Palladium isotope

Other elements have atoms that can have different ratios of protons to neutrons. Indeed, hydrogen actually consists of three types of atoms. All hydrogen atoms have the same number of protons (one for hydrogen), giving each a mass of 1 Dalton, but some atoms of hydrogen also contain one neutron in the nucleus as well as the proton (mass of 2 Da), while yet others have two neutrons with each proton (mass of 3 Da). Thus hydrogen has three naturally occurring isotopes of mass 1, 2, and 3 Da. Chemically, there are only small differences between the reactivities of the different isotopes for any one element. Thus isotopes of palladium aU react in the same way but react differently from all isotopes of platinum. 

Isotope Effects on Superconductivity. Substitution of hydrogen by deuterium affects the superconducting transition temperature of palladium hydride [26929-60-2] PdH2 (54,55), palladium silver hydride, Pd Ag H D ( 6), and vanadium—2itconium—hydride, N(57). 

A mechanism for alkene arylation by palladium(II) is given below. The isotope effect was found to be 5 when benzene-dg was used. When styrene-/S,i5-d2 was used. 

The most commonly used catalysts are palladized charcoal or calcium carbonate and platinum oxide. For better isotopic purity, the use of platinum oxide may be preferred for certain olefins since the substrate undergoes fewer side reactions while being chemisorbed on the platinum surface as compared to palladium.Suitable solvents are cyclohexane, ethyl acetate, tetrahydrofuran, dioxane or acetic acid-OD with platinum oxide. 

A solution of 4,4-dimethyl-5a-androst-l-en-3-one (128, 14 mg) in cyclohexane (3 ml) is stirred in a microhydrogenation apparatus in the presence of 10 % palladium-on-charcoal (15 mg) at atmospheric pressure and room temperature. The uptake of one eq of deuterium (1.15 ml) is complete in about 1 min and no more deuterium is consumed. After 5 min the catalyst is removed by filtration, and the solvent evaporated under reduced pressure. The resulting l<, 2< -d2-4,4-dimethyl-5a-androstan-3-one (129, 13 mg, 93%), mp 120-122°, exhibits 87% isotopic purity and 13% d species. ... 

Replacement of halides with deuterium gas in the presence of a surface catalyst is a less useful reaction, due mainly to the poor isotopic purity of the products. This reaction has been used, however, for the insertion of a deuterium atom at C-7 in various esters of 3j -hydroxy-A -steroids, since it gives less side products resulting from double bond migration. Thus, treatment of the 7a- or 7j5-bromo derivatives (206) with deuterium gas in the presence of 5% palladium-on-calcium carbonate, or Raney nickel catalyst, followed by alkaline hydrolysis, gives the corresponding 3j3-hydroxy-7( -di derivatives (207), the isotope content of which varies from 0.64 to 1.18 atoms of deuterium per mole. The isotope composition and the stereochemistry of the deuterium have not been rigorously established. 

Displacement of aromatic halogen in 2,4-diiodo-estradiol with tritiated Raney nickel yields 2,4-ditritiated estradiol. Aromatic halogen can also be replaced by heating the substrate with zinc in acetic acid-OD or by deuteration with palladium-on-charcoal in a mixture of dioxane-deuterium oxide-triethylamine, but examples are lacking for the application of these reactions in the steroid field. Deuteration of the bridge-head position in norbornane is readily accomplished in high isotopic purity by treatment of the... 

When specifically labelled compounds are required, direct chemical synthesis may be necessary. The standard techniques of preparative chemistry are used, suitably modified for small-scale work with radioactive materials. The starting material is tritium gas which can be obtained at greater than 98% isotopic abundance. Tritiated water can be made either by catalytic oxidation over palladium or by reduction of a metal oxide ... 

For a comparison of experimental Mossbauer isomer shifts, the values have to be referenced to a common standard. According to (4.23), the results of a measurement depend on the type of source material, for example, Co diffused into rhodium, palladium, platinum, or other metals. For Fe Mossbauer spectroscopy, the spectrometer is usually calibrated by using the known absorption spectrum of metallic iron (a-phase). Therefore, Fe isomer shifts are commonly reported relative to the centroid of the magnetically split spectrum of a-iron (Sect. 3.1.3). Conversion factors for sodium nitroprusside dihydrate, Na2[Fe(CN)5N0]-2H20, or sodium ferrocyanide, Na4[Fe(CN)]6, which have also been used as reference materials, are found in Table 3.1. Reference materials for other isotopes are given in Table 1.3 of [18] in Chap. 1. 

Figure 9. The quadrupole mass spectrometer signal for volatile species released from 0.90 nm palladium acetate film as a function of 2 MeV He+ ion dose. Mass 15 is shown for both CH3 and CH4 because of overlap at m/e 16 with oxygen. Mass 31 is shown for C2H6 (13C isotope) because of overlap at m/e 30 with major fragments of other parent ions.

Palladium-catalyzed room-temperature >rtfe>-alkenylations of anilides have been recently reported, employing benzoquinone as a stoichiometric oxidant. A kinetic isotope effect kn/koof 3 points to a slow C-H functionalization step. Electron-rich acetanilides react faster whereas anilines are unreactive (Equation (138)).120... 

C-C bond formation mediated by silane.6,6a 6f With respect to the development of intramolecular variants, these seminal studies lay fallow until 1990, at which point the palladium- and nickel-catalyzed reductive cyclization of tethered 1,3-dienes mediated by silane was disclosed. As demonstrated by the hydrosilylation-cyclization of 1,3,8,10-tetraene 21a, the /rarcr-divinylcyclopentanes 21b and 21c are produced in excellent yield, but with modest stereoselectivity.46 Bu3SnH was shown to participate in an analogous cyclization.46 Isotopic labeling and crossover experiments provide evidence against a mechanism involving initial diene hydrosilylation. Rather, the collective data corroborate a mechanism involving oxidative coupling of the diene followed by silane activation (Scheme 15). 

The reaction rate is half-order in palladium and dimeric hydroxides of the type shown are very common for palladium. The reaction is first order in alcohol and a kinetic isotope effect was found for CH2 versus CD2 containing alcohols at 100 °C (1.4-2.1) showing that probably the (3-hydride elimination is rate-determining. Thus, fast pre-equilibria are involved with the dimer as the resting state. When terminal alkenes are present, Wacker oxidation of the alkene is the fastest reaction. Aldehydes are prone to autoxidation and it was found that radical scavengers such as TEMPO suppressed the side reactions and led to an increase of the selectivity [18],... 

Recently, Rooney (80) expressed the view that the a,j8 exchange process involved tt olefin complexes and asserts that this explains the pattern of exchange on a palladium film of deuterium with 1,1-dimethylcyclo-butane. Its failure to exhibit appreciable multiple isotopic exchange was attributed to the difficulty of forming a tt olefin complex because of the strain in cyclobutene. 

ISOTOPES There are 42 isotopes of palladium, ranging from Pd-91 to Pd-124. All but six are radioactive and artificially produced in nuclear reactors with half-lives ranging from 159 nanoseconds to 6.5x10+ years. The six stable isotopes of palladium and their proportional contribution to their existence in the Earth s crust are as follows Pd-102 = 1.02%, Pd-104 = 11.14%, Pd-105 = 22.23%, Pd-106 = 27.33%, Pd-108 = 26.46%, and Pd-110= 11.72%. 

Gautier C., Bourgeois M., Isnard H., Nonell A., Stadeknann G. Goutelard E. Development of cadmium/silver/palladium separation by ion chromatography with quad-mpole inductively coupled plasma mass spectrometry detection for off-line cadmium isotopic measurements. Journal of Chromatography A 2011 1218 (31)5241-5247. 

Measurement of the Pd- Ag system requires careful chemistry to remove terrestrial silver and palladium and to eliminate interferences in the mass spectrometer. Because silver has only two isotopes, great care must be taken to account for mass-dependent fractionation,... 

---