Palladium enantioselective

R2Zn, cat bis((—>camphorquinone-a-dioximato) cobalt(II) or palladium ] (enantioselective)... 

Jeletic MS, Ghiviriga I, Abboud KA, Veige AS. A new chiral di-N-heterocyclic carbene (NHC) cyclophane ligand and its application in palladium enantioselective catalysis. Dalton Trans. 2010 39 6392-6394. 

Cationic BINAP-palladium and platinum complexes 30a,b can catalyze highly enantioselective cycloaddition reactions of arylglyoxals with acyclic and cyclic... 

For the activation of a substrate such as 19a via coordination of the two carbonyl oxygen atoms to the metal, one should expect that a hard Lewis acid would be more suitable, since the carbonyl oxygens are hard Lewis bases. Nevertheless, Fu-rukawa et al. succeeded in applying the relative soft metal palladium as catalyst for the 1,3-dipolar cycloaddition reaction between 1 and 19a (Scheme 6.36) [79, 80]. They applied the dicationic Pd-BINAP 54 as the catalyst, and whereas this type of catalytic reactions is often carried out at rt or at 0°C, the reactions catalyzed by 54 required heating at 40 °C in order to proceed. In most cases mixtures of endo-21 and exo-21 were obtained, however, high enantioselectivity of up to 93% were obtained for reactions of some derivatives of 1. 

The reactions of nitrones constitute the absolute majority of metal-catalyzed asymmetric 1,3-dipolar cycloaddition reactions. Boron, aluminum, titanium, copper and palladium catalysts have been tested for the inverse electron-demand 1,3-dipolar cycloaddition reaction of nitrones with electron-rich alkenes. Fair enantioselectivities of up to 79% ee were obtained with oxazaborolidinone catalysts. However, the AlMe-3,3 -Ar-BINOL complexes proved to be superior for reactions of both acyclic and cyclic nitrones and more than >99% ee was obtained in some reactions. The Cu(OTf)2-BOX catalyst was efficient for reactions of the glyoxylate-derived nitrones with vinyl ethers and enantioselectivities of up to 93% ee were obtained. 

The first reported chiral catalysts allowing the enantioselective addition of diethylzinc to aryl aldehydes in up to 60% cc were the palladium and cobalt complexes of 1,7,7-trimethylbicy-clo[2.2.1. ]heptane-2,3-dione dioxime (A,B)3. A number of other, even more effective catalysts, based on the camphor structure (C K, Table 26) have been developed. 

Racemization of amines is difficult to achieve and usually requires harsh reaction conditions. Reetz et al. developed the first example of DKR of amines using palladium on carbon for the racemization and CALB for the enzymatic resolution [35]. This combination required long reaction times (8 days) to obtain 64% yield in the DKR of 1-phenylethylamine. More recently, Backvall et al. synthesized a novel Shvo-type ruthenium complex (S) that in combination with CALB made it possible to perform DKR of a variety of primary amines with excellent yields and enantioselectivities (Figure 4.13) [36]. 

When the Pd bears chiral ligands, these reactions can be enantioselective. TT-Allylmolybdenum compounds behave similarly.Because palladium compounds are expensive, a catalytic synthesis, which uses much smaller amounts of the complex, was developed. That is, a substrate such as an allylic acetate, carbo-... 

The reductive amination of ketones can be carried out under hydrogen pressure in the presence of palladium catalysts. However, if enantiopure Q -aminoketones are used, partial racemization of the intermediate a-amino imine can occur, owing to the equilibration with the corresponding enam-ine [102]. Asymmetric hydrogenation of racemic 2-amidocyclohexanones 218 with Raney nickel in ethanol gave a mixture of cis and trans 1,2-diamino cyclohexane derivatives 219 in unequal amounts, presumably because the enamines are intermediates, but with excellent enantioselectivity. The two diastereomers were easily separated and converted to the mono-protected cis- and trans- 1,2-diaminocyclohexanes 220. The receptor 221 has been also synthesized by this route [103] (Scheme 33). 

Helquist et al. [129] have reported molecular mechanics calculations to predict the suitability of a number of chiral-substituted phenanthrolines and their corresponding palladium-complexes for use in asymmetric nucleophilic substitutions of allylic acetates. Good correlation was obtained with experimental results, the highest levels of asymmetric induction being predicted and obtained with a readily available 2-(2-bornyl)-phenanthroline ligand (90 in Scheme 50). Kocovsky et al. [130] prepared a series of chiral bipyridines, also derived from monoterpene (namely pinocarvone or myrtenal). They synthesized and characterized corresponding Mo complexes, which were found to be moderately enantioselective in allylic substitution (up to 22%). 

Chitosan (Fig. 27) was deposited on sihca by precipitation. The palladium complex was shown to promote the enantioselective hydrogenation of ketones [80] with the results being highly dependent on the structure of the substrate. In the case of aromatic ketones, both yield and enantioselectiv-ity depend on the N/Pd molar ratio. Low palladium contents favored enan-tioselectivity but reduced the yield. Very high conversions were obtained with aliphatic ketones, although with modest enantioselectivities. More recently, the immobilized chitosan-Co complex was described as a catalyst for the enantioselective hydration of 1-octene [81]. Under optimal conditions, namely Co content 0.5 mmolg and 1-octene/Co molar ratio of 50, a 98% yield and 98% ee were obtained and the catalyst was reused five times without loss of activity or enantioselectivity. 

Moyano A, Rosol M, Moreno RM, Lopez C, Maestro MA (2005) Oxazoline-mediated interannular cyclopalladation of ferrocene chiral palladium(II) catalysts for the enantioselective Azti-Claisen rearrangement. Angew Chem Int Ed 44 1865-1869... 

Negishi E, Tan Z (2005) Diastereoselective, Enantioselective, and Regioselective Carbo-alumination Reactions Catalyzed by Zirconocene Derivatives. 8 139-176 Netherton M, Fu GC (2005)Palladium-catalyzed Cross-Coupling Reactions of Unactivated Alkyl Electrophiles with Organometallic Compounds. 14 85-108 NicolaouKC, KingNP, He Y (1998) Ring-Closing Metathesis in the Synthesis of EpothUones and Polyether Natural Products. 1 73-104 Nishiyama H (2004) Cyclopropanation with Ruthenium Catalysts. 11 81-92 Noels A, Demonceau A, Delaude L (2004) Ruthenium Promoted Catalysed Radical Processes toward Fine Chemistry. 11 155-171... 

Campos, K.R., Klapers, A., Waldman, J.H., Dormer, P.G., Chen, C.Y. (2006) Enantioselective, Palladium-Catalyzed a-Arylation of N-Boc-pyrrolidine. Journal of the American Chemical Society, 128, 3538-3539. 

Concerning enantioselective processes, Fujihara and Tamura have proved that palladium NPs containing (S)-BINAP (2,2 -bis(diphenylphosphino)-l,l -binaphthyl) as chiral stabiliser, catalyse the hydrosilylation of styrene with trichlorosilane, obtaining (S)-l-phenylethanol as the major isomer (ee = 75%) [42]. In contrast, the palladium complex [Pd(BINAP)(C3H5)]Cl is inactive for the same reaction [43]. 

Since Pd complexes are well-known catalysts for enantioselective allylic substitution reactions, here the catalytic behaviour of palladium NPs for this reaction is examined (Scheme 1). One example involving a chiral phosphite with a carbohydrate backbone, able to coordinate firmly at the surface of NPs together with oxygen atoms capable to interact weakly with this surface, is presented. In particular. 

It is remarkable that the monofunctionalization of norbornadiene (31), giving exo-5-trichlorosilyl-2-norbornene (32a), is effected by the palladium-MOP catalyst with high chemo- and enantioselectivity [41] (Scheme 3-14). Thus, the reaction of 31 with... 

For the asymmetric hydrosilylation of 1,3-cyclohexadiene (42) (Scheme 3-17), the enantioselectivity is higher in the reaction with phenyldifluorosilane than that with trichlorosilane or methyidichlorosilane. The reaction of 42 with phenyldifluorosilane in the presence of a palladium catalyst coordinated with ferrocenylphosphine... 

The discussion of the activation of bonds containing a group 15 element is continued in chapter five. D.K. Wicht and D.S. Glueck discuss the addition of phosphines, R2P-H, phosphites, (R0)2P(=0)H, and phosphine oxides R2P(=0)H to unsaturated substrates. Although the addition of P-H bonds can be sometimes achieved directly, the transition metal-catalyzed reaction is usually faster and may proceed with a different stereochemistry. As in hydrosilylations, palladium and platinum complexes are frequently employed as catalyst precursors for P-H additions to unsaturated hydrocarbons, but (chiral) lanthanide complexes were used with great success for the (enantioselective) addition to heteropolar double bond systems, such as aldehydes and imines whereby pharmaceutically valuable a-hydroxy or a-amino phosphonates were obtained efficiently. 

Since carbohydrates constitute an inexpensive and highly modular chiral source for preparing chiral ligands," Claver et al. have reported the use of a series of thioether-phosphite" and thioether-phosphinite furanoside ligands" in the test palladium-catalysed allylic substitution reaction. In the first type of ligand, a systematic variation of the donor group attached to the carbon atom C5 indicated that the presence of a bulky phosphite functionality had a positive effect on the enantioselectivity. Indeed, the enantioselectivity was controlled mainly by the phosphite moiety. This was confirmed by the use of a ligand... 

---