Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Memory capability

Downhole Recording. When the logging measurements are battery powered the logging parameters can be recorded versus time while tripping the drill string. If the depth is simultaneously recorded versus time, the data can be plotted versus depth. Common memory capabilities are of the order of 2 to 10 megabytes. The recording rate is adjusted to obtain about two data sets per foot. [Pg.999]

Consistently, the agreement with experiment is about 1% for geometric parameters and 5-10% for force constants. On the other hand, binding energies are found to be usually too large by l-2eV per atom. The computational efforts in the LDF approach scale with the third power in the number of orbitals. Consequently, the speed and memory capabilities of supercomputers will allow the study of systems with a hundred atoms and more. [Pg.49]

Faster computers with bigger memory capabilities and smaller size and energy consumption are a must for further technological development. More complicated tasks can be handled with computer speed and memories doubling every 3 years and an increase in computers efficiency being accompanied by the shrinking of their sizes. One of the first electronic computers ENIAC occupied several rooms and weighted 30 tons [51], its counterparts in the seventies were of the size of a wardrobe while todays palmtops are more efficient than mainframes of the 1980-ties. However, this miniaturization process cannot... [Pg.128]

This has the benefit of freeing up conventional memory for use by your programs and is a key concept to memory optimization (which will be discussed later in this chapter). If you don t need expanded memory capability, you can change these lines to turn off EMS but keep the ability to load drivers and TSRs into upper memory blocks (free areas in reserved memory, also called UMBs). To do this, your CONFIG. SYS file must have these lines ... [Pg.130]

A device with an acoustic or visual reminder for the patient and a memory capability so the treating physician will get that patient s actual history of dosing. When a strong routine exists, then this device may be used only sporadically to check if the patient is continuing to dose satisfactorily. [Pg.369]

PDAs are efficient tools that can be used to collect, process, and transmit data that ultimately have an impact on the care delivered to patients, although they do have limitations, such as their memory capabilities, screen size, and overall functionality. In some software applications, a synchronization interface can be written to allow for... [Pg.46]

Both pH and ISE probes have always been small but have, historically, been attached to a pH meter that is often not so small. This has changed with the advent of handheld dataloggers and built-in LCD screens that allow the analyst to carry the pH or ISE probe to the sample, take the measurement and obtain a reading immediately. Calibration standards can be checked just before the measurement. pH and ISE meters that are commercially available range from handheld to pocket-size to devices that have a neckstrap for handsfree operation. Generally, the decrease in size equates to an decrease in accuracy and memory capability. Some meters allow the data to be downloaded on return to a central repository or PC. [Pg.193]

Hazlett BA, Acquistapace P, Gherardi F (2002) Difference in memory capabilities in invasive and native crayfish. J Crustacean Biol 22 439-448... [Pg.368]

Behl, M., Ridder, U., Feng, Y, Kelch, S., and Lendlein, A. 2009. Shap>e memory capability of binary multiblock copolymer blends with hard and switching domains provided by different components. Soft Matter 5 676-684. [Pg.144]

A frilly constrained stress recovery test was conducted for specimens after various environmental attaeks in order to evaluate the effect of environmental conditioning on the memory capability of the SMP based syntactic foam. The same test equipment and test fixture as others used in this chapter were used in the stress recovery teat. The test parameters were as follows healing was performed at an average rate of 0.3 °C/min from room temperature until 79 °C and then the temperature was maintained constant for approximately 20 minutes. The load cell of the Q-TEST 150 machine was used to record the recovered force as a function of time and temperature. [Pg.103]

While shape (strain) memory has been traditionally used as a parameter to characterize shape memory capabilities of shape memory polymers, stress memory is more important for some... [Pg.200]

In general, SMPFs have a good memory of strain or shape, but a poor memory of stress or load. It is expected that, if other properties such as conductivity, color, density, etc., were used to evaluate the memory capability of SMPs, different recovery ratios would be obtained. Therefore, the memory capability depends on the parameter or criterion used. Although the current dominant criterion used to evaluate memory capability is the shape or strain recovery ratio, it is expected that other indicators such as the stress recovery ratio would be more and more used because SMPs will find new applications in various areas. Most importantly, we need to better understand the underlying physics for each parameter because different parameters may not be related linearly or proportionally. It is expected that this opens... [Pg.206]


See other pages where Memory capability is mentioned: [Pg.1475]    [Pg.689]    [Pg.294]    [Pg.39]    [Pg.186]    [Pg.9]    [Pg.15]    [Pg.8]    [Pg.3]    [Pg.393]    [Pg.100]    [Pg.51]    [Pg.127]    [Pg.240]    [Pg.32]    [Pg.203]    [Pg.74]    [Pg.295]    [Pg.57]    [Pg.1475]    [Pg.14]    [Pg.292]    [Pg.112]    [Pg.132]    [Pg.476]    [Pg.52]    [Pg.52]    [Pg.60]    [Pg.61]    [Pg.80]    [Pg.82]    [Pg.104]    [Pg.105]    [Pg.138]    [Pg.163]    [Pg.179]    [Pg.179]   
See also in sourсe #XX -- [ Pg.14 ]




SEARCH



© 2024 chempedia.info