Polymer-supported chemistry SPOS

Abstract An overview on the microwave-enhanced synthesis and decoration of the 2(lH)-pyrazinone system is presented. Scaffold decoration using microwave-enhanced transition-metal-catalyzed reactions for generating structural diversity, as well as the conversion of the 2(lH)-pyrazinone skeleton applying Diels-Alder reactions to generate novel heterocyclic moieties are discussed. The transfer of the solution phase to polymer-supported chemistry (SPOS) is also described in detail. 

One of the cornerstones of combinatorial synthesis has been the development of solid-phase organic synthesis (SPOS) based on the original Merrifield method for peptide preparation [19]. Because transformations on insoluble polymer supports should enable chemical reactions to be driven to completion and enable simple product purification by filtration, combinatorial chemistry has been primarily performed by SPOS [19-23], Nonetheless, solid-phase synthesis has several shortcomings, because of the nature of heterogeneous reaction conditions. Nonlinear kinetic behavior, slow reaction, solvation problems, and degradation of the polymer support, because of the long reactions, are some of the problems typically experienced in SPOS. It is, therefore, not surprising that the first applications of microwave-assisted solid-phase synthesis were reported as early 1992 [24],... 

Chemistry on soluble polymer matrices has recently emerged as a viable alternative to solid-phase organic synthesis (SPOS) involving insoluble cross-linked polymer supports. Separation of the functionalized matrix is achieved by solvent or heat precipitation, membrane filtration, or size-exclusion chromatography. Suitable soluble polymers for liquid phase synthesis should be crystalline at room temperature, with functional groups on terminal ends or side chains, but must not be not cross-linked they are therefore soluble in several organic solvents. 

In addition to traditional solid-phase organic synthesis (SPOS), use of polymer-supported reagents (PSR) has attracted increasing attention from practitioners of combinatorial chemistry [104, 105]. The use of PSRs combines the benefits of SPOS with the advantages of solution-phase synthesis. In addition, PSRs can be used in excess without affecting the purification step. By using this technique, reactions can be driven to completion more easily than in conventional solution-phase chemistry. 

An important breakthrough in that respect was the use of soHd-phase organic synthesis (SPOS) where the attachment of the substrate to an insoluble support allowed for easy workup (filtration) and for rapid generation of products via split-mix procedures [1,2]. An important subsequent development consisted of the immobihzation of reagents, scavengers and catalysts. This technique, coined polymer-assisted solution phase chemistry (PASP), allowed solution phase synthesis of compoimds, yet still enjoying the bene-... 

One of the key technologies used in combinatorial chemistry is solid-phase organic synthesis (SPOS) [2], originally developed by Merrifield in 1963 for the synthesis of peptides [3]. In SPOS, a molecule (scaffold) is attached to a solid support, for example a polymer resin (Fig. 7.1). In general, resins are insoluble base polymers with a linker molecule attached. Often, spacers are included to reduce steric hindrance by the bulk of the resin. Linkers, on the other hand, are functional moieties, which allow the attachment and cleavage of scaffolds under controlled conditions. Subsequent chemistry is then carried out on the molecule attached to the support until, at the end of the often multistep synthesis, the desired molecule is released from the support. 

---