Naphthalene derivatives, conversion

Fourth, kinetic data of the sulfur extrusion reaction of thiepin will provide direct evidence for the transition state of the process. Data on the conversion of the thiepin 34 into its corresponding naphthalene derivative are available 2SK The substantially large negative activation entropy (AS si —24 cal mol-1 deg-1) points to the existence of a highly ordered transition state, namely a thianorcaradiene, in the reaction. 3,4-Bis(methoxycarbonyl)-5-hydroxybenzo[/>]thiepin 33 thermally... 

Another possibility to increase the diastereoselectivity in an asymmetric synthesis can arise from different thermodynamic stabilities of the diasteieoisomeric products. If the thermodynamic stabilities of these are different enough, then, under conditions of equilibrium, a complete conversion of the less stable into the more stable can be achieved. For example, the diastereoselective hydrogenation of naphthalene derivates over Pd/C catalyst leads to a mixture of dihydronaphtalenes in which the cA-isomer predominates. The conversion of this isomer into the tram occurs by changing the properties of the reaction medium, namely by equilibration with a base. For such a purpose, NaOMe in IHF can be used [263], Generally, such an increase in stability in the six-membered rings can result from a rearrangement of the substituents from an axial to an equatorial position. 

Solid benzylic halogens are easily substituted with gaseous dialkylamines. Monoalkylamines are less suitable for uniform reactions due to secondary substitution of the initial product by the benzylic halide present. Some characteristic 100% yield conversions are listed in Scheme 31. The benzene (230) and naphthalene derivatives (231) started from the solid bromides, the anthracene derivatives (232) from the solid chlorides [22]. 

A specific feature of these conversions of dimers 276 (R3 = H) is produced by the formyl group. Thus, treatment of 281 with a mixture of aqueous alkaline solution and dioxane at room temperature leads to cyclic semiacetals 284. The precursor compounds towards 284 are the ring-opened intermediates 282, which can be also isolated on treatment of dimer 281 with aqueous sodium acetate [90KGS(ip3)]. Heating of semiacetal 284 (as well as 282 and dimer 281) in concentrated alkaline solutions results in the naphthalene derivative 285, which is obviously formed via ring opening to the hydroxyaldehyde 283, followed by elimination of water. 

In a similar manner, the corresponding (l,3,5-triazin-2-yloxy)naphthalene derivatives 3 rearrange with oxygen to nitrogen migration of the 1,3,5-triazinyl group to the peri /V-atom. Subsequent hydrolysis leads to the l-hydroxy-8-(l,3,5-triazin-2-ylamino)naphthalene-3,6-disulfonic acid derivative 5. These conversions are conducted at room temperature at pH 10.5— 11.0 for 6— 16 h, finally the pH is lowered to 5-6.7... 

The formation of the benzyl radical by photolysis of toluene in benzene at 4.2 and 77 K has been investigated as a function of light intensity and shown to be unimolecular and biphotonic, and to occur via the lowest excited triplet state. The gas-phase photodissociation of [2,2]paracyclophane (71) into two molecules of /7-quinodimethane and analogous dissociations of two methyl-substituted derivatives have been shown to be efficient two-photon processes.A hot molecule formed by internal conversion from the initially formed singlet electronic excited state is proposed as an intermediate, a mechanism which is completely different from that of the two-photon dissociation of (71) in low-temperature matrices, which involves a triplet state. The photolyses of [2,2]para-cylcophane and [2,2]paracyclophane-l-ene have also been studied in THF and hexane matrices at 77 K, using detection by both luminescence and absorption spectroscopy. The products from both these compounds in THF matrices included alkyl derivatives of rra/15-stilbene, and in hexane matrices alkylphenan-threnes. Cycloreversion of so-called cyclodimers of naphthalene derivatives with benzene or furan, e.g. (72), occurs efficiently upon UV irradiation. ... 

Bender and his coworkers " have examined the influence of the position of a cyano substituent on the outcome of the reactions of the naphthalene derivatives 237, 238 and 239. Typical of the reactions is the direct irradiation (A > 290 nm) of 237, resulting in its conversion into the three products shown in Scheme 16. The semibullvalene 240 is also photochemically reactive and is converted into the cyclo-octatetraene in 75% yield on fur-... 

Georges Darzens (at the Ecole Polytechnique in Paris, France) in 1926 described the conversion of 2-benzylpent-4-enoic acid 3 into 4-methyl-tetrahydronaphthalene-2-carboxylic acid 4 that has proceeded under the influence of concentrated sulfuric acid. Subsequent dehydrogenation and decarboxylation yielded a naphthalene derivative. This work was followed by a series of extended reports. The outcome of Darzens et al. (Levy, Heinz) sequence of works in this area has been reviewed. ... 

Finally, the replacement of the coumarine scaffold by naphthalene derivatives was envisaged, and conversions of 15% to 45% were obtained for the methylation of some naphthalenediols, opening new perspectives for this green and selective Friedel-Craft alkylation. 

An important reaction in the chemistry of naphthalenes is the Bucherer reaction,i.e. the conversion of naphthols 1 to naphthylamines 2 as well as the reverse reaction. The reaction is carried out in aqueous medium in the presence of catalytic amounts of a sulfite or bisulfite. Apart from very few exceptions it does not apply to benzene derivatives, which limits the scope of that reaction. 

The high-spin/low-spin interconverison in a Ni11 complex of the cyclam derivative (639) bearing a luminescent naphthalene substituent has been used as a fluorescent molecular thermometer.161 The Ni11 tends to quench fluorescence of the proximate naphthalene subunit, but the two spin states exert a different influence on the emission properties. Emission is temperature dependent, since the high spin —> low spin conversion is endothermic, i.e., a temperature increase favors formation of the low-spin form. 

Results showing the effectiveness of the A1- and A2-dialins in coal liquefaction relative to control solvents, naphthalene, Decalin, and fetralin, are presented in Tables 3.1 and 3.2. In both these tables, each row provides the conversion of the coal sample to each of hexane-, benzene-, and pyridine-solubles (plus gases) by the indicated solvent. Table 3.1 contains data derived at a temperature of 400 C and a reaction time of 0.5 hr. Among the control solvents, it can be seen that the naphthalene... 

Use has been made of the C-N cleavage in the conversion of the bicyclic tertiary amines, derived from the 4tc + 2tc cycloaddition of pyrroles and isoindoles with benzynes, into aromatic systems, e.g. naphthalen-l,4-imines and anthracen-9,10-imines yield naphthalenes and anthracenes with the extrusion of the nitrogen bridge [24] in yields which are higher than those obtained by standard oxidation procedures. 

Oxidation of several 1,1-bisphenols 78 with IBD gives spirobenzofuran derivatives of general formula 79 (Eq. 21). This approach, when applied to benzylidine l.l -bisnaphthols 80, leads to a stereospecific cyclization, thereby forming the less hindered naphtho[2,l-fi]furan-2(l//)-spiro-r-(2//)-naphthalene-2 -ones (82) [80JCS(P1)1978,80JCS(P1)1986]. The conversion 80 to 82 probably occurs through intermediate 81 (Scheme 25). 

There is surprisingly little reliable information on the sulfonation of benzo[6]thiophene or its derivatives. Benzo[6]thiophene is more readily sulfonated than naphthalene.699 Reaction with concentrated sulfuric acid at 80° gives a mixture of mono-, di-, and trisulfonic acids, reaction with 70% sulfuric acid at 80° gives a monosulfonic acid,699 and reaction with 18% oleum gives a disulfonic acid 86 in each case the orientation of the products is unknown. Treatment of benzo[6]thiophene with concentrated sulfuric acid in acetic anhydride at 20° gives 3-acetylbenzo[6]thiophene (ca. 10%) and a sulfonation product (isolated as the potassium salt), which was believed to be the 3-sulfonic acid.660 Recently, the sulfonation product has been shown to contain the 2- (8%) and 3-isomer (92%), by conversion into the sulfonyl chlorides and reduction to a separable mixture of 2- and 3-mercaptobenzo[6]thiophene.84... 

---