On rhodium

In a study on the influence of supports on rhodium, the amount of dicyclohexylamine was found to decrease in the order carbon > barium carbonate > alumina > barium sulfate > calcium carbonate. Plain carbon added to rhodium-on-alumina-catalyzed reactions was found to cause an increase in the amount of dicyclohexylamine, suggesting that carbon catalyzes the formation of the intermediate addition product (59). 

Although there is a severe paucity of vibrational data for the molecular form of O2 chemisorbed on rhodium surfaces, it is possible to visualize the dinuclear and trinuclear complexes as models for the associative chemisorption of O2 on rhodium. The pq-o values of the complexes Rh2(02)i,2 show little... 

Much research has been carried out into direct amination of aromatic substrates, typified by the direct conversion of benzene to aniline using ammonia and a catalyst. Although there have been many patented routes conversions, are normally low, making them uneconomic. Modem catalysts based on rhodium and iridium, together with nickel oxide (which becomes reduced), have proved more active,and such is the research activity in this area that it is only a matter of time before such processes become widely used. 

Temperature-programmed reactions between small amounts of adsorbed species are an excellent way to study the intrinsic reactivity of catalytic surfaces. Such experiments on rhodium (100) and (111) surfaces covered by small amounts of CO and... 

The ruthenium-copper and osmium-copper systems represent extreme cases in view of the very limited miscibility of either ruthenium or osmium with copper. It may also be noted that the crystal structure of ruthenium or osmium is different from that of copper, the former metals possessing the hep structure and the latter the fee structure. A system which is less extreme in these respects is the rhodium-copper system, since the components both possess the face centered cubic structure and also exhibit at least some miscibility at conditions of interest in catalysis. Recent EXAFS results from our group on rhodium-copper clusters (14) are similar to the earlier results on ruthenium-copper ( ) and osmium-copper (12) clusters, in that the rhodium atoms are coordinated predominantly to other rhodium atoms while the copper atoms are coordinated extensively to both copper and rhodium atoms. Also, we conclude that the copper concentrates in the surface of rhodium-copper clusters, as in the case of the ruthenium-copper and osmium-copper clusters. 

Since ruthenium and rhodium are neighboring elements in the periodic table, a closer comparison of the properties of ruthenium-copper and rhodium-copper clusters is of interest (17). When we compare EXAFS results on rhodium-copper and ruthenium-copper catalysts in which the Cu/Rh and Cu/Ru atomic ratios are both equal to one, we find some differences which can be related to the differences in miscibility of copper with ruthenium and rhodium. The extent of concentration of copper at the surface appears to be lower for the rhodium-copper clusters than for the ruthenium-copper clusters, as evidenced by the fact that rhodium exhibits a greater tendency than ruthenium to be coordinated to copper atoms in such clusters. The rhodium-copper clusters presumably contain some of the copper atoms in the interior of the clusters. 

In conclusion, hydrogenolysis processes and coke formation occur on large ensembles of surface platinum atoms [160], while dehydrogenation reactions would proceed on single (isolated) Pt atoms [169]. The presence of tin atoms regularly distributed on the metal surface diminishes the size of the ensemble [130,170-173], the same is observed for copper atoms on nickel surfaces [174] or tin atoms on rhodium and nickel surfaces [137,175-177], leading to site isolation and therefore to selectivity. 

NMR measurements are very useful to understand the properties of the stabilizing reagents of metal nanoparticles. Author s group reported the structure of stabilization of non-ionic and cationic surfactants on platinum nanoparticles [22] and that of ternary amines on rhodium nanoparticles [23]. Such information is considerably important for applications of nanoparticles such as... 

In recent years, much attention has been focused on rhodium-mediated carbenoid reactions. One goal has been to understand how the rhodium ligands control reactivity and selectivity, especially in cases in which both addition and insertion reactions are possible. These catalysts contain Rh—Rh bonds but function by mechanisms similar to other transition metal catalysts. 

Citra, A., Andrews, L., 1999, Reactions of Laser Ablated Rhodium Atoms With Nitrogen Atoms and Molecules. Infrared Spectra and Density Functional Calculations on Rhodium Nitrides and Dinitrogen Complexes , J. Phys. Chem. A, 103, 3410. 

Figure 3.6. Example of the type of kinetic information available for the catalytic reduction of NO on rhodium single-crystal surfaces under atmospheric conditions. The data in this figure correspond to specific rates for C02, N20, and N2 formation over Rh(l 11) as a function of inverse temperature for two NO + CO mixtures PNO = 0.6 mbar and Pco — 3 mbar (A), and Pno — Pco = 4 mbar (B) [55]. The selectivity of the reaction in this case proved to be approximately constant independent of surface temperature at high NO pressures, but to change significantly below Pno 1 mbar. This highlights the dangers of extrapolating data from experiments under vacuum to more realistic pressure conditions. (Reproduced with permission from the American Chemical Society, Copyright 1995).

This review has highlighted the key contributions of modern surface science to the understanding of the kinetics and mechanism of nitrogen oxide reduction catalysis. As discussed above, the conversion of NO has been taken as the standard to represent other NOx, and CO has typically been used as the reducing agent in these studies. The bulk of the work has been carried out on rhodium and palladium surfaces, the most common transition metals used in three-way catalytic converters. 

Tolia, A. A., Williams, C. T., Weaver, M. J. et al. (1995) Surface-enhanced Raman spectroscopy as an in situ real-time probe of catalytic mechanisms at high gas pressures. The NO-H2 reaction on rhodium , Langmuir, 11, 3438. 

Bustos, V., Ufiac, R., Zaera, F. et al. (2003) Lattice-gas study of the kinetics of the catalytic NO-CO reaction on rhodium surfaces. II. The effect of nitrogen surface islands , J. Chem. Phys., 118, 9372. 

This volume is concerned with fundamental developments in the coordination chemistry of the elements of Groups 9-12 since 1982. The individual chapters cover the coordination chemistry of cobalt, iridium, nickel, palladium, platinum, copper, silver and gold, zinc and cadmium, and mercury. Unfortunately, because of factors beyond the Editors control, the manuscript for the proposed chapter on rhodium was not available in time for publication. 

Although most of the reports that have appeared since 1980 on hydroformylation of alkenes focus on rhodium catalysts, alkene hydroformylation catalyzed by Ptn complexes in the presence of Sn11 halides has been the object of great interest and platinum can be considered as the second metal in hydroformylation.77-79... 

Important by-products are urea derivatives (ArNHC(0)NHAr) and azo compounds (Ar-N=N-Ar). The reaction is highly exothermic (—128kcalmol-1) and it is surprising that still such low rates are obtained (several hundred turnovers per hour) and high temperatures are required (130 °C and 60 bar of CO) to obtain acceptable conversions.533 Up to 2002, no commercial application of the new catalysts has been announced. Therefore, it seems important to study the mechanism of this reaction in detail aiming at a catalyst that is sufficiently stable, selective, and active. Three catalysts have received a great deal of attention those based on rhodium, ruthenium, and palladium. Many excellent reviews,534"537 have appeared and for the discussion of the mechanism and the older literature the reader is referred to those. Here we concentrate on the coordination compounds identified in relation to the catalytic studies.534-539... 

To a solution of 2 g. of rhodium(III) chloride trihydrate in 70 ml. of ethanol is added 12 g. of triphenylphosphine in 250 ml. of hot ethanol. After refluxing until the red solution begins to lighten in color (about 5 minutes), 8 g. of lithium bromide dissolved in 50 ml. of hot ethanol is added and the mixture refluxed for an hour. The orange prisms of the complex are collected by filtration, washed with 50 ml. of anhydrous ether, and dried in vacuum yield 5.1 g. (64% based on rhodium). 

Sautet P, Joachim C (1991) Calculation of the benzene on rhodium STM image. Chem Phys Lett 185 23... 

---