlled process, integration of Pick s First Law of Diffusion with respect to time yields the classic Tammann relationship commonly referred to as the Parabolic Rate Law ... 

In some circumstances, the reaction rates may not be exactly parabolic, and even initially parabolic rates may be influenced by changes within the oxide scale with time. As an oxide scale grows, the build-up of inherent growth stresses, externally applied strains and chemical changes to either oxide scale or metal may all compromise the initial protection offered by the scale, leading to scale breakdown and ultimately partial or complete loss of protection paralinear, or linear kinetics may ensue. In other circumstances, as will be seen later in this chapter, very small additions of contaminants to... 

Additional information on the rates of these (and other) coupled chemical reactions can be achieved by changing the scan rate (i.e., adjusting the experimental time scale). In particular, the scan rate controls the tune spent between the switching potential and the peak potential (during which the chemical reaction occurs). Hence, as illustrated in Figure 2-6, i is the ratio of the rate constant (of the chemical step) to die scan rate, which controls the peak ratio. Most useful information is obtained when the reaction time lies within the experimental tune scale. For scan rates between 0.02 and 200 V s-1 (common with conventional electrodes), the accessible... 

---