Poly chains, self-assembly

The use of ordered supramolecular assemblies, such as micelles, monolayers, vesicles, inverted micelles, and lyotropic liquid crystalline systems, allows for the controlled nucleation of inorganic materials on molecular templates with well-defined structure and surface chemistry. Poly(propyleneimine) dendrimers modified with long aliphatic chains are a new class of amphiphiles which display a variety of aggregation states due to their conformational flexibility [38]. In the presence of octadecylamine, poly(propyleneimine) dendrimers modified with long alkyl chains self-assemble to form remarkably rigid and well-defined aggregates. When the aggregate dispersion was injected into a supersaturated... 

In systems of LP the dynamic response to a temperature quench is characterized by a different mechanism, namely monomer-mediated equilibrium polymerization (MMEP) in which only single monomers may participate in the mass exchange. For this no analytic solution, even in terms of MFA, seems to exist yet [70]. Monomer-mediated equilibrium polymerization (MMEP) is typical of systems like poly(a-methylstyrene) [5-7] in which a reaction proceeds by the addition or removal of a single monomer at the active end of a polymer chain after a radical initiator has been added to the system so as to start the polymerization. The attachment/detachment of single monomers at chain ends is believed to be the mechanism of equilibrium polymerization also for certain liquid sulphur systems [8] as well as for self-assembled aggregates of certain dyes [9] where chain ends are thermally activated radicals with no initiators needed. 

Poly(lactic acid) (PLA) has also been added to poly(SA) via melt polycondensation to produce the triblock copolymers poly(lactic acid-Wock-sebacic acid-Wock-lactic acid) (P(LA-block-SA-block-LA)) by Slivniak and Domb (2002). The PLA (d-, l-, and dl-) was incorporated by acetylation and addition to the PSA synthesis. They showed the formation of stable stereocomplexed particles with increased melting points and reduced solubility, and studied the degradation and drug release characteristics of the same (Slivniak and Domb, 2002). The stereocomplexes self-assemble as a consequence of the chirality in the PLA portions of the chains (Slivniak and Domb, 2002). 

Figure 11.18 Dendron chain copolymers, (a) A poly ether dendron displaying a focal PEG chain and (b) notional representation of the self-assembly of the dendron chain copolymers.

Recently fluorinated chains were also attached to amine based dendrimers, like PPI and poly(amido amine) (PAMAM), by means of ionic self assembly with semiperfluorinated alkanoic acids (Fig. 71, 216, 217). All dendrimer complexes 216 with perfluorinated alkanoic acids show SmA phases except the fifth generation dendrimer which shows a Colrec phase [378]. Also semiperfluorinated 4-alkoxybenzoic acids 217 [379] and mixed systems combining fluorinated and nonfluorinated alkanoic or benzoic acids (216, 217) have been reported [379-381]. In most cases layer structures (SmA) and for higher generation dendrimers also modulated SmA phases (Colrec phases) were observed. The layer thickness of the SmA phases of the mixed complexes 216 depends on the ratio of fluorinated and non-fluorinated acids, where smaller d values were observed for dendrimers with low Rp-content for Rp-rich dendrimers the more rigid Rp-chains provide... 

Recently, a new class of inhibitors (nonionic polymer surfactants) was identified as promising agents for drug formulations. These compounds are two- or three-block copolymers arranged in a linear ABA or AB structure. The A block is a hydrophilic polyethylene oxide) chain. The B block can be a hydrophobic lipid (in copolymers BRIJs, MYRJs, Tritons, Tweens, and Chremophor) or a poly(propylene oxide) chain (in copolymers Pluronics [BASF Corp., N.J., USA] and CRL-1606). Pluronic block copolymers with various numbers of hydrophilic EO (,n) and hydrophobic PO (in) units are characterized by distinct hydrophilic-lipophilic balance (HLB). Due to their amphiphilic character these copolymers display surfactant properties including ability to interact with hydrophobic surfaces and biological membranes. In aqueous solutions with concentrations above the CMC, these copolymers self-assemble into micelles. 

Adsorption of block copolymers onto a surface is another pathway for surface functionalization. Block copolymers in solution of selective solvent afford the possibility to both self-assemble and adsorb onto a surface. The adsorption behavior is governed mostly by the interaction between the polymers and the solvent, but also by the size and the conformation of the polymer chains and by the interfacial contact energy of the polymer chains with the substrate [115-119], Indeed, in a selective solvent, one of the blocks is in a good solvent it swells and does not adsorb to the surface while the other block, which is in a poor solvent, will adsorb strongly to the surface to minimize its contact with the solvent. There have been a considerable number of studies dedicated to the adsorption of block copolymers to flat or curved surfaces, including adsorption of poly(/cr/-butylstyrcnc)-ft/od -sodium poly(styrenesulfonate) onto silica surfaces [120], polystyrene-Woc -poly(acrylic acid) onto weak polyelectrolyte multilayer surfaces [121], polyethylene-Wocfc-poly(ethylene oxide) on alkanethiol-patterned gold surfaces [122], or poly(ethylene oxide)-Woc -poly(lactide) onto colloidal polystyrene particles [123],... 

---