Magnesium methods

Propenylmagnesium Chloride from Mechanically Activated Magnesium (Method B) General Procedure16 ... 

Application of the purified magnesium method to l,3-dibromo-2,2-dimethylpropane affords 15 18% of 1,3-di-Grignard reagent [23], which has been reacted with two molecules of cyclohexanone to afford the expected 1,3-diol [24]. However, the substitution pattern of the 1,3-di-Grignard reagent is limited one /i-alkyl substituent resulted in low yields and high decomposition rates owing to increased / -hydride mobility [25]. 

Martin MT, Shapiro R. Atomic absorption spectrometry of magnesium. Methods Enzymol 1988 158 365-70. 

Baneqee HD, Sen S, Acharya HN, (1982) Investigations on the production of silicon from rice husks by the magnesium method. Mater Sci Eng 52 173-179 Bao Z, Weatherspoon MR, Shian S, Cai Y, Graham PD, Allan SM, Ahmad G, Dickerson MB, Church BC, Kang Z, Abernathy HW III, Summers CJ, Liu M, Sandhage KH (2007) Chemical reduction of three-dimensional silica micro-assemblies into microporous silicon replicas. Nature 446 172-175... 

Other methods for analyzing combustion products can be substituted for chromatography. Gravimetry can be used, for example, after a series of absorption on different beds, as in the case of water absorption in magnesium perchlorate or CO2 in soda lime infra-red spectrometry can be used for the detection of CO2 and water. 

Brunauer and co-workers [129, 130] found values of of 1310, 1180, and 386 ergs/cm for CaO, Ca(OH)2 and tobermorite (a calcium silicate hydrate). Jura and Garland [131] reported a value of 1040 ergs/cm for magnesium oxide. Patterson and coworkers [132] used fractionated sodium chloride particles prepared by a volatilization method to find that the surface contribution to the low-temperature heat capacity varied approximately in proportion to the area determined by gas adsorption. Questions of equilibrium arise in these and adsorption studies on finely divided surfaces as discussed in Section X-3. 

The method of hydrolysis depends on the nature of the product. It is usually sufficient to add dilute sulphuric acid to the ethereal solution and to shake thoroughly, when the magnesium enters the aqueous solution, whilst the organic compound remains in the ether. Alternatively, however, the ethereal solution may be poured on to ice and water, and then treated with dilute sulphuric acid. Should the product be affected by this acid, the hydrolysis can be carried out with an aqueous solution of ammonium chloride. In the following examples the hydrolysis is usually shown as a simple double decomposition... 

Method B. Reflux a mixture of 101 g. of sebacic acid, 196 g. (248 ml.) of absolute ethjd alcohol and 20 ml. of concentrated sulphuric acid for 12 hours. Distil oft about half of the alcohol on a water bath dilute the residue with 500-750 ml. of water, remove the upper layer of crude ester, and extract the aqueous layer with ether. Wash the combined ethereal extract and crude ester with water, then with saturated sodium bicarbonate solution until effervescence ceases, and finally with water. Dry with anhydrous magnesium or sodium sulphate, remove the ether on a water bath, and distil the residue under reduced pressure. B.p. 155-157°/6 mm. Yield llOg. 

Method 1. Arrange the flask containing the reaction mixture for steam distillation as in Fig. II, 40, 1. Proceed with the steam distillation until crystals of p-dibromobenzene appear in the condenser. Change the receiver and continue with the distillation until all the p-dibromobenzeiie has passed over from time to time run out the water from the condenser so that the crystals melt and run down into the receiver. Reject the residue in the flask. Transfer the first distillate to a separatory funnel, wash it with a httle water, and dry the lower layer with a little anhydrous magnesium sulphate or anhydrous calcium chloride filter. Distil slowly from a small distilling flask use a wire gauze or an air bath (Fig. II, 5, 3). Collect the fraction which passes over at 150-170° pour the residue (R), while it is still hot, into a small beaker or porcelain basin for the isolation of p-dibromobenzene. Redistil the fraction of b.p. 150-170° and collect the bromobenzene at 154-157° (3). The yield is 60 g. 

Method 2. Transfer the dark-coloured reaction product to a separatory funnel and shake successively with water, with sufficient 5-10 per cent, sodium hydroxide solution to ensure that the washings are alkaline to litmus, and finally with water. Dry with anhydrous magnesium sulphate or calcium chloride. Filter through a fluted filter paper into a small distilling flask and distil slowly. Collect the crude bromobenzene at 150-170° pour the residue whilst still hot into a small porcelain basin. Redistil the hquid of b.p. 150-170° (3) and collect the bromobenzene at 154-157° the yield is about 60 g. 

I) The steam distillation may be omitted, if desired, by utilising the following method of purihcation. Allow the reaction mixture to cool, decant the aqueous layer and dissolve the residue in about 150 ml. of benzene. Wash the benzene solution with water, I per cent, sodium hydroxide solution, and finally with water dry with anhydrous magnesium sulphate, distil oft the benzene on a water bath, and distil the residue under diminished pressure. 

Method 2. Into a 500 ml. round-bottomed flask place 120 ml. of dry A.R. benzene, and 35 g. (29 ml.) of redistilled benzoyl chloride. Weigh out 30 g. of finely-powdered, anhydrous aluminium chloride into a dry corked test-tube, and add the solid, with frequent shaking, during 10 minutes to the contents of the flask. Fit a reflux condenser to the flask, and heat on a water bath for 3 hours or until hydrogen chloride is no longer evolved. Pour the contents of the flask wliile still warm into a mixture of 200 g. of crushed ice and 100 ml. of concentrated hydrochloric acid. Separate the upper benzene layer (filter first, if necessary), wash it with 50 ml. of 5 per cent, sodium hydroxide solution, then with water, and dry with anhydrous magnesium sulphate. Isolate the benzophenone as in Method 1. The yield is 30 g. 

Method 2. Equip a 1 htre thre necked flask with a double surface reflux condenser, a mechanical stirrer and a separatory funnel, and place 12 -2 g. of dry magnesium turnings, a crystal of iodine, 50 ml. of sodium-dried ether and 7-5 g. (5 ml.) of a-bromonaphthalene (Section IV,20) in the flask. If the reaction does not start immediately, reflux gently on a water bath until it does remove the water bath. Stir the mixture, and add a solution of 96 g. (65 ml.) of a-bromonaphthalene in 250 ml. of anhydrous ether from the separatory funnel at such a rate that the reaction is vmder control (1 -5-2 hours). Place a water bath under the flask and continue the stirring and refluxing for a further 30 minutes. The Grignard reagent collects as a heavy oil in the bottom of the flask ... 

In an alternative method of preparation, benzophenone is used. Prepare the Grignard reagent from 13 -5 g. of magnesium turnings as above, cool in cold water, and add a solution of 91 g. of benzophenone (Section IV,139) in 200 ml. of dry benzene at such a rate that the mixture refluxes gently. Reflux the mixture for 60 minutes, and isolate the triphenylcarbinol in the manner described above. The yield is of the same order. 

Method 1. Reflux a mixture of pure nicotinic acid (Section V,22), 84 g. (105 ml.) of absolute ethanol and 90 g. (50 ml.) of concentrated sulphuric acid in a flask for 4 hours on a steam bath. Cool the solution and pour it slowly and with stirring on to 200 g. of crushed ice. Add sufficient ammonia solution to render the resulting solution strongly alkaline generally, some ester separates as an oil but most of it remains dissolved in the alkaline solution. Extract the solution with five 25 ml. portions of ether, dry the combined ethereal extracts with anhydrous magnesium sulphate, remove the ether and distil under reduced pressure. The ethyl nicotinate passes over at 117-118°/ 6 mm. the yield is 34 g. The b.p. under normal pressure is 222-224°. 

Method 2. Dissolve 20 0 g. of sahcylaldehyde in 30 ml. of rectified spirit, add a solution of 15 g. of hydroxylamine hydrochloride in 10 ml. of water, and render the mixture just alkahne with 10 per cent, sodium carbonate solution whilst coohng in ice. Allow to stand overnight. Acidify with acetic acid, distil off the alcohol under reduced pressiu e (water pump), dilute with twice the volume of water, and extract with two 50 ml. portions of ether. Dry the ethereal extract with anhydrous sodium or magnesium sulphate, distil off most of the ether, and allow the residue to crystaUise. RecrystallLse from chloroform - hght petroleum (b.p. 40-60°). The yield of sahcylaldoxime, m.p. 57°, is 12 g. 

Method 2. Ethyl p-nitrobenzoate. Place 21 g. of p-nitrobenzoic acid (Section IV,154), 11-5 g. of absolute ethyl alcohol, 3 8 g. of concentrated sulphuric acid, and 30 ml. of sodium-dried A.R. benzene in a 250 ml. round-bottomed flask, fit a reflux condenser, and heat the mixture under reflux for 16 hours. Add 50 ml. of ether to the cold reaction mixture, wash the extract successively with sodium bicarbonate soiution and water, dry with anhydrous magnesium sulphate or calcium chloride, and distil off the solvent on a water bath. Remove the last traces of benzene either by heating in an open evaporating dish on a water bath or in a bath at 100-110°. The residual ethyl p-nitrobenzoate (21 g.) solidifies completely on cooling and melts at 56°. 

The metal was a laboratory curiosity until Kroll, in 1946, showed that titanium could be produced commercially by reducing titanium tetrachloride with magnesium. This method is largely used for producing the metal today. The metal can be purified by decomposing the iodide. 

Table 11.1 lists some of the reaction conditions which have given prepara-tively useful yields of 3-alkylation. Entries 1-3 are typical alkylations using a magnesium salt and an alkyl halide. Even 2,3-disubstituted indoles are alkylated at C3 under these conditions (Entry 7). Entry 5 represents a more recently developed method in which an allylic alcohol and indole react in the... 

---