Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

NO determination

NaOH when the end point s pH falls between 6 and 10, but no determinate error is observed when the end point s pH is less than 6. [Pg.362]

The concentration of NO determines the relative importance of reaction 3, and the formation of NO2 is particularly significant since this is readily photolyzed to produce 0( P) that reacts with oxygen to produce ozone. This alkane-NO reaction may produce O3 at the troposphere-stratosphere interface ... [Pg.16]

The first interest in the electroreduction of N02 or NO catalyzed by metal complexes is to model the activity of nitrite reductase enzymes.327 There is also an extensive growth in studies related to the development of metal complex-based electrochemical sensors for NO determination in biological and environmental samples 328 329 Nitrate disproportionates to nitric oxide and nitrate in aqueous solution. [Pg.491]

In the biomedical literature (e.g. solute = enzyme, drug, etc.), values of kf and kr are often estimated from kinetic experiments that do not distinguish between diffusive transport in the external medium and chemical reaction effects. In that case, reaction kinetics are generally assumed to be rate-limiting with respect to mass transport. This assumption is typically confirmed by comparing the adsorption transient to maximum rates of diffusive flux to the cell surface. Values of kf and kr are then determined from the start of short-term experiments with either no (determination of kf) or a finite concentration (determination of kT) of initial surface bound solute [189]. If the rate constant for the reaction at the cell surface is near or equal to (cf. equation (16)), then... [Pg.475]

No determination was made as to whether differences between C0/AI2O3 and C0/K-AI2O3 were due to the presence of K, the higher support calcination temperature, or the lower surface area of K-AI2O3. It should be noted that although the total amount of bulk cobalt reducible in H2 at 480°C had increased in... [Pg.56]

Within the field of Lewis adducts, we naturally studied the conformational analysis of the parent borazane complex, H3N BH3, and of its fluorinated derivatives (13) and showed that, with respect to their preferred conformation, there is no determinant AEN-.iH spatial term analogous to the AEP...H term discussed above relative to F3P BH3. [Pg.7]

Table 8 gives expressions for the rate coefficients of secondary reactions in the thermal decompositions of N20, where these have been measured. To our knowledge no determination has been made of ks. [Pg.69]

It is natural that the participation of N02 and NO+ in the one-electron oxidation puts forward the target of NO2 and NO determination. The direct determination of these gaseous products presents some problems. IR spectroscopy is a method (see, e.g., Todres et al. 1988), but this method is not always convenient or even available. The direct determination of NO2 and NO by ESR spectroscopy is not possible owing to the short relaxation time, which gives rise to broad absorption lines. Spin trapping of NO combined with ESR is recommended for this purpose (Norby et al. 1997). As an effective spin trap for NO2, poly(2-vinylpyridine) has been recently proposed (Davydov et al. 2006). [Pg.67]

Presence of the His392-T3rr415 (y, yes n, no) covalent bond was determined by MALDI-MS analysis of trypic digest mixtures. Where no indication is given, no determination was made. [Pg.74]

Mixed Flow Reactor-Microfluid. When a microfluid containing reactant A is treated as in Fig. 16.1, the reactant concentration everywhere drops to the low value prevailing in the reactor. No clump of molecules retains its high initial concentration of A. We may characterize this by saying that each molecule loses its identity and has no determinable past history. In other words, by examining its neighbors we cannot tell whether a molecule is a newcomer or an old-timer in the reactor. [Pg.351]

Unlike national (such as British Pharmacopoeia, Indian Pharmacopoeia or US Pharmacopoeia) and regional (such as European Pharmacopoeia) pharmacopoeias, The International Pharmacopoeia has, a priori, no determined legal status, but WHO Member States are free to adopt it and to incorporate it into national legislation, either in part or in whole. The first edition was published in two volumes (1951 and 1955). The latest fourth edition of The International Pharmacopoeia was published in 2006 and an update is to be published in 2008. [Pg.73]

Consider, for example, a colony of ants. It is perfectly clear that the local mles manifest themselves in the interaction of innumerable individual ants. At the same time, it is equally clear that the whole anthill, on a global level, has an identity of its own. . . We can now ask ourselves where this insect colony is located. Where is it If you stick your hand into the anthill, you will only be able to grasp a number of ants, i.e., the incorporation of local rules. Furthermore, you will realize that a central control unit cannot be localised anywhere because it does not have an independent identity but a relational one. The ants exist as such but their mutual relations produce an emergent entity that is quite real and amenable to direct experience. This mode of existence was unknown before on the one hand, we perceive a compact identity, on the other, we recognize that it has no determinable substance, no localisable core. [Pg.124]

Progress Rept No 10, Oct-Dec 1955. A new contemplated modification of apparatus for detn of temp of deton, using the 21-foot grating spectrograph, was briefly described and its diagram is given. As the apparatus was not yet constructed, no determinations were made... [Pg.596]

Figure 53 shows relative rates of C02 formation under steady-state conditions that were recorded with various single-crystal surfaces of Pd as well as with a polycrystalline Pd wire (173). It must be noted that with these experiments no determination of the effective surface areas was performed so that no absolute turnover numbers per cm2 are obtained. Instead, the reaction rates were normalized to their respective maximum values. As can be seen from Fig. 53, all data points are close to a common line which indicates that, in fact, with this reaction the activity is influenced very little by the surface structure. As has been outlined in Section II, the adsorption of CO exhibits essentially quite similar behavior on single-crystal planes with varying orientation. Since the adsorption-desorption equilibrium of CO forms an important step in the overall kinetics of steady-state C02 formation, this effect forms at least a qualitative basis on which the structural insensitivity may be made plausible. [Pg.66]

We see continually that heat and dryness give form to everything. A potter would never succeed in making a vase, if dryness does not give to the clay a certain degree of adhesion and solidity. If the earth is too moist, too soft, it is a mud, which has no determined form. [Pg.43]

There have recently been several measurements of the rate coefficient for the reaction of HS with NO2 (25 and references therein). Our value for CH3S + N02 is very close to the rate coefficient for HS + NO determined by Wang et al. (25). [Pg.456]

Sokolowski interprets the referent of Aristotle s remarks in the Metaphysics passage as a kind of matter that has no determinate dimensions but is capable of being made determinate through form. [Pg.100]

The first description of a differential mobility spectrometer is shown in Fig. 9 with a schematic from the 1993 article by Buryakov et al. [8-10], Subsequently, the technology from this team was migrated to the USA [39] and then Canada [40] as field asymmetric ion mobility spectrometry (FAIMS) with a cylindrical design for the analyzer. The FAIMS analyzer was attached to a mass spectrometer [41], and a line of study on large instrumentation was begun where the FAIMS was an ion filter for the mass spectrometer in environmental and biological studies [42 14], Refinements were made and a commercial inlet for mass spectrometers was introduced [45], but no determinations with... [Pg.72]

The most extensive work on the subject so far has been carried out by Brink and Shrieve [44]. The highest yield of 2-methyl-1-nitronaphthalene they obtained was 57% of the theoretical. This was produced by nitrating 2-methylnaphthalene at low temperatures (0-30°C) with a 70% excess of 70% nitric acid The other isomers appeared as a by-product oil. When using a 15% excess of a nitrating mixture composed of 25% HNOs, 55% H2S04 and 20% H20 the yield of 1-nitro-2-methylnaphthalene was also 57%. Dinitration took place when acetic anhydride was used. The product was in the form of a solid with m. p. 209-213°C. No determination of the structure of the dinitroproducts was carried out. [Pg.447]

Conditions selected so that the copolymer contained about the same amount of cellulose, 77-82% AN = acrylonitrile DMF = N,N-dimethylformamide. b Initial molecular weight of cellulose 7.1 X 105 for ionizing radiation molecular weight of cellulose was determined at dosage indicated no determination was made on possible oxidative depolymerization of cellulose by chemical redox systems. c Based on poly (acrylonitrile) recovered from acid hydrolysis of copolymer and on intrinsic viscosity method. [Pg.602]

Beginning in 1937, both Kamen and Kurie became associated with E. O. Lawrence s newly organized radiation laboratory. At that time, recoil tracks were used to calibrate cloud chamber experiments, but little was known about the isotope s physical characteristics. It was assumed that it was radioactive with a half-life of a few hours or, at most, a few days based on an analogy with the 0.8-sec half-life of He (J2). In view of its assumed short half-life, no determined eflFort to isolate it was undertaken immediately since the Lawrence laboratory between 1937 and... [Pg.35]

Due to the low thickness of this sample, approximately 25pm, no determination of a lag time was possible. Testing using mass spectrometer generally indicated hydrogen at near saturation levels within the first sampling frequency, which is limited to about 15 seconds for the instrumentation used. The data were analyzed using the standard data reduction method and the permeability of this alloy is indicated in Table 3. [Pg.295]


See other pages where NO determination is mentioned: [Pg.53]    [Pg.25]    [Pg.86]    [Pg.67]    [Pg.628]    [Pg.303]    [Pg.492]    [Pg.57]    [Pg.6]    [Pg.24]    [Pg.12]    [Pg.164]    [Pg.156]    [Pg.74]    [Pg.76]    [Pg.38]    [Pg.516]    [Pg.4]    [Pg.197]    [Pg.66]    [Pg.254]    [Pg.56]    [Pg.549]    [Pg.158]    [Pg.330]    [Pg.244]    [Pg.26]    [Pg.566]   
See also in sourсe #XX -- [ Pg.239 , Pg.240 ]




SEARCH



Electrodes fabrication, for NO determination dark type

Electrodes fabrication, for NO determination integrated microelectrodes

Electrodes fabrication, for NO determination modified carbon fiber

© 2024 chempedia.info