Electromagnetic pumps

The integration of vacuum system and gas distribution is mainly for pumping vacuum in pipeline, vacuum chamber and gas distribution tank. It consists of vacuum pressure gauge, vacuum pump, electromagnetic valve and jointing pipeline. 

Primary pump Electromagnetic pump, no movable parts... 

The sample should be liquid or in solution. It is pumped and nebulized in an argon atmosphere, then sent through a plasma torch that is, in an environment where the material is strongly ionized resulting from the electromagnetic radiation produced by an induction coil. Refer to the schematic diagram in Figure 2.8. 

Techniques for handling sodium in commercial-scale appHcations have improved (5,23,98,101,102). Contamination by sodium oxide is kept at a minimum by completely welded constmction and inert gas-pressured transfers. Residual oxide is removed by cold traps or micrometallic filters. Special mechanical pumps or leak-free electromagnetic pumps and meters work well with clean Hquid sodium. Corrosion of stainless or carbon steel equipment is minimi2ed by keeping the oxide content low. The 8-h TWA PEL and ceiling TLV for sodium or sodium oxide or hydroxide smoke exposure is 2 mg/m. There is no defined AID for pure sodium, as even the smallest quantity ingested could potentially cause fatal injury. 

There are four (4) major types of pumps (I) positive displacement, (2) dynamic (kinetic), (3) lift, and (4) electromagnetic. Piston pumps are positive displacement pumps. The most common centrifugal pumps are of dynamic type ancient bucket-type pumps are lift pumps and electromagnetic pumps use electromagnetic force and are common in modern reactors. Canned pumps are also becoming popular in the petrochemical industiy because of the drive to minimize fugitive emissions. Figure 10-24 shows pump classification ... 

Electromagnetic Force When the fluid is an electrical conductor, as is the case with molten metals, it is possible to impress an electromagnetic field around the fluid conduit in such a way that a driving force that will cause flow is created. Such pumps have been developed for the handling of heat-transfer hquids, especially for nuclear reactors. 

FIG. 10-60 Simpl ified diagram of a direct-current-operated electromagnetic pump. 

The thermal-convection loops are limited to flow velocities up to about 6 cm s . Where higher velocities are required, the liquid must be pumped, either mechanically or electromagnetically the latter is usually preferred as it avoids the problem of leakage at the pump seal. Basically, these forced-convection systemsconsist of (c) a hot leg, where the liquid metal is... 

The ODMR spectrometer resembles the PA spectrometer shown in Figure 7-1, with the sample placed in a microwave cavity between the pole pieces of an electromagnet. The sample is constantly illuminated by the pump and probe beams amplitude-modulated microwaves arc coupled into the cavity through a waveguide. Changes Si in PL or ST in probe transmission are delected by lock-in am-... 

There are four (4) major types of pumps (1) positive displacement, (2) dynamic (kinetic), (3) lift, and (4) electromagnetic. Piston pumps are positive displacement pumps. The most common centrifugal... 

---