Phosphorus pentachloride preparation

Preparation o/ Phosphorus Pentachloride. Prepare phosphorus trichloride or take the substance from the laboratory assistant. Assemble an apparatus as shown in Fig. 99b. Put the phosphorus trichloride into test tube 2 and connect reflux condenser 4 with water cooling to... 

Phosphorus pentachloride is prepared by the action of chlorine on phosphorus trichloride. To push the equilibrium over to the right, the temperature must be kept low and excess chlorine must be present. Hence the liquid phosphorus trichloride is run dropwise into a flask cooled in ice through which a steady stream of dry chlorine is passed the solid pentachloride deposits at the bottom of the flask. 

It is prepared by heating together phosphorus pentachloride and a sulphite, for example calcium sulphite ... 

One of the general methods for the preparation of acid chlorides is the action of phosphorus pentachloride on the corresponding carboxylic acid ... 

This preparation illustrates the use of phosphorus pentachloride for the preparation of acyl chlorides in this case no difficulty is experienced in separating the 3,5-dinitrobenzoyl chloride from the phosphorus oxychloride formed simultaneously (c/. p. 240), because the former is readily isolated as a crystalline... 

The melting points of these esters are usually much lower than those of the corresponding 3 5 dinitrobenzoates their preparation, therefore, offers no advantages over the latter except for alcohols of high molecular weight and for polyhydroxy compounds. The reagent is, however, cheaper than 3 5 dinitrobenzoyl chloride it hydrolyses in the air so that it should either be stored under light petroleum or be prepared from the acid, when required, by the thionyl chloride or phosphorus pentachloride method. 

The procedure is not usually applicable to aminosulphonic acids owing to the interaction between the amino group and the phosphorus pentachloride. If, however, the chlorosulphonic acid is prepared by diazotisation and treatment with a solution of cuprous chloride in hydrochloric acid, the crystalline chlorosulphonamide and chlorosulphonanilide may be obtained in the usual way. With some compounds, the amino group may be protected by acetylation. Sulphonic acids derived from a phenol or naphthol cannot be converted into the sulphonyl chlorides by the phosphorus pentachloride method. 

Because of the structural requirements of the bielectrophile, fully aromatized heterocycles are usually not readily available by this procedure. The dithiocarbamate (159) reacted with oxalyl chloride to give the substituted thiazolidine-4,5-dione (160) (see Chapter 4.19), and the same reagent reacted with iV-alkylbenzamidine (161) at 100-140 °C to give the 1 -alkyl-2-phenylimidazole-4,5-dione (162) (see Chapter 4.08). Iminochlorides of oxalic acid also react with iV,iV-disubstituted thioureas in this case the 2-dialkylaminothiazolidine-2,4-dione bis-imides are obtained. Thiobenzamide generally forms linear adducts, but 2-thiazolines will form under suitable conditions (70TL3781). Phenyliminooxalic acid dichloride, prepared from oxalic acid, phosphorus pentachloride and aniline in benzene, likewise yielded thiazolidine derivatives on reaction with thioureas (71KGS471). 

Nitrophenyl isocyanate has been prepared by heating -nitrophenyl carbamyl chloride. The latter has been obtained by the action of phosgene on -nitroaniline in benzene-toluene solutions, and by the action of phosphorus pentachloride on methyl jii-nitrophenylcarbamate. The preparation given above is based upon recent publications of the authors. ... 

These last named materials may be considered as derivatives of the inorganic rubber, polyphosphonitrilic chloride, discovered by Stokes in 1895. This was prepared by the reaction of phosphorus pentachloride with ammonium chloride as follows ... 

Chlorophenylacetic acid has been prepared from mandeloni-trile and hydrochloric acid in a sealed tube, from mandelic acid and hydrochloric acid in a sealed tube/ from a-nitrostyrene and hydrochloric acid in a sealed tube, from phenylglycine, hydrochloric acid, and sodium nitrite, from mandelic acid and phosphorus pentachloride (to give the acid chloride which is then hydrolyzed), and, in poor yield, from mandelic acid and thionyl chloride. In the method described, ethyl mandelate is prepared according to Fischer and Speier. The conversion to the chloroester and the acid hydrolysis step are modifications of a preparation described by McKenzie and Barrow. ... 

The method described is a modification of the procedure used by Ghosez to synthesize cinnamonitrile. 3-(2-Furyl)acrylo-nitrile has been prepared by catalytic condensation of furfural with acetonitrile in the vapor phase at 320°, by dehydration of the corresponding amide over phosphorus pentachloride, and by decarboxylation of 3-(2-furyl)-2-cyanoacrylic acid. ... 

In an effort to prepare 1 2-dihydropapaverine, Buck dehydrated with phosphoryl chloride, and subjected the product (V) to catalytic reduction, followed by the action of phosphorus pentachloride in the cold. The final product was assumed to be 1 2-dihydropapaverine but Young and Robinson interpret this synthesis differently, and their formulae (V) and (VI) are given above, the final product being 3 4-dihydropapaverine (VII), which Buck thus prepared for the first time in a crystalline condition, m.p. 97-8° picrate, m.p. 151° perchlorate, m.p. 238° dec.). 

Starting with cuminal, nitro-cuminal was prepared, the nitro group entering the para position, meta to the aldehyde group. This compound - when treated with phosphorus pentachloride was converted into nitro-cymyline chloride, which on reduction with zinc and hydrochloric acid... 

Meanwhile a stirred suspension of phosphorus pentachloride (14.99 g, 0.072 mol) in dry di-chloromethane (150 ml) was cooled to 0°C, and N,N-dimethylacetamide (27.5 ml) was added. The resulting solution was recooled to -10°C and 2-fur-2-yl)-2-methoxyiminoaceticacid (syn-isomer) (12.17 g, 0.072 mol) was added. The mixture was stirred at -10°C for 15 minutes and crushed ice (35 g) was added. The mixture was stirred at 0°C for 10 minutes, whereafter the lower dichloromethane phase was added over 10 minutes to the cephalosporin solution prepared above, cooled to -10°C so that the reaction temperature rose steadily to 0°C. The mixture was stirred at 0°C to 2°C for 1 hour, whereafter the cooling bath was removed and the reaction temperature allowed to rise to 20°C over 1 hour. The reaction mixture was then added slowly to 2 N hydrochloric acid (100 ml) diluted with cold water (1.15 C) at 5°C. The pH of the two-phase mixture was adjusted to below 2 with 2 N hydrochloric acid (10 ml), and the mixture was stirred and recooled to 5°C. The solid which precipitated was filtered, washed with dichloromethane (100 ml) and water (250 ml), and dried in vacuo at 40°C overnight to give the title compound (22.04 g, 86.6%). 

Phosphorus oxychloride serves only as a suspension medium for phosphorus pentachloride and makes possible a homogeneous reaction. The phosphorus oxychloride obtained during workup may be recycled in this preparation. 

Dichloromethyl methyl ether has been prepared by the chlorination of chlorodimethyl ether in the liquid5-4 or gas phase,5 by the reaction of chlorodimethyl ether with sulfuryl chloride and benzoyl peroxide,6 7 and by the treatment of methyl formate with phosphorus pentachloride.8-10... 

In the Meisenheimer reaction of quinoline 1-oxides chlorine atoms usually enter the 2-and 4-positions, but not exclusively. 2,4-Dibromoquinoline 1-oxide was 6-chlorinated (57MI1), and the 5- and 6-nitroquinoline 1-oxides were 3-chlorinated to some extent (44JOC302). This reaction with phosphoryl chloride-phosphorus pentachloride has also been used in the preparation of chlorinated phenanthrolines (88YZ1148). 

Protocatechualdehyde has been made by a variety of methods, but is usually prepared from catechol by the Reimer-Tiemann method 1 by demethylation of vanillin,2 or veratric aldehyde 3 or from piperonal by the action of phosphorus pentachloride followed by hydrolysis.4... 

Chloroanthracene has been prepared by the action of chlorine,2 tert-butyl hypochlorite, l,3-dichloro-5,5-dimethylhy-dantoin, or phosphorus pentachloride 5 on anthracene. 

A suspension of 100 g (0 48 mole, 33% excess) of phosphorus pentachloride in 800 ml of carbon tetrachloride is prepared in a 1-1 flask equipped with an efficient stirrer and an exit valve for the hydrogen chloride that is evolved ( ote 1) Tropilidene (cycloheptatriene, 24.2 g of 91% mateiial, 0.24 mole) (Note 2)... 

Phosphorus trichloride, PCI, and phosphorus pentachloride, PC15, are the two most important halides of phosphorus. The former is prepared by direct chlorination... 

The factors affecting the preparation of the cyclic chlorophosphazenes from phosphorus pentachloride and ammonium chloride continue to receive attention. For example, the yields and reaction times for the preparation of the series, (NPCla) ( — 3—7), varied with the fineness of the ammonium chloride, the nature and volume of the solvent, and added catalysts such as phosphoryl chloride. A procedure, giving due consideration to these factors, was described for the preparation of N3P3CI6 in good yield (88% of cyclic products) and in a relatively short time (2J h). The cyclic chlorophosphazenes can be obtained in even shorter times ca. 10 min) by addition of four moles of pyridine to remove the hydrogen chloride formed ... 

When chlorine reacted with sodium diethyl dithiophosphate in the presence of an organic solvent, the desired compound was obtained in good yield. The reaction of phosphorus pentachloride on the sodium salt resulted in the same product. Thiophos-phoryl chloride is a probable by-product of this reaction. It was later found that diethyl dithiophosphoric acid could be chlorinated in an organic solvent without the intermediate preparation of the sodium salt. 

---