Polymerization iron complexes

Figure 3. Synthetic routes to PLA macroligands and polymeric iron complexes based on dibenzoylmethane (dbm).

Cyclopentadiene itself has been used as a feedstock for carbon fiber manufacture (76). Cyclopentadiene is also a component of supported metallocene—alumoxane polymerization catalysts in the preparation of syndiotactic polyolefins (77), as a nickel or iron complex in the production of methanol and ethanol from synthesis gas (78), and as Group VIII metal complexes for the production of acetaldehyde from methanol and synthesis gas (79). 

As an alternative method for the C-C bond formation, oligomerization and polymerization reactions of olefins catalyzed by a bis(imino)pyridine iron complex are also well known (Scheme 40) [121-124]. 

Scheme 40 Olefin polymerization catalyzed by a bis(imino)pyridine iron complex...

Fink and Babik reported that propylene polymerization was achieved by a bis (imino)pyridine iron complex with Ph3C[B(C6p5)]4] and ttialkylaluminium as additives [127]. Both 3-methyl-"butyl and "butyl endgroups were observed by NMR spectrum when ttiisobutylaluminium as an activator was used, whereas the only "propyl endgroup was formed in case of triethylaluminium activation. In addition, this polymerization proceeds two times faster with than without a hydrogen atmosphere, but the value decreases and the M IM value rises up. 

The reduction electrochemistry of ECP porphyrin films furthermore responds to added axial ligands in the expected ways. We have tested this (2,6) for the ECP form of the iron complex of tetra(o-amino)phenyl)porphyrin by adding chloride and various nitrogeneous bases to the contacting solutions, observing the Fe(III/II) wave shift to expected potentials based on the monomer behavior in solution. This is additional evidence that the essential porphyrin structure is preserved during the oxidation of the monomer and its incorporation into a polymeric film. 

It is essential to characterize the reactant species in solution. One of the problems, for example, in interpreting the rate law for oxidation by Ce(IV) or Co(III) arises from the difficulties in characterizing these species in aqueous solution, particularly the extent of formation of hydroxy or polymeric species. We used the catalyzed decomposition of HjOj by an Fe(III) macrocycle as an example of the initial rate approach (Sec. 1.2.1). With certain conditions, the iron complex dimerizes and this would have to be allowed for, since it transpires that the dimer is catalytically inactive. In a different approach, the problems of limited solubility, dimerization and aging of iron(III) and (Il)-hemin in aqueous solution can be avoided by intercalating the porphyrin in a micelle. Kinetic study is then eased. 

The reaction of hexacyanometalates with metal complexes chelated by penta-dentate ligands may afford polynuclear complexes. The presence of the penta-dentate ligand precludes the polymerization that leads to extended systems. The preparation of a representative heptanuclear, mixed-valance iron complex, [Fe (CNFe° (salmeten))6]Cl2 6H20, is detailed herein. 

The syntheses of iron isonitrile complexes and the reactions of these complexes are reviewed. Nucleophilic reagents polymerize iron isonitrile complexes, displace the isonitrile ligand from the complex, or are alkylated by the complexes. Nitration, sulfonation, alkylation, and bromina-tion of the aromatic rings in a benzyl isonitrile complex are very rapid and the substituent is introduced mainly in the para position. The cyano group in cyanopentakis(benzyl isonitrile)-iron(ll) bromide exhibits a weak "trans" effect-With formaldehyde in sulfuric acid, benzyl isonitrile complexes yield polymeric compositions. One such composition contains an ethane linkage, suggesting dimerization of the transitory benzyl radicals. Measurements of the conductivities of benzyl isonitrile iron complexes indicate a wide range of A f (1.26 e.v.) and o-o (1023 ohm-1 cm.—1) but no definite relationship between the reactivities of these complexes and their conductivities. 

Electron transfer from the substrates to 02 proceeds by a redox cycle that consists of copper(II) and copper(I). The high catalytic activity of the copper complex can be explained as follows (1) The redox potential of Cu(I)/Cu(II) fits the redox reaction. (2) The high affinity of Cu(I) to 02 results in rapid reoxidation of the catalyst. (3) Monomers can coordinate to, and dissociate from, the copper complex, and inner-sphere electron transfer proceeds in the intermediate complex. (4) The complex remains stable in the reaction system. It may be possible to investigate other catalysts whose redox potentials can be controlled by the selection of ligands and metal species to conform with these requisites several other suitable catalysts for oxidative polymerization of phenols, such as manganese and iron complexes, are candidates on the basis of their redox potentials. 

Terminally brominated PE as PE macroinitiator can be produced by other methods. It has been reported that vinyl terminated PE produced by a bis(phenoxy-imine)metal complex and MAO catalyst system (Mn = 1800, Mw/Mn = 1.70) was converted to terminally 2-bromoisobutyrate PE through the addition reaction of 2-bromoisobutyric acid to the vinyl chain end. Polyethylene-Wodc-poly( -bulyl acrylate) (PE-fo-PnBA) from terminally brominated PE by ATRP procedure has also been produced [68]. It was reported that degenerative transfer coordination polymerization with an iron complex can be used to prepare terminally brominated PE as a macroinitiator [69]. A Zn-terminated PE prepared using an iron complex and diethylzinc,... 

Because of the stability of iron tricarbonyl diene complexes, conjugated dienals are protected from polymerization when complexed, while other reactions can be carried out at the aldehyde functionaUty. A number of synthetically attractive nucleophilic transformations of the aldehyde can be performed on these complexes. These include, aldol reactions, Michael additions, reactions with organozinc, -silicon, -boron, and -tin... 

The condensation reaction is very slow, unless the amine is complexed with ferric ions. In a polymerizing emulsion system, the peroxide is in the hydrocarbon phase the amine-iron complex is in the water. The very large interface between these two phases now allows the rapid formation of the unstable condensation product and the chemical nature of this product points to the possibility of separation of the radicals formed on decomposition by diffusion into different phases. 

Electropolymerization of 4-Vinylpyridine Complexes. Investigations of Structural and Electronic Influences on Thin Film Formation. The recent discovery of the reductive polymerization of complexes containing vinylpyridyl ligands (lg), such as Ru -(bpy)2(vpy)22+ has led to the preparation of homogeneous thin layers of very stable electroactive polymers. This method has been extended to 4-vinyl-4 -methyl-2,2 -bipyridine (lg, 21a) and 4-vinyl-l,10-phenanthroline (21b) on both ruthenium and iron. In the following section we discuss our results on thin films derived from the polymerizable ligands BPE and the trans-4 -X-stilbazoles, (4 -X-stilb X - Cl, OMe, CN and H). 

---