Multi-collector system

For the determination of isotope ratios, the precision of TOF-ICP-MS has been studied in a preliminary comparison with other mass spectrometer systems [643]. Typical isotope ratio precisions of 0.05% were obtained, thus overtaking sector field mass spectrometry with sequential detection, for which values of 0.1-0.3% for Cu/ Cu in Antarctic snow samples have been reported [644]. Similar results were obtained by Becker et al. [645] for Mg and Ca in biological samples (0.4-0.5%). In principle, the features of TOF-ICP-MS may be superior to those of sequential sector field or quadrupole mass spectrometry however, true parallel detection of the signals, as is possible with multi-collector systems or array detector mass spectrometry, may be the definitive solution, as shown by Hirata et al. [646]. Here, the use of detectors which allow true parallel measurement of the signals within the relevant mass range, just as the CCDs do for optical atomic spectrometry, may be the ultimate solution and bring about the final breakthrough for ICP-MS isotope ratio measurements as is required in isotope dilution mass spectrometry. 

A fraction collector and a post-column derivatization system were included (Figure 2.1) for a comprehensive and multi-purpose instrument. However, the fraction collector is needed only when collecting components from the effluent, and is generally not included in an analytical system. The post-column derivatization system is connected only when required for the selective and sensitive detection of specially targeted compounds. Usually, most compounds are directly detected by an on-line spectroscopic or other detector. 

Similar to chemical vapor deposition, reactants or precursors for chemical vapor synthesis are volatile metal-organics, carbonyls, hydrides, chlorides, etc. delivered to the hot-wall reactor as a vapor. A typical laboratory reactor consists of a precursor delivery system, a reaction zone, a particle collector, and a pumping system. Modification of the precursor delivery system and the reaction zone allows synthesis of pure oxide, doped oxide, or multi-component nanoparticles. For example, copper nanoparticles can be prepared from copper acetylacetone complexes [70], while europium doped yttiria can be obtained from their organometallic precursors [71]. 

The mechanical system used for this evaluation consisted of several automated components feed control, reactants preparation, synchronized injected reactant pulses, reactor temperature and pressure and residence time control, on-line analytical, fraction collector for product sample collection, as well as programming for multi-system coordination. 

---