Methane characteristics

CH2 CH-0-CH CH2 Colourless inflammable liquid, with a characteristic ethereal odour, b.p. 28-31°C. Prepared by the action of KOH on 2,2 -dichiorodiethyl ether. It is unstable, breaking down to methanal and methanoic acid. 

In general, each nomial mode in a molecule has its own frequency, which is detemiined in the nonnal mode analysis [24]- Flowever, this is subject to the constraints imposed by molecular synmietry [18, 25, 26]. For example, in the methane molecule CFI, four of the nonnal modes can essentially be designated as nonnal stretch modes, i.e. consisting primarily of collective motions built from the four C-FI bond displacements. The molecule has tetrahedral synmietry, and this constrains the stretch nonnal mode frequencies. One mode is the totally symmetric stretch, with its own characteristic frequency. The other tliree stretch nonnal modes are all constrained by synmietry to have the same frequency, and are refened to as being triply-degenerate. 

There is no satisfactory chemical way of distinguishing betn een ethane and methane, both of which burn with an almost non-luminous flame this fact however is quite unimportant at this stage of the investigation. Hydrogen also burns with a non-luminous flame and w hen the open end of a test-tube full of the gas is placed in a Bunsen flame, a mild explosion with a very characteristic report takes place. 

Docusate Calcium. Dioctyl calcium sulfosuccinate [128-49-4] (calcium salt of l,4-bis(2-ethylhexyl)ester butanedioic acid) (11) is a white amorphous soHd having the characteristic odor of octyl alcohol. It is very slightly soluble in water, and very soluble in alcohol, polyethylene glycol 400, and com oil. It may be prepared directly from dioctyl sodium sulfo succinate dissolved in 2-propanol, by reaction with a methan olic solution of calcium chloride. 

The reported characteristics of methane oxidation at high pressures are interesting. As expected,the reaction can be conducted at lower temperatures eg, 262°C at 334 MPa (3300 atm) (100). However, the cool flame phenomenon is observed even under these conditions. At high pressures. 

Ethane. Ethane VPO occurs at lower temperatures than methane oxidation but requires higher temperatures than the higher hydrocarbons (121). This is a transition case with mixed characteristics. Low temperature VPO, cool flames, oscillations, and a NTC region do occur. At low temperatures and pressures, the main products are formaldehyde, acetaldehyde (HCHOiCH CHO ca 5) (121—123), and carbon monoxide. These products arise mainly through ethylperoxy and ethoxy radicals (see eqs. 2 and 12—16 and Fig. 1). 

Characteristics of moving-bed gasifiers are low gasification temperatures, relatively low oxygen requirements, relatively high methane content in... 

The characteristic magnitudes of detonation cells for various fuel-air mixtures (Table 3.2) show that these restrictive boundary conditions for detonation play only a minor role in full-scale vapor cloud explosion incidents. Only pure methane-air may be an exception in this regard, because its characteristic cell size is so large (approximately 0.3 m) that the restrictive conditions, summarized above, may become significant. In practice, however, methane is often mixed with higher hydrocarbons which substantially augment the reactivity of the mixture and reduce its characteristic-cell size. 

These two research areas share the common characteristic of involving inorganic solids in the combustion process. Catalytic combustion research focuses on using the solid to facilitate the oxidation of well-known fuels such as hydrogen and methane. Materials synthesis research focuses on using combustion as a means to react the solids either with each other or a gas, such as nitrogen (which in this case acts as an oxidizer), to make new solid materials. 

The oxidation of nitric oxide, NO, is a reaction involved in smog production. It is moderately rapid at normal temperatures. The oxidation of methane, CHt (household gas), however, occurs so slowly at room temperature that we may say that, for all practical purposes it doesn t react at all. Again, the difference in the reaction rates must depend upon specific characteristics of the reactants, NO and CH,. 

With formulae (3.58), (3.59) and (3.66) Q-branch contours are calculated for CARS spectra of spherical rotators at various pressures and for various magnitudes of parameter y (Fig. 3.14). For comparison with experimental data, obtained in [162], the characteristic parameters of the spectra were extracted from these contours half-widths and shifts of the maximum subject to the density. They are plotted in Fig. 3.15 and Fig. 3.16. The corresponding experimental dependences for methane were plotted by one-parameter fitting. As a result, the cross-section for rotational energy relaxation oe is found ... 

The extent to which anode polarization affects the catalytic properties of the Ni surface for the methane-steam reforming reaction via NEMCA is of considerable practical interest. In a recent investigation62 a 70 wt% Ni-YSZ cermet was used at temperatures 800° to 900°C with low steam to methane ratios, i.e., 0.2 to 0.35. At 900°C the anode characteristics were i<>=0.2 mA/cm2, Oa=2 and ac=1.5. Under these conditions spontaneously generated currents were of the order of 60 mA/cm2 and catalyst overpotentials were as high as 250 mV. It was found that the rate of CH4 consumption due to the reforming reaction increases with increasing catalyst potential, i.e., the reaction exhibits overall electrophobic NEMCA behaviour with a 0.13. Measured A and p values were of the order of 12 and 2 respectively.62 These results show that NEMCA can play an important role in anode performance even when the anode-solid electrolyte interface is non-polarizable (high Io values) as is the case in fuel cell applications. 

---