Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Pump probe absorption spectroscopy

Takeuchi T, Tahara T (2005) Coherent nuclear wavepacket motions in ultrafast excited-state intramolecular proton transfer sub-30-fs resolved pump-probe absorption spectroscopy of 10-hydroxybenzo[h]quinoline in solution. J Phys Chem A 109 10199-10207... [Pg.264]

We investigated the ultrafast dynamics in a Na-NaBr melt at 1073 K by fs pump probe absorption spectroscopy. A simple model was used to simulate the dynamics of polaron-, bipolaron- and Drude-type electrons. The relaxation times for polarons and bipolarons are 210 fs and 3 ps, respectively. The existence of an isosbestic point at 1.35 eV indicates an inter-conversion between bipolarons and Drude-type electrons. [Pg.249]

Two-color pump-probe absorption spectroscopy is carried out with moderate pump energies producing small depletions of the vibrational ground state of only a few percent in order to avoid secondary excitation steps and minimize the temperature increase of the sample due to the deposited pump energy. [Pg.51]

The pump pulse in time-resolved pump-probe absorption spectroscopy is often linearly polarized, so photoexcitation generally creates an anisotropic distribution of excited molecules. In essence, the polarized light photoselects those molecules whose transition moments are nominally aligned with respect to the pump polarization vector (12,13). If the anisotropy generated by the pump pulse is probed on a time scale that is fast compared to the rotational motion of the probed transition, the measured anisotropy can be used to determine the angle between the pumped and probed transitions. Therefore, time-resolved polarized absorption spectroscopy can be used to acquire information related to molecular structure and structural dynamics. [Pg.213]

The Si-photoisomerization of ris-stilbene was investigated by femtosecond pump-probe absorption spectroscopy in compressed solvents [79]. The viscosity dependence confirmed the existence of two pathways of the reaction. One showed an inverse viscosity dependence and led to trans-stilbene, the other one indicated no viscosity dependence and led to dihydrophenathrene. [Pg.121]

The femtosecond pump-probe absorption spectroscopy was used for the investigation of the SI-photoisomerization of cis-stilbene in compressed solvents [20]. The authors of the work [21] demonstrated a technique for femtosecond time-resolved optical pump-probe spectroscopy that allowed to scan over a nanosecond time delay at a kilohertz scan rate without mechanical delay line. Two mode-locked femtosecond lasers with 1 GHz repetition rate were linked at a fixed difference frequency of =11 kHz. One laser delivers the pump pulses, the other provides the probe pulses. The techniques enabled high-speed scanning over a 1-ns time delay with a time resolution of 230 fs. [Pg.314]

Fig. 5.10 Examples of ns pump-probe absorption spectroscopy for deuterated HK271 in 5CB. They show some indicators of our global best-fit procedure, (a, b) Typical probe transmittance signals (gray noisy line). The apparently constant isotropic signal reached after the pump passage is actually decaying in a time of several microseconds (data not shown), (c) Maximum ns dichroism, normalized to equilibrium transmittance T t = 0), vs. pump pulse energy density (circles). (d) Transmittance measured at 50 ns (triplet contribution) vs. pump pulse energy density. Best-fit curves are reported as black lines (see text for explanation). Reprinted with permission from [30]. Copyright 2003, American Physical Society... Fig. 5.10 Examples of ns pump-probe absorption spectroscopy for deuterated HK271 in 5CB. They show some indicators of our global best-fit procedure, (a, b) Typical probe transmittance signals (gray noisy line). The apparently constant isotropic signal reached after the pump passage is actually decaying in a time of several microseconds (data not shown), (c) Maximum ns dichroism, normalized to equilibrium transmittance T t = 0), vs. pump pulse energy density (circles). (d) Transmittance measured at 50 ns (triplet contribution) vs. pump pulse energy density. Best-fit curves are reported as black lines (see text for explanation). Reprinted with permission from [30]. Copyright 2003, American Physical Society...
Pump-probe absorption experiments on the femtosecond time scale generally fall into two effective types, depending on the duration and spectral width of the pump pulse. If tlie pump spectrum is significantly narrower in width than the electronic absorption line shape, transient hole-burning spectroscopy [101. 102. 103. 104. 105. 106. 107. 108. 109. 110. 111. 112 and 113] can be perfomied. The second type of experiment, dynamic absorption spectroscopy [57, 114. 115. 116. 117. 118. 119. 120. 121 and 122], can be perfomied if the pump and probe pulses are short compared to tlie period of the vibrational modes that are coupled to the electronic transition. [Pg.1979]

Transient intermediates are most commonly observed by their absorption (transient absorption spectroscopy see ref. 185 for a compilation of absorption spectra of transient species). Various other methods for creating detectable amounts of reactive intermediates such as stopped flow, pulse radiolysis, temperature or pressure jump have been invented and novel, more informative, techniques for the detection and identification of reactive intermediates have been added, in particular EPR, IR and Raman spectroscopy (Section 3.8), mass spectrometry, electron microscopy and X-ray diffraction. The technique used for detection need not be fast, provided that the time of signal creation can be determined accurately (see Section 3.7.3). For example, the separation of ions in a mass spectrometer (time of flight) or electrons in an electron microscope may require microseconds or longer. Nevertheless, femtosecond time resolution has been achieved,186 187 because the ions or electrons are formed by a pulse of femtosecond duration (1 fs = 10 15 s). Several reports with recommended procedures for nanosecond flash photolysis,137,188-191 ultrafast electron diffraction and microscopy,192 crystallography193 and pump probe absorption spectroscopy194,195 are available and a general treatise on ultrafast intense laser chemistry is in preparation by IUPAC. [Pg.94]

Pump-probe absorption experiments on the femtosecond time scale generally fall into two effective types, depending on the duration and spectral width of the pump pulse. If the pump spectrum is significantly narrower in width than the electronic absorption line shape, transient hole-burning spectroscopy [101. 102. [Pg.1979]

In all these time-resolved experiments the principles of pump-probe laser spectroscopy are the key element in the experimental design. A laser pulse is optically split into two components of unequal amplitude. The intense fraction, acting as a pump piilse, is directed towards the target or sample cell to trigger the molecular event under study. The much attenuated probe pulse monitors the absorption, raman scattering, polarization, coherence, or phase shift, which is linked explicitly to the dynamical observable under investigation. Extremely precise time... [Pg.187]

A suitable method for a detailed investigation of stimulated emission and competing excited state absorption processes is the technique of transient absorption spectroscopy. Figure 10-2 shows a scheme of this technique. A strong femtosecond laser pulse (pump) is focused onto the sample. A second ultrashort laser pulse (probe) then interrogates the transmission changes due to the photoexcita-lions created by the pump pulse. The signal is recorded as a function of time delay between the two pulses. Therefore the dynamics of excited state absorption as... [Pg.169]

A qualitatively different approach to probing multiple pathways is to interrogate the reaction intermediates directly, while they are following different pathways on the PES, using femtosecond time-resolved pump-probe spectroscopy [19]. In this case, the pump laser initiates the reaction, while the probe laser measures absorption, excites fluorescence, induces ionization, or creates some other observable that selectively probes each reaction pathway. For example, the ion states produced upon photoionization of a neutral species depend on the Franck-Condon overlap between the nuclear configuration of the neutral and the various ion states available. Photoelectron spectroscopy is a sensitive probe of the structural differences between neutrals and cations. If the structure and energetics of the ion states are well determined and sufficiently diverse in... [Pg.223]

It is more difficult to perform ultrafast spectroscopy on neat H20 (than it is on H0D/D20 or HOD/H20) since the neat fluid is so absorptive in the OH stretch region. One innovative and very informative technique, developed by Dlott, involves IR pumping and Raman probing. This technique has a number of advantages over traditional IR pump-probe experiments The scattered light is Stokes-shifted, which is less attenuated by the sample, and one can simultaneously monitor the populations of all Raman-active vibrations of the system at the same time. These experimental have been brought to bear on the spectral diffusion problem in neat water [18, 19, 75 77],... [Pg.95]

One of the most commonly apphed types of spectroscopy in the picosecond realm is pump-probe electronic absorption spectroscopy. The absorption spectra of reactive intermediates are usually just as featureless as those of the other two time domains described in this volume. It is simply the inherent nature of these spectra in condensed phases, most typically in solution. Spectroscopic studies in solution most closely mimic reaction conditions that reactive intermediates may find themselves involved in when they are formed and consumed during the course of an organic chemical reaction. [Pg.875]

The pump and probe pulses employed may be subjected to a variety of nonlinear optical mixing processes they may be prepared and characterized by intensity, duration, spectral band width, and polarization. They may arrive in the reaction chamber at a desired time difference, or none. The probe pulse may lead to ionizations followed by detections of ions by mass spectrometry, but many alternatives for probing and detection have been used, such as laser-induced fluorescence, photoelectron spectroscopic detection, absorption spectroscopy, and the like. [Pg.904]


See other pages where Pump probe absorption spectroscopy is mentioned: [Pg.123]    [Pg.343]    [Pg.516]    [Pg.343]    [Pg.123]    [Pg.343]    [Pg.516]    [Pg.343]    [Pg.377]    [Pg.372]    [Pg.3173]    [Pg.16]    [Pg.25]    [Pg.332]    [Pg.322]    [Pg.288]    [Pg.334]    [Pg.263]    [Pg.264]    [Pg.1968]    [Pg.2116]    [Pg.390]    [Pg.141]    [Pg.124]    [Pg.244]    [Pg.50]    [Pg.31]    [Pg.73]    [Pg.145]    [Pg.161]    [Pg.239]    [Pg.276]    [Pg.876]    [Pg.878]   
See also in sourсe #XX -- [ Pg.516 ]




SEARCH



Absorption Probes

Absorption pumps

Pump-probe

Pump-probe absorption

Pump-probe electronic absorption spectroscopy

Spectroscopy probes

Transient absorption spectroscopy pump-probe measurement

© 2024 chempedia.info