Oxidation, sulfur-containing

In contrast to nucleic acids, which can be repaired after oxidative damage by excision and insertion mechanisms (see Chapter 28), the repair of oxidized proteins does not occur except the oxidized sulfur-containing amino acid residues [22]. Instead, oxidized proteins are... 

Carbon disulfide is obtained industrially from carbon and sulfur and is contaminated by sulfides and other sulfur-containing substances. It can be dried by calcium chloride or phosphoric oxide. Sulfur-containing contaminants can be removed by shaking with mercury and mercury(n) chloride38 or by treatment with concentrated nitric acid38 or potassium permanganate solution.39... 

Scheme 16. Structures of two oxidized sulfur containing heterocycles...

CAAA Clean Air Act amendments of 1990 in the United States, which introduced substantial new controls for nitrogen oxides, sulfur-containing compounds, and, potentially, many metals emissions by power plants. 

Criteria pollutants Pollutants for which federal law governs emissions (nitrogen oxides, sulfur-containing compounds, CO, and particulates are the most significant criteria pollutants for coal-based power systems). 

Cmde diketene obtained from the dimeriza tion of ketene is dark brown and contains up to 10% higher ketene oligomers but can be used without further purification. In the cmde form, however, diketene has only limited stabHity. Therefore, especiaHy if it has to be stored for some time, the cmde diketene is distiHed to > 99.5% purity (124). The tarry distiHation residue, containing trike ten e (5) and other oligomers, tends to undergo violent Spontaneous decomposition and is neutralized immediately with water or a low alcohol. Ultrapure diketene (99.99%) can be obtained by crystallization (125,126). Diketene can be stabHized to some extent with agents such as alcohols and even smaH quantities of water [7732-18-5] (127), phenols, boron oxides, sulfur [7704-34-9] (128) and sulfate salts, eg, anhydrous copper sulfate [7758-98-7]. 

Molybdenite concentrate contains about 90% M0S2. The remainder is primarily siUca, with lesser amounts of Fe, Al, and Cu. The concentrate is roasted to convert the sulfide to technical molybdic oxide. Molybdenum is added to steel in the form of this oxide. In modem molybdenum conversion plants, the oxidized sulfur formed by roasting M0S2 is converted to sulfuric acid. 

Other Specialty Chemicals. In fuel-ceU technology, nickel oxide cathodes have been demonstrated for the conversion of synthesis gas and the generation of electricity (199) (see Fuel cells). Nickel salts have been proposed as additions to water-flood tertiary cmde-oil recovery systems (see Petroleum, ENHANCED oil recovery). The salt forms nickel sulfide, which is an oxidation catalyst for H2S, and provides corrosion protection for downweU equipment. Sulfur-containing nickel complexes have been used to limit the oxidative deterioration of solvent-refined mineral oils (200). 

In the electromotive force series of the elements, silver is less noble than only Pd, Hg, Pt, and Au. AH provide high corrosion resistance. Silver caimot form oxides under ambient conditions. Its highly reactive character, however, results in the formation of black sulfides on exposure to sulfur-containing atmospheres. 

S-oxidation of sulfur-containing pesticides such as aldicarb, parathion, and malathion can be of importance in the absence of microbial activity (29). The products of chemical vs biological oxidation are generally identical (eq. 8). 

Generally, cmde sulfur contains small percentages of carbonaceous matter. The amount of this impurity is usually determined by combustion, which requires an exacting technique. The carbonaceous matter is oxidized to carbon dioxide and water the carbon dioxide is subsequently absorbed (18). Automated, on-stream determination of impurities in molten sulfur has been accompHshed by infrared spectrophotometry (35). 

The catalysts are prepared by impregnating the support with aqueous salts of molybdenum and the promoter. In acidic solutions, molybdate ions are present largely in the form of heptamers, [Mo2024] , and the resulting surface species are beHeved to be present in islands, perhaps containing only seven Mo ions (100). Before use, the catalyst is treated with H2 and some sulfur-containing compounds, and the surface oxides are converted into the sulfides that are the catalyticaHy active species. 

The most common form of corrosion is uniform corrosion, in which the entire metal surface degrades at a near uniform rate (1 3). Often the surface is covered by the corrosion products. The msting of iron (qv) in a humid atmosphere or the tarnishing of copper (qv) or silver alloys in sulfur-containing environments are examples (see also SiLVERAND SILVER ALLOYS). High temperature, or dry, oxidation, is also usually uniform in character. Uniform corrosion, the most visible form of corrosion, is the least insidious because the weight lost by metal dissolution can be monitored and predicted. 

Oxides of sulfur-containing azoles comprise another class of non-aromatic azoles. 

The conducted researches of complexing processes of noble metals on a sulfur-containing CMSG surface formed the basis for development of sorption-photometric, sorption-luminescent, soi ption-atomic-absoi ption, sorption-atomic-emission and sorption-nuclear-physic techniques of the analysis of noble metals in rocks, technological objects and environmental objects. Techniques of separation and detenuination of noble metals in various oxidation levels have been proposed in some cases. 

Thiobacillus thiooxidans is an aerobic organism that oxidizes various sulfur-containing compounds to form sulfuric acid. These bacteria are sometimes found near the tops of tubercles (see Chap. 3, Tubercu-lation ). There is a symbiotic relationship between Thiobacillus and sulfate reducers Thiobacillus oxidizes sulfide to sulfate, whereas the sulfate reducers convert sulfide to sulfate. It is unclear to what extent Thiobacillus directly influences corrosion processes inside tubercles. It is more likely that they indirectly increase corrosion by accelerating sulfate-reducer activity deep in the tubercles. 

The Dim ester was developed for the protection of the carboxyl function during peptide synthesis. It is prepared by transesterification of amino acid methyl esters with 2-(hydroxymethyl)-l,3-dithiane and Al(/-PrO)3 (reflux, 4 h, 75°, 12 torr, 75% yield). It is removed by oxidation [H2O2, (NH4)2Mo04 pH 8, H2O, 60 min, 83% yield]. Since it must be removed by oxidation it is not compatible with.sulfur-containing amino acids such as cysteine and methionine. Its suitability for other, easily oxidized amino acids (e.g., tyrosine and tryptophan) must also be questioned. It is stable to CF3CO2H and HCl/ether. - ... 

Contents Introduction and Principles. - The Reaction of Dichlorocarbene With Olefins. - Reactions of Dichlorocarbene With Non-Olefinic Substrates. -Dibromocarbene and Other Carbenes. - Synthesis of Ethers. - Synthesis of Esters. - Reactions of Cyanide Ion. - Reactions of Superoxide Ions. - Reactions of Other Nucleophiles. - Alkylation Reactions. - Oxidation Reactions. - Reduction Techniques. - Preparation and Reactions of Sulfur Containing Substrates. -Ylids. - Altered Reactivity. - Addendum Recent Developments in Phase Transfer Catalysis. 

General Incineration (oxidation) is the best-known method for the removal of gaseous industrial waste. Combustible compounds containing carbon, hydrogen, and oxygen are converted to carbon dioxide and water by the overall exothermic reactions [Eq. (13.72)]. When chlorinated or sulfur-containing compounds are present in the effluent, the products of combustion include HCl/CE or S02/S03. ... 

Mammalian sulfite oxidase is the last enzyme in the pathway for degradation of sulfur-containing amino acids. Sulfite oxidase (SO) catalyzes the oxidation of sulfite (SO ) to sulfate (S04 ), using the heme-containing protein, cytochrome c, as electron acceptor ... 

---