Nucleophilic substitution isotope effects

Secondary isotope effects at the position have been especially thoroughly studied in nucleophilic substitution reactions. When carbocations are involved as intermediates, substantial /9-isotope effects are observed. This is because the hyperconjugative stabliliza-... 

In TFE the secondary isotope effect for solvolysis ( h/ d3)s is found to have the value 1.46 and that for Na,Np-rearrangement (kH/kD3)r has the value 1.42 (Szele and Zollinger, 1981). The two isotope effects are similar to the largest values observed in nucleophilic aliphatic substitutions following the DN + AN mechanism (Shiner,... 

If one limits the consideration to only that limited number of reactions which clearly belong to the category of nucleophilic aromatic substitutions presently under discussion, only a few experimental observations are pertinent. Bunnett and Bernasconi30 and Hart and Bourns40 have studied the deuterium solvent isotope effect and its dependence on hydroxide ion concentration for the reaction of 2,4-dinitrophenyl phenyl ether with piperidine in dioxan-water. In both studies it was found that the solvent isotope effect decreased with increasing concentration of hydroxide ion, and Hart and Bourns were able to estimate that fc 1/ for conversion of intermediate to product was approximately 1.8. Also, Pietra and Vitali41 have reported that in the reaction of piperidine with cyclohexyl 2,4-dinitrophenyl ether in benzene, the reaction becomes 1.5 times slower on substitution of the N-deuteriated amine at the highest amine concentration studied. 

Saunders10 and by Sims and coworkers11 have shown that the magnitude of the leaving-group heavy-atom isotope effect varies linearly with the extent of C—X bond rupture in the transition state for concerted elimination reactions and for nucleophilic substitution reactions, respectively. Since the magnitude of the isotope effect is directly related to the amount of C—X bond rupture in the transition state, these isotope effects provide detailed information about the structure of the transition state. 

TABLE 10. The secondary alpha deuterium and secondary incoming nucleophile deuterium kinetic isotope effects found for the S 2 reactions between para-substituted anilines and benzylamines with benzyl, methyl and ethyl para-substituted benzensulfonates in ace- ... 

The nucleophile in the S.v2 reactions between benzyldimethylphenylammonium nitrate and sodium para-substituted thiophenoxides in methanol at 20 °C (equation 42) can exist as a free thiophenoxide ion or as a solvent-separated ion-pair complex (equation 43)62,63. The secondary alpha deuterium and primary leaving group nitrogen kinetic isotope effects for these Sjv2 reactions were determined to learn how a substituent on the nucleophile affects the structure of the S.v2 transition state for the free ion and ion-pair reactions64. 

This reaction proceeds via the transition state illustrated in Fig. 10.2. An Sn2 reaction (second order nucleophilic substitution) in the rate limiting step involves the attack of the nucleophilic reagent on the rear of the (usually carbon) atom to which the leaving group is attached. The rate is thus proportional to both the concentration of nucleophile and substrate and is therefore second order. On the other hand, in an SnI reaction the rate limiting step ordinarily involves the first order formation of an active intermediate (a carbonium ion or partial carbonium ion, for example,) followed by a much more rapid conversion to product. A sampling of a and 3 2° deuterium isotope effects on some SnI and Sn2 solvolysis reactions (i.e. a reaction between the substrate and the solvent medium) is shown in Table 10.2. The... 

An S Ar (nucleophilic substitution at aromatic carbon atom) mechanism has been proposed for these reactions. Both nonenzymatic and enzymatic reactions that proceed via this mechanism typically exhibit inverse solvent kinetic isotope effects. This observation is in agreement with the example above since the thiolate form of glutathione plays the role of the nucleophile role in dehalogenation reactions. Thus values of solvent kinetic isotope effects obtained for the C13S mutant, which catalyzes only the initial steps of these reactions, do not agree with this mechanism. Rather, the observed normal solvent isotope effect supports a mechanism in which step(s) that have either no solvent kinetic isotope effect at all, or an inverse effect, and which occur after the elimination step, are kinetically significant and diminish the observed solvent kinetic isotope effect. 

A kinetic smdy of the acylation of ethylenediamine with benzoyl chloride (110) in water-dioxane mixtures at pH 5-7 showed that the reaction involves mainly benzoylation of the monoprotonated form of ethylenediamine. Stopped-flow FT-IR spectroscopy has been used to study the amine-catalysed reactions of benzoyl chloride (110) with either butanol or phenol in dichloromethane at 0 °C. A large isotope effect was observed for butanol versus butanol-O-d, which is consistent with a general-base-catalysed mechanism. An overall reaction order of three and a negligible isotope effect for phenol versus phenol- /6 were observed and are consistent with either a base- or nucleophilic-catalysed mechanism. Mechanistic studies of the aminolysis of substituted phenylacetyl chlorides (111) in acetonitrile at —15 °C have revealed that reactions with anilines point to an associative iSN2 pathway. ... 

In a second-order (SN2)nucleophilic substitution reaction, the carbon atom simultaneously experiences the effects of the attacking nucleophile (N) and leaving group or exiphile (E). These mutual effects (shown in Fig. 3) serve to diminish energy diferences between each isotopic substrate and its corresponding transition state. 

A reaction described as Sn2, abbreviation for substitution, nucleophilic (bimolecular), is a one-step process, and no intermediate is formed. This reaction involves the so-called backside attack of a nucleophile Y on an electrophilic center RX, such that the reaction center the carbon or other atom attacked by the nucleophile) undergoes inversion of stereochemical configuration. In the transition-state nucleophile and exiphile (leaving group) reside at the reaction center. Aside from stereochemical issues, other evidence can be used to identify Sn2 reactions. First, because both nucleophile and substrate are involved in the rate-determining step, the reaction is second order overall rate = k[RX][Y]. Moreover, one can use kinetic isotope effects to distinguish SnI and Sn2 cases (See Kinetic Isotope Effects). 

---