Primary plasticizer INDEX

Shear Modulus at very low strain Shear Modulus at very low strain Initial thickness of layer Thickness of the considered layer after primary settlement Layer thickness Inclination factors Point load strength Plasticity index Consistency index Liquidity index... 

The two primary sections of this book are devoted first to the chemicals, coatings and plastics industry as a whole and then to the Individual Data Listings for THE CHEMICALS 400. If time permits, you should begin your research in the front chapters of this book. Also, you will find lengthy indexes in Chapter 4 and in the back of the book. 

Index of Refraction of Transparent Organic Plastics. Primary Film Test Method ASTM D542 Additional Test Method ISO 489. The... 

Total height of the holding vessel including 40% excess volume (m) Height of tapered portion of the primary fluid nozzle (m) Consistency index for pseudo-plastic non-Newtonian liquid (Pa s") First-order reaction rate constant (m /kg catalyst s)... 

Different properties of plastics are preferred for different fabrication methods. The viscosity of the resin melt is typically measured against a standard test referred to as the melt flow index (MFI). The MFI and resin density characteristics of some of the primary applications are shown in Table 1.4. As can be seen, the MFI and density properties vary with fabrication method. To allow for high tolerances and precise definition, injection molding utilizes a resin melt which is runny (MFI=5-400) in comparison to blow mold grade resin (MFI=0.01-0.2) or extrusion grade resin (MFI=0.3-2). Blow mold resin tends to be more taffy like so that it will retain thickness while pressure is applied inside a mold. This viscosity difference limits the type of recycling production methods possible because different melt viscosity resins do not mix homogeneously. If different melt viscosity resins are not separated pror to reuse, the resin properties will not be uniform in production. 

---