Molecular oxygenate formation

The alkali chlorates melt before decomposition [844], The catalytic properties of Co304 in promoting [865] the solid phase decomposition of NaC103 are attributed to the ability of the oxide to donate an electron to an oxygen atom, temporarily accepted at its surface from a CIO ion, prior to molecular oxygen formation and desorption. The progressive increase in E during reaction (from 120 to 200 kJ mole-1) is associated with systematic deactivation of the surface. 

The matrix photochemistry of 2v proved to be fairly complicated.108 The primary product of the photolysis of 2v is carbene lv, which was identified by ESR spectroscopy. Under the conditions of matrix isolation the carbene showed the expected reactivity towards molecular oxygen (formation of carbonyl oxide 7v) and carbon monoxide (formation of ketene lOv) (Scheme 22). In contrast to the oxocyclohexadienylidenes (la and derivatives) carbene lv slowly reacted with CO2 to give an a-lactone with the characteristic C=0 stretching vibration at 1896 cm-1. The latter reaction indicates that lv is — as expected — more nucleophilic than la. 

Molecular oxygen formation is probably negligible at all but the highest LET and HO2 can be normally ignored with fast electrons and y-rays. 

Thus, N20 synthesis from N2 requires the presence of sufficient amounts of HO free radical in the system. However, this amount can be significantly decreased by quadratic chain termination (HO radical recombination), which leads to molecular oxygen formation. It is common knowledge that molecular oxygen interacts with nitrogen only at... 

Redmond, R.W. and Braslavsky, S.E. (1988) Time-resolved thermal lensing and phosphorescence studies on photosensitized molecular oxygen formation. Influence of the electronic configuration of the sensitizer on sensitization efficiency, Chem. Phys. Lett., 148, 523-529. 

Gauthier, M., and D. R. Snelling (1971). Mechanism of singlet molecular oxygen formation from photolysis of ozone at 2537 A. J. Chem. Phys. 54, 4317-4325. 

In contrast to oxidation in water, it has been found that 1-alkenes are directly oxidized with molecular oxygen in anhydrous, aprotic solvents, when a catalyst system of PdCl2(MeCN)2 and CuCl is used together with HMPA. In the absence of HMPA, no reaction takes place(100]. In the oxidation of 1-decene, the Oj uptake correlates with the amount of 2-decanone formed, and up to 0.5 mol of O2 is consumed for the production of 1 mol of the ketone. This result shows that both O atoms of molecular oxygen are incorporated into the product, and a bimetallic Pd(II) hydroperoxide coupled with a Cu salt is involved in oxidation of this type, and that the well known redox catalysis of PdXi and CuX is not always operalive[10 ]. The oxidation under anhydrous conditions is unique in terms of the regioselective formation of aldehyde 59 from X-allyl-A -methylbenzamide (58), whereas the use of aqueous DME results in the predominant formation of the methyl ketone 60. Similar results are obtained with allylic acetates and allylic carbonates[102]. The complete reversal of the regioselectivity in PdCli-catalyzed oxidation of alkenes is remarkable. 

Reaction (12-9) shows the photochemical dissodation of NO2. Reaction (12-10) shows the formation of ozone from the combination of O and molecular O2 where M is any third-body molecule (principally N2 and O2 in the atmosphere). Reaction (12-11) shows the oxidation of NO by O3 to form NO2 and molecular oxygen. These three reactions represent a cyclic pathway (Fig. 12-4) driven by photons represented by hv. Throughout the daytime period, the flux of solar radiation changes with the movement of the sun. However, over short time periods (—10 min) the flux may be considered constant, in which case the rate of reaction (12-9) may be expressed as... 

As we have seen, the metabolic energy from oxidation of food materials—sugars, fats, and amino acids—is funneled into formation of reduced coenzymes (NADH) and reduced flavoproteins ([FADHg]). The electron transport chain reoxidizes the coenzymes, and channels the free energy obtained from these reactions into the synthesis of ATP. This reoxidation process involves the removal of both protons and electrons from the coenzymes. Electrons move from NADH and [FADHg] to molecular oxygen, Og, which is the terminal acceptor of electrons in the chain. The reoxidation of NADH,... 

The possibility of a radical mechanism is supported by the observation of the accelerating effect of molecular oxygen on the cyclopropanation. Miyano et al. discovered that the addition of dioxygen accelerated the formation of the zinc carbenoid in the Furukawa procedure [24a, b]. The rate of this process was monitored by changes in the concentration of ethyl iodide, the by-product of reagent formation. Comparison of the reaction rate in the presence of oxygen with that in the... 

There are several available terminal oxidants for the transition metal-catalyzed epoxidation of olefins (Table 6.1). Typical oxidants compatible with most metal-based epoxidation systems are various alkyl hydroperoxides, hypochlorite, or iodo-sylbenzene. A problem associated with these oxidants is their low active oxygen content (Table 6.1), while there are further drawbacks with these oxidants from the point of view of the nature of the waste produced. Thus, from an environmental and economical perspective, molecular oxygen should be the preferred oxidant, because of its high active oxygen content and since no waste (or only water) is formed as a byproduct. One of the major limitations of the use of molecular oxygen as terminal oxidant for the formation of epoxides, however, is the poor product selectivity obtained in these processes [6]. Aerobic oxidations are often difficult to control and can sometimes result in combustion or in substrate overoxidation. In... 

One of the earliest examples of this methodology involves the reaction of a polymeric anion (formed by living anionic polymerization) with molecular oxygen to form a polymeric hydroperoxide which can be decomposed either thermally or, preferably, in a redox reaction to initiate block polymer formation with a second monomer (Scheme 7.25). However, the usual complications associated with initiation by hydroperoxides apply (Section 3.3.2.5). 

The recombination of fragments stemming from one macromolecule, at times shorter than the diffusion time, prevents the linear increase in RD with the absorbed dose per pulse, as not all main-chain scissions result in the formation of fragments. The effect of molecular oxygen on RD in the case of PBS can be interpreted by formation of peroxyl radicals, e.g. 

---