Radioactivity defined

To perpetuate the name of Curie, the quantity of emanation in equilibrium with one gn.m of radium was termed a curie. This is an inconveniently large amount and the milli-micro curie is frequently used as a practical unit. It is the quantity of emanation in equilibrium with one millionth of a milligram of radium. Since one-fiftieth of this can be detected with a sensitive electroscope, this method of detecting the presence of radio-elements is extraordinarily sensitive — more so even than the spectroscope. The above definition of the curie has now been superseded. In July 1950 the Joint Commission on Standards, Units and Constants of Radioactivity defined the curie as the quantity of any radioactive nuclide in which the number of disintegrations per second is 3-700 X io10. 

BASELINE RESTORATION (BLR) A circuit at the amplifier output that maintains the baseline at its reference value. BECQUEREL (Bq) The SI unit of radioactivity, defined as one disintegration per second. 

The analysis of steady-state and transient reactor behavior requires the calculation of reaction rates of neutrons with various materials. If the number density of neutrons at a point is n and their characteristic speed is v, a flux effective area of a nucleus as a cross section O, and a target atom number density N, a macroscopic cross section E = Na can be defined, and the reaction rate per unit volume is R = 0S. This relation may be appHed to the processes of neutron scattering, absorption, and fission in balance equations lea ding to predictions of or to the determination of flux distribution. The consumption of nuclear fuels is governed by time-dependent differential equations analogous to those of Bateman for radioactive decay chains. The rate of change in number of atoms N owing to absorption is as follows ... 

Classification of wastes may be according to purpose, distinguishing between defense waste related to military appHcations, and commercial waste related to civiUan appHcations. Classification may also be by the type of waste, ie, mill tailings, high level radioactive waste (HLW), spent fuel, low level radioactive waste (LLW), or transuranic waste (TRU). Alternatively, the radionucHdes and the degree of radioactivity can define the waste. Surveys of nuclear waste management (1,2) and more technical information (3—5) are available. 

Radioactive waste is characterized by volume and activity, defined as the number of disintegrations per second, known as becquerels. Each radionucHde has a unique half-life,, and corresponding decay constant, A = 0.693/tj 2 For a component radionucHde consisting of JS1 atoms, the activity, M, is defined as... 

Radioactive isotopes are characterized by a number of parameters in addition to those attributable to chemistry. These are radioactive half-life, mode of decay, and type and quantity of radioactive emissions. The half-life, defined as the time required for one-half of a given quantity of radioactivity to decay, can range from milliseconds to biUions of years. Except for the most extreme conditions under very unusual circumstances, half-life is independent of temperature, pressure, and chemical environment. 

Nuclear Waste. NRC defines high level radioactive waste to include (/) irradiated (spent) reactor fuel (2) Hquid waste resulting from the operation of the first cycle solvent extraction system, and the concentrated wastes from subsequent extraction cycles, in a faciHty for reprocessing irradiated reactor fuel and (3) soHds into which such Hquid wastes have been converted. Approximately 23,000 metric tons of spent nuclear fuel has been stored at commercial nuclear reactors as of 1991. This amount is expected to double by the year 2001. 

The licensing process consists of two steps construction and operating license that must be completed before fuel loading. Licensing covers radiological safety, environmental protection, and antitru,st considerations. Activities not defined as production or utilization of special nuclear material (SNM), use simple one-step. Materials Licenses, for the possession of radioactive materials. Examples are uranium mills, solution recovery plants, UO fabrication plants, interim spent fuel storage, and isotopic separation plants. 

The initiating event task was a detailed and systematic search for accident initiators that fail barriers to radioactive material release using dendograms (hierarchical trees). Dendograms define barriers and their failure modes in terms of J phenomena (e.g., melt,... 

From this expression, it is obvious that the rate is proportional to the concentration of A, and k is the proportionality constant, or rate constant, k has the units of (time) usually sec is a function of [A] to the first power, or, in the terminology of kinetics, v is first-order with respect to A. For an elementary reaction, the order for any reactant is given by its exponent in the rate equation. The number of molecules that must simultaneously interact is defined as the molecularity of the reaction. Thus, the simple elementary reaction of A P is a first-order reaction. Figure 14.4 portrays the course of a first-order reaction as a function of time. The rate of decay of a radioactive isotope, like or is a first-order reaction, as is an intramolecular rearrangement, such as A P. Both are unimolecular reactions (the molecularity equals 1). 

The next thing, of course, is to see whether things work out as they should. Do radioactive counts in fact distribute themselves according to the unique Gaussian defined by N and < = VN As Figure 10-3 shows, Rutherford and Geiger6 proved in 1910 that they do. 

Glaser and Lichtenstein (G3) measured the liquid residence-time distribution for cocurrent downward flow of gas and liquid in columns of -in., 2-in., and 1-ft diameter packed with porous or nonporous -pg-in. or -in. cylindrical packings. The fluid media were an aqueous calcium chloride solution and air in one series of experiments and kerosene and hydrogen in another. Pulses of radioactive tracer (carbon-12, phosphorous-32, or rubi-dium-86) were injected outside the column, and the effluent concentration measured by Geiger counter. Axial dispersion was characterized by variability (defined as the standard deviation of residence time divided by the average residence time), and corrections for end effects were included in the analysis. The experiments indicate no effect of bed diameter upon variability. For a packed bed of porous particles, variability was found to consist of three components (1) Variability due to bulk flow through the bed... 

Tracer materials are defined as any product included in the test substance that can be recovered analytically for determining the drift from the application. This may be the active ingredient in an actual tank mix, or it may be a material added to the tank mix for subsequent detection. The selection of an appropriate tracer for assessing deposition rates in the field is critical to the success of a field study. Tracer materials such as low-level active ingredient products, colored dyes, fluorescent dyes, metallic salts, rare earth elements and radioactive isotopes have been used with varying degrees of success in the field. An appropriate tracer should have the following characteristics ... 

This equation shows that on a plot of (N2/Ni)g versus e , the volcanics erupted from this reservoir should define a straight line whose y intercept (at e = 0, i.e., in the future at 0 = -00) is 1 (radioactive equilibrium, cf Fig. 3). A linear relationship is also obtained if isotope ratios, like ( °Th7 Th)e, are reported versus e (see Fig. 11 in Condomines et al. 1988). This latter diagram is similar to the well known isotope... 

The half-life of a radioactive species is defined as the time it takes for the activity of the sample to drop by 50%. In this activity, you will investigate the decay of 137Bam, a metastable isotope of barium that undergoes gamma decay with a half-life of several minutes. 

---