Micellization free energy

The cleaning process proceeds by one of three primary mechanisms solubilization, emulsification, and roll-up [229]. In solubilization the oily phase partitions into surfactant micelles that desorb from the solid surface and diffuse into the bulk. As mentioned above, there is a body of theoretical work on solubilization [146, 147] and numerous experimental studies by a variety of spectroscopic techniques [143-145,230]. Emulsification involves the formation and removal of an emulsion at the oil-water interface the removal step may involve hydrodynamic as well as surface chemical forces. Emulsion formation is covered in Chapter XIV. In roll-up the surfactant reduces the contact angle of the liquid soil or the surface free energy of a solid particle aiding its detachment and subsequent removal by hydrodynamic forces. Adam and Stevenson s beautiful photographs illustrate roll-up of lanoline on wood fibers [231]. In order to achieve roll-up, one requires the surface free energies for soil detachment illustrated in Fig. XIII-14 to obey... 

Such linear free energy relationships are available for alkyl sulphates and for tire C4 to C9 homologues of tire dialkanoyl lecitliins (see table C2.3.3 for stmcture). Most of tire naturally occurring phospholipids are too insoluble to fonn micelles, but tire lower alkanoyl lecitliins, also known as phosphotidylcholines, do fonn micelles. The ernes for tliese homologues are listed in table C2.3.6. The approximately linear free energy relationship between tire alkyl chain iengtli and log cmc is given by ... 

The ernes of ionic surfactants are usually depressed by tire addition of inert salts. Electrostatic repulsion between headgroups is screened by tire added electrolyte. This screening effectively makes tire surfactants more hydrophobic and tliis increased hydrophobicity induces micellization at lower concentrations. A linear free energy relationship expressing such a salt effect is given by ... 

Resolution at tire atomic level of surfactant packing in micelles is difficult to obtain experimentally. This difficulty is based on tire fundamentally amoriDhous packing tliat is obtained as a result of tire surfactants being driven into a spheroidal assembly in order to minimize surface or interfacial free energy. It is also based upon tire dynamical nature of micelles and tire fact tliat tliey have relatively short lifetimes, often of tire order of microseconds to milliseconds, and tliat individual surfactant monomers are coming and going at relatively rapid rates. 

The solubilization of diverse solutes in micelles is most often examined in tenns of partitioning equilibria, where an equilibrium constant K defines the ratio of the mole fraction of solute in the micelle (X and the mole fraction of solute in the aqueous pseudophase. This ratio serves to define the free energy of solubilization -RT In K). 

Mesoscale simulations model a material as a collection of units, called beads. Each bead might represent a substructure, molecule, monomer, micelle, micro-crystalline domain, solid particle, or an arbitrary region of a fluid. Multiple beads might be connected, typically by a harmonic potential, in order to model a polymer. A simulation is then conducted in which there is an interaction potential between beads and sometimes dynamical equations of motion. This is very hard to do with extremely large molecular dynamics calculations because they would have to be very accurate to correctly reflect the small free energy differences between microstates. There are algorithms for determining an appropriate bead size from molecular dynamics and Monte Carlo simulations. 

Larger aggregates seldom have spherical geometry, but tend to form cylindrical micelles. In this case, the diameter of the cylinders can usually be adjusted such that the head groups can cover their optimal head group area Uq, and the interaction free energy per surfactant reduces to the constant The size distribution for cylindrical micelles is then exponential in the limit of large N,... 

AB diblock copolymers in the presence of a selective surface can form an adsorbed layer, which is a planar form of aggregation or self-assembly. This is very useful in the manipulation of the surface properties of solid surfaces, especially those that are employed in liquid media. Several situations have been studied both theoretically and experimentally, among them the case of a selective surface but a nonselective solvent [75] which results in swelling of both the anchor and the buoy layers. However, we concentrate on the situation most closely related to the micelle conditions just discussed, namely, adsorption from a selective solvent. Our theoretical discussion is adapted and abbreviated from that of Marques et al. [76], who considered many features not discussed here. They began their analysis from the grand canonical free energy of a block copolymer layer in equilibrium with a reservoir containing soluble block copolymer at chemical potential peK. They also considered the possible effects of micellization in solution on the adsorption process [61]. We assume in this presentation that the anchor layer is in a solvent-free, melt state above Tg. The anchor layer is assumed to be thin and smooth, with a sharp interface between it and the solvent swollen buoy layer. 

The potential of reversed micelles needs to be evaluated by theoretical analysis of the metal ion distribution within micelles, by evaluation of the free energy of the solvated ions in the reversed micelle organic solution and the bulk aqueous water, and by the experimental characterization of reversed micelles by small-angle neutron and x-ray scattering. 

Usually the discussion of the ODT of highly asymmetric block copolymers in the strong segregation limit starts from a body-centred cubic (bcc) array of the minority phase. Phase transitions were calculated using SOFT accounting for both the translational entropy of the micelles in a disordered micelle regime and the intermicelle free energy [129]. Results indicate that the ODT occurs between ordered bcc spheres and disordered micelles. 

Most studies of micellar systems have been carried out on synthetic surfactants where the polar or ionic head group may be cationic, e.g. an ammonium or pyridinium ion, anionic, e.g. a carboxylate, sulfate or sulfonate ion, non-ionic, e.g. hydroxy-compound, or zwitterionic, e.g. an amine oxide or a carboxylate or sulfonate betaine. Surfactants are often given trivial or trade names, and abbreviations based on either trivial or systematic names are freely used (Fendler and Fendler, 1975). Many commercial surfactants are mixtures so that purity can be a major problem. In addition, some surfactants, e.g. monoalkyl sulfates, decompose slowly in aqueous solution. Some examples of surfactants are given in Table 1, together with values of the critical micelle concentration, cmc. This is the surfactant concentration at the onset of micellization (Mukerjee and Mysels, 1970) and can therefore be taken to be the maximum concentration of monomeric surfactant in a solution (Menger and Portnoy, 1967). Its value is related to the change of free energy on micellization (Fendler and Fendler, 1975 Lindman and Wennerstrom, 1980). 

The cmc is a key property, because it is related to the free energy difference between monomer and micelles. The onset of micellization is detected by marked changes in such properties as surface tension, refractive index and... 

It is easy to understand the lower reactivity of non-ionic nucleophiles in micelles as compared with water. Micelles have a lower polarity than water and reactions of non-ionic nucleophiles are typically inhibited by solvents of low polarity. Thus, micelles behave as a submicroscopic solvent which has less ability than water, or a polar organic solvent, to interact with a polar transition state. Micellar medium effects on reaction rate, like kinetic solvent effects, depend on differences in free energy between initial and transition states, and a favorable distribution of reactants from water into a micellar pseudophase means that reactants have a lower free energy in micelles than in water. This factor, of itself, will inhibit reaction, but it may be offset by favorable interactions with the transition state and, for bimolecular reactions, by the concentration of reactants into the small volume of the micellar pseudophase. 

The degree of stereoselectivity is usually not large in these reactions and appears to be due to transition-state rather than initial-state interactions. In other words the diastereomeric transition states derived from the enantiomeric substrates have different free energies in the micelle. To this extent the situation is essentially no different to the stereoselectivity which is often observed in non-micellar reactions involving reactions of enantiomeric substrates with a chiral reagent. In some cases it is possible to identify the noncovalent interactions which are responsible for the stereoselectivity (Brown et al., 1981). 

In a recent study, Jin and Kaplan (2003) demonstrate the formation of silk fibroin aggregates in the presence of polyethylene glycol, and present a step by step model for fiber formation based on the principle of micelle formation, and driven by dehydration as well as flow elongation. During this process, hydrophobic chains are exposed to the solvent, but because of the molecules high free energy, water solvation is unfavorable and phase separation followed by aggregation predominates. 

Free energy of micellization, 24 130 Free enzyme-catalyzed reactions ionic liquids in, 26 897-898 Free fatty acids, 70 802-804, 825-826 removal of, 70 807 as soap bar additives, 22 742-743 Free-flow agents, in sodium chloride (salt), 22 808... 

Semianalytical mean-field theories of block copolymer micellization were formulated by Noolandi et al. [ 197] and by Leibler et al. [198]. In the approach of Noolandi et al., the micellar characteristics were obtained through a minimization of the Gibbs free energy for an isolated micelle. This was applied to PS-PB micelles, and the obtained theoretical values were in good agreement with the experimental ones. 

---