MPA

The viscosity is expressed in Pa s. The commonly used unit is mPa-s, formerly called centipoise, cP. 

This relation is applicable to hydrocarbons whose viscosities vary between 0.1 and 10 mPa-s. 

The Mehrotra and ASTM methods apply with acceptable accuracy only for viscosities between 1 and 1000 mPa s. The average error is about 20%. The largest spreads are obtained at low and very high viscosities. 

Mole fraction of hexane Experimental viscosity mPa-s Calculated viscosity method 1 mPa-s Calculated viscosity method 2 mPa-s Calculated viscosity method 3 mPa-s Molecular weight kg/kmol Density kg/m ... 

At nominal body forces the same compressive stress of 100 -110 Mpa was calculated in all directions in the middle of the head of the examined bolts... 

Fig.7 Emission activity time trend (structural steel - loading 4000 MPa)...

Fig.8 Total number of AE signal counts dependence on time for grey cast iron(GCI) (a) and GCl with nitrided surface (b) (2500 MPa)...

Fig.9 Distribution of emission counts number in individual levels (structural steel) a) higher contact load (4000 MPa) b) lower contact load (2500 MPa).

N Diagnostic method Breaking point , MPa Defect identifying parameters ... 

Fig. 3 shows results of Wirotest 202 A indications as a function of compressive stress for cylindrical samples d> 18 mm made of steel LH 15, what is turn indieates that the dependence of indications on compressive stress is linear in the range up to 180 MPa with regard of quenched (1) and up 120 MPa with regard to annealed (2) samples. 

Whereas in the scope of plastic deformations differences are observed Arc welding of pipes <6 32 mm, wall thickness 6,5 mm has caused own tensile stress of 260 MPa in the jont, relief at 720°C during 4 hours, has caused a lowering of stress to 60 MPa. 

The changing of welding method to the vibro-contact has caused a lowering of own tensile stress to 180 MPa, whereas in the joint the stress is close to zero After annealing the maximum value of stress has reached 20 MPa... 

SP<249 Implementation of power plant component life assessment Dr. A. Jovanovic MPA Stuttgail... 

Application of 150 MPa pressure increases the interfacial tension for w-hex-ane-water from 50.5 to 53.0 mN/m at 25°C. Calculate AV. What is AV for that area corresponding to a molecular size (take a representative molecular area to be 20 A ) Convert this to cm /cm mol. 

The heat capacity of a gas at constant pressure is nonually detenuined in a flow calorimeter. The temperature rise is detenuined for a known power supplied to a gas flowing at a known rate. For gases at pressures greater than about 5 MPa Magee et al [13] have recently described a twin-bomb adiabatic calorimeter to measure Cy. 

---